ISO 21927-10:2011

Smoke and heat control systems — Part 10: Specification for power output devices

ISO 21927-10:2011 specifies requirements and gives test methods for primary and secondary electrical and pneumatic power output devices, designed for use in smoke and heat control systems in buildings. A summary of functions is given.

Systèmes pour le contrôle des fumées et de la chaleur — Partie 10: Spécifications pour les sources d'alimentation

General Information

• Status: Published
• Publication Date: 12-Jul-2011
• ICS: 13.220.20 - Fire protection
• Technical Committee: ISO/TC 21/SC 11 - Smoke and heat control systems and components
• Drafting Committee: ISO/TC 21/SC 11 - Smoke and heat control systems and components
• Current Stage: 9093 - International Standard confirmed
• Completion Date: 22-Mar-2024

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 21927-10
First edition
2011-07-15

Smoke and heat control systems —
Part 10:
Specification for power output devices
Systèmes pour le contrôle des fumées et de la chaleur —
Partie 10: Spécifications pour les sources d'alimentation




Reference number
ISO 21927-10:2011(E)
©
ISO 2011

---------------------- Page: 1 ----------------------
ISO 21927-10:2011(E)


COPYRIGHT PROTECTED DOCUMENT


©  ISO 2011
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56  CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [e-mail]
Web www.iso.org
Published in Switzerland

ii © ISO 2011 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 21927-10:2011(E)
Contents Page
Foreword . v
Introduction . vi
1 Scope . 1
2 Normative references . 1
3 Terms, abbreviated terms and definitions . 3
3.1 Terms and definitions . 3
3.2 Abbreviations . 4
4 General requirements — Electrical . 4
4.1 General . 4
4.2 Batteries . 5
4.3 Generator sets . 5
5 General requirements — Pneumatic . 6
5.1 General . 6
5.2 Power sources . 6
5.2.1 General . 6
5.2.2 Compressors . 7
5.2.3 Air receivers . 7
5.2.4 Multiple use gas bottles . 7
5.2.5 Single-use gas bottles . 8
6 Functions . 9
6.1 Power supply from the primary power source — Electrical . 9
6.2 Power supply from the secondary power source — Battery . 9
6.3 Power supply from the secondary power source — Generators . 10
6.4 Recognition and indication of faults — Electrical . 11
6.5 Power supply from compressed gases . 12
6.5.1 General .
...