ISO 17299-6:2025
(Main)Textiles — Determination of deodorant property — Part 6: Gas chromatography method using automated dosing and sampling
Textiles — Determination of deodorant property — Part 6: Gas chromatography method using automated dosing and sampling
This document specifies gas chromatography (GC) test methods for the deodorant testing of all textile products. These methods apply to odour component chemicals, such as indole, isovaleric acid and nonenal. Two methods are described in this document. — Method A (single analysis) where an odour chemical is applied in a container avoiding contact with a test specimen. — Method B (auto-regeneration) where an odour chemical is applied in a container avoiding contact with a test specimen multiple times to repeatedly challenge a test specimen.
Textiles — Détermination des propriétés de neutralisation d'odeurs — Partie 6: Méthode par chromatographie en phase gazeuse utilisant un dosage et un échantillonnage automatisés
General Information
Standards Content (Sample)
International
Standard
ISO 17299-6
First edition
Textiles — Determination of
2025-05
deodorant property —
Part 6:
Gas chromatography method using
automated dosing and sampling
Textiles — Détermination des propriétés de neutralisation
d'odeurs —
Partie 6: Méthode par chromatographie en phase gazeuse
utilisant un dosage et un échantillonnage automatisés
Reference number
© ISO 2025
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Reagents and materials . 2
5 Apparatus . 2
6 Preparation and preservation of test samples and test specimens . 3
7 Procedure . 4
7.1 General .4
7.2 Method A — Single analysis procedure .4
7.2.1 Preparation of injection vials . .4
7.2.2 Placement of test specimen . .4
7.2.3 Placement of injection vials .4
7.2.4 Conditioning the test specimens .4
7.2.5 Preparation of the odour component chemical solution .4
7.2.6 Injection of testing odour component chemical solution .5
7.2.7 Sampling of the testing gas .5
7.2.8 Concentration measurement of testing gas by GC .5
7.2.9 Peak area of MS/FID spectrum of testing gas with test specimen .5
7.2.10 Concentration of testing gas without specimen .5
7.3 Method B — Auto-regeneration procedure .5
7.3.1 Analysis .5
7.3.2 Repeat cycles .5
8 Calculation of odour reduction rate . 6
9 Test report . 6
Annex A (informative) GC parameters . 7
Annex B (informative) Selection of the test condition comparing to ISO 17299-3 . 9
Annex C (informative) Example of test result . 10
Annex D (informative) Example of odour reduction rate test report .13
Bibliography . 14
iii
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out through
ISO technical committees. Each member body interested in a subject for which a technical committee
has been established has the right to be represented on that committee. International organizations,
governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely
with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are described
in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the different types
of ISO document should be noted. This document was drafted in accordance with the editorial rules of the
ISO/IEC Directives, Part 2 (see www.iso.org/directives).
ISO draws attention to the possibility that the implementation of this document may involve the use of (a)
patent(s). ISO takes no position concerning the evidence, validity or applicability of any claimed patent
rights in respect thereof. As of the date of publication of this document, ISO had not received notice of (a)
patent(s) which may be required to implement this document. However, implementers are cautioned that
this may not represent the latest information, which may be obtained from the patent database available at
www.iso.org/patents. ISO shall not be held responsible for identifying any or all such patent rights.
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and expressions
related to conformity assessment, as well as information about ISO's adherence to the World Trade
Organization (WTO) principles in the Technical Barriers to Trade (TBT), see www.iso.org/iso/foreword.html.
This document was prepared by Technical Committee ISO/TC 38, Textiles.
A list of all parts in the ISO 17299 series can be found on the ISO website.
Any feedback or questions on this document should be directed to the user’s national standards body. A
complete listing of these bodies can be found at www.iso.org/members.html.
iv
Introduction
This document describes a gas chromatography testing method for concentration measurement of odour
chemicals in deodorant testing. This is the most general testing method that can be carried out in many
testing laboratories globally if they have gas chromatography equipped with accessories for automated
dosing and sampling.
This document describes a specific procedure for the gas chromatography testing method using automated
dosing and sampling, while ISO 17299-3 is based on manual dosing and sampling.
Concentrations of the gaseous odour component chemicals in containers with or without a test specimen
after a designated contact time are measured by GC. The reduction rate of concentration of odour chemicals
in the container with a test specimen is calculated from the concentration data with a test specimen and
without a test specimen.
Each chemical odorant is tested separately. Odour chemical contact with fabric can be uncontrollable due to
auto-dosing device. However, heating and agitation are expected to volatilize the odorant solution.
v
International Standard ISO 17299-6:2025(en)
Textiles — Determination of deodorant property —
Part 6:
Gas chromatography method using automated dosing and
sampling
1 Scope
This document specifies gas chromatography (GC) test methods for the deodorant testing of all textile
products. These methods apply to odour component chemicals, such as indole, isovaleric acid and nonenal.
Two methods are described in this document.
— Method A (single analysis) where an odour chemical is applied in a container avoiding contact with a test
specimen.
— Method B (auto-regeneration) where an odour chemical is applied in a container avoiding contact with a
test specimen multiple times to repeatedly challenge a test specimen.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes
requirements of this document. For dated references, only the edition cited applies. For undated references,
the latest edition of the referenced document (including any amendments) applies.
ISO 139, Textiles — Standard atmospheres for conditioning and testing
ISO 3696, Water for analytical laboratory use — Specification and test methods
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
ISO and IEC maintain terminology databases for use in standardization at the following addresses:
— ISO Online browsing platform: available at https:// www .iso .org/ obp
— IEC Electropedia: available at https:// www .electropedia .org
3.1
test specimen
test piece that is cut from a sample of a textile product (3.3), as specified by the test procedure, or a
representative sample of the product itself
3.2
textile deodorant
textile with the ability to reduce the unpleasant odour (3.4) in the ambient air around textile products (3.3)
Note 1 to entry: The unpleasant odour is caused by the chemicals listed in 4.1, 4.2 and 4.3.
[SOURCE: ISO 17299-1:2014, 3.1.4, modified — cross reference changed in Note 1]
3.3
textile product
product made of textile fibres, yarns and/or fabrics and intended to be used, as such or in conjunction with
other textile or non-textile elements
3.4
unpleasant odour
uncomfortable odour related to the human living environment, such as toilet odour, sweat odour, body odour
(nonenal mixture odour), excrement odour, etc.
Note 1 to entry: These chemicals are as follows:
— sweat odour: isovaleric acid (4.2);
— body odour: isovaleric acid (4.2) and nonenal (4.3);
— excrement odour: indole (4.1).
Note 2 to entry: Other chemicals might be relevant. The selected chemicals are conceived as representative.
[SOURCE: ISO 17299-1:2014, 3.1.1, modified — Notes to entry have been added.]
3.5
auto-sampling device
device used to automatically and reproducibly deliver the odour chemicals (3.4) into the injection vials and
uptake the headspace sample that is to be analysed
3.6
auto-regeneration
ability of a textile deodorant to continue odour capture actions when odour chemical application is repeated
4 Reagents and materials
Unless otherwise specified, analytical grades shall be used.
1)
4.1 Indole (C H N), (CAS RN® 120-72-9) reagent.
8 7
1)
4.2 Isovaleric acid, (CAS RN® 503-74-2) reagent with a purity of 98 %.
1)
4.3 2-Nonenal (C H O), (CAS RN® 18829-56-6) reagent with a purity of 95,0 %.
9 16
1)
4.4 Methanol, (CAS RN® 67-56-1) for cleaning scissors/rotary cutter.
1)
4.5 Ethanol, (CAS RN® 64-17-5) reagent grade.
4.6 Water, grade 3 as specified in ISO 3696.
5 Apparatus
The usual laboratory apparatus and, in particular, the following shall be used.
5.1 Analytical balance, capable of weighing accurately to 0,000 1 g.
1) CAS Registry Number® is a trademark of the American Chemical Society (ACS
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.