ISO 8600-7:2012

Endoscopes — Medical endoscopes and endotherapy devices — Part 7: Basic requirements for medical endoscopes of water-resistant type

ISO 8600-7:2012 specifies requirements for medical endoscopes, either flexible or rigid with a bending section, of water-resistant type.

Endoscopes — Endoscopes médicaux et dispositifs d'endothérapie — Partie 7: Exigences de base pour les endoscopes médicaux résistants à l'eau

General Information

• Status: Published
• Publication Date: 05-Jul-2012
• ICS: 11.040.55 - Diagnostic equipment
• Technical Committee: ISO/TC 172/SC 5 - Microscopes and endoscopes
• Drafting Committee: ISO/TC 172/SC 5/WG 6 - Endoscopes
• Current Stage: 9093 - International Standard confirmed
• Completion Date: 10-Nov-2023

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 8600-7
First edition
2012-07-15
Endoscopes — Medical endoscopes and
endotherapy devices —
Part 7:
Basic requirements for medical
endoscopes of water-resistant type
Endoscopes — Endoscopes médicaux et dispositifs d’endothérapie —
Partie 7: Exigences de base pour les endoscopes médicaux
résistants à l’eau
Reference number
ISO 8600-7:2012(E)
©
ISO 2012

---------------------- Page: 1 ----------------------
ISO 8600-7:2012(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2012
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO’s
member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [e-mail]
Web www.iso.org
Published in Switzerland
ii © ISO 2012 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 8600-7:2012(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International
Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 8600-7 was prepared by Technical Committee ISO/TC 172, Optics and photonics, Subcommittee SC 5,
Microscopes and endoscopes.
ISO 8600 consists of the following parts, under the general title Endoscopes — Medical endoscopes and
1)
endotherapy devices :
— Part 1: General requirements
— Part 2: Particular requirements for rigid bronchoscopes
— Part 3: Determination of field of view and direction of view of endoscopes with optics
— Part 4: Determination of maximum width of insertion portion
— Part 5: Determination of optical resolution of rigid endoscopes with optics
— Part 6: Vocabulary
— Par
...