ISO/IEC 14496-1:2004/Amd 3:2007
(Amendment)Information technology — Coding of audio-visual objects — Part 1: Systems — Amendment 3: JPEG 2000 support in MPEG-4
Information technology — Coding of audio-visual objects — Part 1: Systems — Amendment 3: JPEG 2000 support in MPEG-4
Technologies de l'information — Codage des objets audiovisuels — Partie 1: Systèmes — Amendement 3: Support JPEG 2000 dans MPEG-4
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO/IEC
STANDARD 14496-1
First edition
2004-11-15
AMENDMENT 3
2007-12-01
Information technology — Coding of
audio-visual objects —
Part 1:
Systems
AMENDMENT 3: JPEG 2000 support in
MPEG-4
Technologies de l'information — Codage des objets audiovisuels —
Partie 1: Systèmes
AMENDEMENT 3: Support JPEG 2000 dans MPEG-4
Reference number
ISO/IEC 14496-1:2004/Amd.3:2007(E)
©
ISO/IEC 2007
---------------------- Page: 1 ----------------------
ISO/IEC 14496-1:2004/Amd.3:2007(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
COPYRIGHT PROTECTED DOCUMENT
© ISO/IEC 2007
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO/IEC 2007 – All rights reserved
---------------------- Page: 2 ----------------------
ISO/IEC 14496-1:2004/Amd.3:2007(E)
Foreword
ISO (the International Organization for Standardization) and IEC (the International Electrotechnical
Commission) form the specialized system for worldwide standardization. National bodies that are members of
ISO or IEC participate in the development of International Standards through technical committees
established by the respective organization to deal with particular fields of technical activity. ISO and IEC
technical committees collaborate in fields of mutual interest. Other international organizations, governmental
and non-governmental, in liaison with ISO and IEC, also take part in the work. In the field of information
technology, ISO and IEC have established a joint technical committee, ISO/IEC JTC 1.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of the joint technical committee is to prepare International Standards. Draft International
Standards adopted by the joint technical committee are circulated to national bodies for voting. Publication as
an International Standard requires approval by at least 75 % of the national bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO and IEC shall not be held responsible for identifying any or all such patent rights.
Amendment 3 to ISO/IEC 14496-1:2004 was prepared by Joint Technical Committee ISO/IEC JTC 1,
Information technology, Subcommittee SC 29, Coding of audio, picture, multimedia and hypermedia
information.
It specifies the mechanisms for enabling the use of JPEG 2000 pictures inside an MPEG-4 scene. It consists
in defining the ObjectTypeIndication, the DecoderSpecificInfo and the Access Unit for JPEG 2000.
© ISO/IEC 2007 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO/IEC 14496-1:2004/Amd.3:2007(E)
Information technology — Coding of audio-visual objects —
Part 1:
Systems
AMENDMENT 3: JPEG 2000 support in MPEG-4
In 7.2.6.6.2, Table 5, add the ObjectTypeIndication for JPEG 2000 as follows.
Replace:
Table 5 — objectTypeIndication Values
Value ObjectTypeIndication Description
0x00 Forbidden
a
0x01 Systems ISO/IEC 14496-1
b
0x02 Systems ISO/IEC 14496-1
0x03 Interaction Stream
c
0x04 Systems ISO/IEC 14496-1 Extended BIFS Configuration
d
0x05 Systems ISO/IEC 14496-1 AFX
0x06 Font Data Stream
0x07 Synthesized Texture Stream
0x08 Streaming Text Stream
0x09-0x1F reserved for ISO use
e
0x20 Visual ISO/IEC 14496-2
f
0x21 Visual ITU-T Recommendation H.264 | ISO/IEC 14496-10
f
0x22 Parameter Sets for ITU-T Recommendation H.264 | ISO/IEC 14496-10
0x23-0x3F reserved for ISO use
g
0x40 Audio ISO/IEC 14496-3
0x41-0x5F reserved for ISO use
0x60 Visual ISO/IEC 13818-2 Simple Profile
0x61 Visual ISO/IEC 13818-2 Main Profile
0x62 Visual ISO/IEC 13818-2 SNR Profile
0x63 Visual ISO/IEC 13818-2 Spatial Profile
0x64 Visual ISO/IEC 13818-2 High Profile
0x65 Visual ISO/IEC 13818-2 422 Profile
0x66 Audio ISO/IEC 13818-7 Main Profile
0x67 Audio ISO/IEC 13818-7 LowComplexity Profile
© ISO/IEC 2007 – All rights reserved 1
---------------------- Page: 4 ----------------------
ISO/IEC 14496-1:2004/Amd.3:2007(E)
0x68 Audio ISO/IEC 13818-7 Scaleable Sampling Rate Profile
0x69 Audio ISO/IEC 13818-3
0x6A Visual ISO/IEC 11172-2
0x6B Audio ISO/IEC 11172-3
0x6C Visual ISO/IEC 10918-1
i
0x6D reserved for registration authority
0x6E - 0x9F reserved for ISO use
i
0xA0 - 0xBF reserved for registration authority
0xC0 - 0xE0 user private
i
0xE1 reserved for registration authority
0xE2 - 0xFE user private
h
0xFF no object type specified
a
This type is used for all 14496-1 streams unless specifically indicated to the contrary. Scene
Description scenes, which are identified with StreamType=0x03, using this object type value shall use the
BIFSConfig specified in ISO/IEC 14496-11.
b
This object type shall be used, with StreamType=0x03, for Scene Description streams that use the
BIFSv2Config specified in ISO/IEC 14496-11. Its use with other StreamTypes is reserved.
c
This object type shall be used, with StreamType=0x03, for Scene Description streams that use the
BIFSConfigEx specified in subclause 7.2.6.7 of this specification. Its use with other StreamTypes is
reserved.
d
This object type shall be used, with StreamType=0x03, for Scene Description streams that use the
AFXConfig specified in subclause 7.2.6.7 of this specification. Its use with other StreamTypes is
reserved.
e
Includes associated Amendment(s) and Corrigendum(a). The actual object types are defined in
ISO/IEC 14496-2 and are conveyed in the DecoderSpecificInfo as specified in ISO/IEC 14496-2, Annex
K.
f
Includes associated Amendment(s) and Corrigendum(a). The actual object types are defined in ITU-
T Recommendation H.264 | ISO/IEC 14496-10 and are conveyed in the DecoderSpecificInfo as specified
in this amendment, subclause I.2.
g
Includes associated Amendment(s) and Corrigendum(a). The actual object types are defined in
ISO/IEC 14496-3 and are conveyed in the DecoderSpecificInfo as specified in ISO/IEC 14496-3 subpart
1 subclause 6.2.1.
h
Streams with this value with a StreamType indicating a systems stream (values 1,2,3, 6, 7, 8, 9)
shall be treated as if the ObjectTypeIndication had been set to 0x01.
i
The latest entries registered can be found in http://mp4ra.apple.com/object.html.
2 © ISO/IEC 2007 – All rights reserved
---------------------- Page: 5 ----------------------
ISO/IEC 14496-1:2004/Amd.3:2007(E)
with:
Table 5 — ObjectTypeIndication Values
Value ObjectTypeIndication Description
0x00 Forbidden
a
0x01 Systems ISO/IEC 14496-1
b
0x02 Systems ISO/IEC 14496-1
0x03 Interaction Stream
c
0x04 Systems ISO/IEC 14496-1
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.