ISO 251:2024

Conveyor belts with textile carcass — Widths and lengths

This document specifies the widths and lengths of conveyor belts with a textile carcass. It also specifies the corresponding tolerances. It is not applicable to light conveyor belts as described in ISO 21183-1, as tolerances on the widths and lengths of cut light conveyor belts are given in ISO 15147. NOTE The lengths of conveyor belts are not standardized.

Courroies transporteuses à carcasse textile — Largeurs et longueurs

L'ISO 251:2012 spécifie les largeurs et les longueurs des courroies transporteuses à carcasse textile. Elle spécifie également les tolérances correspondantes. Elle n'est pas applicable aux courroies transporteuses légères telles que décrites dans l'ISO 21183-1, puisque les tolérances sur les largeurs et les longueurs des courroies transporteuses légères à bords tranchés sont données dans l'ISO 15147.

General Information

• Status: Published
• Publication Date: 11-Dec-2024
• ICS: 53.040.20 - Components for conveyors
• Technical Committee: ISO/TC 41/SC 3 - Conveyor belts
• Drafting Committee: ISO/TC 41/SC 3 - Conveyor belts
• Current Stage: 6060 - International Standard published
• Start Date: 12-Dec-2024
• Due Date: 12-Dec-2024
• Completion Date: 12-Dec-2024

Relations

• Revises: ISO 251:2012 - Conveyor belts with textile carcass — Widths and lengths
• Effective Date: 25-Nov-2023

Standards Content (Sample)

International
Standard
ISO 251
Fifth edition
Conveyor belts with textile
2024-12
carcass — Widths and lengths
Courroies transporteuses à carcasse textile — Largeurs et
longueurs
Reference number
© ISO 2024
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: [phone]
Email: [e-mail]
Website: www.iso.org
Published in Switzerland
ii
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Widths and tolerances . 1
5 Tolerances on lengths . 2
Bibliography . 3

iii
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out through
ISO technical committees. Each member body interested in a subject for which a technical committee
has been established has the right to be represented on that committee. International organizations,
governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely
with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are described
in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the different types
of ISO documents should be noted. This document was drafted in accordance with the editorial rules of the
ISO/IEC Directives, Part 2 (see www.iso.org/directives).
ISO draws attention to the possibility that the implementation of this document may involve the use of (a)
patent(s). ISO takes no position concerning the evidence, validity or ap
...