ISO 21308-7:2018

Road vehicles — Product data exchange between chassis and body work manufacturers (BEP) — Part 7: Coding of skip loader bodywork

This document series describes a generic system for the exchange of data between truck chassis manufacturers and bodywork manufacturers. It applies to commercial vehicles as defined in ISO 3833, having a maximum gross vehicle mass above 3 500 kg. The process of exchanging the above information can involve: — chassis manufacturer; — chassis importer; — chassis dealer; — one or more bodywork manufacturers; and — bodywork component suppliers, e.g. manufacturers of demountable bodies, cranes and loading equipment, tipping equipment. This document specifically deals with the coding of dimensions and other characteristics of skip loaders, to ensure an efficient and unambiguous communication of installation data between the parties involved.

Véhicules routiers — Échange de données de produit entre les fabricants de châssis et de carrosseries (BEP) — Partie 7: Codage des multibennes

General Information

• Status: Published
• Publication Date: 03-Oct-2018
• ICS: 43.080.01 - Commercial vehicles in general
• Technical Committee: ISO/TC 22/SC 40 - Specific aspects for light and heavy commercial vehicles, busses and trailers
• Drafting Committee: ISO/TC 22/SC 40/WG 2 - Bodywork Exchange Parameters for commercial vehicles (BEP)
• Current Stage: 9060 - Close of review
• Start Date: 04-Jun-2029

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 21308-7
First edition
2018-10
Road vehicles — Product data
exchange between chassis and body
work manufacturers (BEP) —
Part 7:
Coding of skip loader bodywork
Véhicules routiers — Échange de données de produit entre les
fabricants de châssis et de carrosseries (BEP) —
Partie 7: Codage des multibennes
Reference number
ISO 21308-7:2018(E)
©
ISO 2018

---------------------- Page: 1 ----------------------
ISO 21308-7:2018(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2018
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: [phone]
Fax: [phone]
Email: [e-mail]
Website: www.iso.org
Published in Switzerland
ii © ISO 2018 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 21308-7:2018(E)

Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Coding principles . 4
4.1 BEP codes of bodywork for hook loaders . 4
4.2 Units of BEP code values . 4
4.3 References for measurements . 5
4.3.1 Global coordinate system (X, Y, Z) . 5
4.3.2 Skip loader coordinate system . 5
4.4 Related XML coding . 7
5 Coding of geometrical data and space requirements . 8
5.1 Installation of skip loader on vehicle . 8
5.2 Main dimensions skip loaders . 9
5.2.1 Transport position . . 9
5.2.2 Tipping position .17
5.2.3 Loading/unloading position .18
6 Coding of container dimensions and features necessary for the handling .21
7 Coding of masses .
...