SIST ETS 300 133-6 E1:2003
(Main)Paging Systems (PS); Enhanced Radio MEssage System (ERMES); Part 6: Base station conformance specification
Paging Systems (PS); Enhanced Radio MEssage System (ERMES); Part 6: Base station conformance specification
General requirements Base station model Transmitter requirements Synchronization requirements Base station network functions
Sistemi osebnega klica (PS) ¬– Evropski sistem za radijsko sporočanje (ERMES) – 6. del: Specifikacija skladnosti za bazne postaje
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
SIST ETS 300 133-6 E1:2003
01-december-2003
6LVWHPLRVHEQHJDNOLFD36¤±(YURSVNLVLVWHP]DUDGLMVNRVSRURþDQMH(50(6±
GHO6SHFLILNDFLMDVNODGQRVWL]DED]QHSRVWDMH
Paging Systems (PS); Enhanced Radio MEssage System (ERMES); Part 6: Base station
conformance specification
Ta slovenski standard je istoveten z: ETS 300 133-6 Edition 1
ICS:
33.070.20 Sistem za osebni klic Paging systems
SIST ETS 300 133-6 E1:2003 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST ETS 300 133-6 E1:2003
---------------------- Page: 2 ----------------------
SIST ETS 300 133-6 E1:2003
EUROPEAN ETS 300 133-6
TELECOMMUNICATION July 1992
STANDARD
Source: ETSI TC-PS Reference: DE/PS-2001-6
ICS: 33.080
ERMES, base station, conformance
Key words:
Paging systems (PS);
European Radio Message System (ERMES)
Part 6 : Base station conformance specification
ETSI
European Telecommunications Standards Institute
ETSI Secretariat
F-06921 Sophia Antipolis CEDEX - FRANCE
Postal address:
650 Route des Lucioles - Sophia Antipolis - Valbonne - FRANCE
Office address:
c=fr, a=atlas, p=etsi, s=secretariat - secretariat@etsi.fr
X.400: Internet:
Tel.: +33 92 94 42 00 - Fax: +33 93 65 47 16
Copyright Notification: No part may be reproduced except as authorized by written permission. The copyright and the
foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 1992. All rights reserved.
New presentation - see History box
---------------------- Page: 3 ----------------------
SIST ETS 300 133-6 E1:2003
Page 2
ETS 300 133-6: July 1992
Whilst every care has been taken in the preparation and publication of this document, errors in content,
typographical or otherwise, may occur. If you have comments concerning its accuracy, please write to
"ETSI Editing and Committee Support Dept." at the address shown on the title page.
---------------------- Page: 4 ----------------------
SIST ETS 300 133-6 E1:2003
Page 3
ETS 300 133-6: July 1992
Contents
Foreword .5
1 Scope .7
2 Normative references.7
3 Definitions.7
4 Abbreviations.8
5 Base station description .8
6 RF requirements .8
6.1 General .8
6.1.1 Extreme test conditions.8
6.2 Modulation .8
6.2.1 Symbol transition shaping .8
6.2.2 In-channel RF spectrum.9
6.3 Frequency tolerances .9
6.4 Symbol rate.9
7 Test methods .9
7.1 General .9
7.2 Modulation .9
7.2.1 Symbol transition shaping .9
7.2.2 RF spectrum.10
7.3 Frequency tolerances .10
7.3.1 Centre frequency.10
7.3.2 Symbol frequency.10
7.4 Symbol rate.10
History.11
---------------------- Page: 5 ----------------------
SIST ETS 300 133-6 E1:2003
Page 4
ETS 300 133-6: July 1992
Blank page
---------------------- Page: 6 ----------------------
SIST ETS 300 133-6 E1:2003
Page 5
ETS 300 133-6: July 1992
Foreword
This European Telecommunication Standard (ETS) has been produced by the Paging Systems (PS)
Technical Committee of the European Telecommunications Standards Institute (ETSI).
This ETS comprises seven parts with the generic title "Paging systems (PS); European Radio Message
System (ERMES)". The title of each part is listed below:
- ETS 300 133-1: "Part 1: General aspects"
- ETS 300 133-2: "Part 2: Service aspects"
- ETS 300 133-3: "Part 3: Network aspects"
- ETS 300 133-4: "Part 4: Air interface specification"
- ETS 300 133-5: "Part 5: Receiver conformance specification"
- ETS 300 133-6: "Part 6: Base station conformance specification"
- ETS 300 133-7: "Part 7: Operation and maintenance aspects"
This part, ETS 300 133-6, gives the European Radio Message System (ERMES) base station
conformance specification and includes the technical characteristics of the transmitters.
---------------------- Page: 7 ----------------------
SIST ETS 300 133-6 E1:2003
Page 6
ETS 300 133-6: July 1992
Blank page
---------------------- Page: 8 ----------------------
SIST ETS 300 133-6 E1:2003
Page 7
ETS 300 133-6: July 1992
1 Scope
This part of the seven part European Telecommunication Standard (ETS) 300 133 defines the
requirements for base stations operating on the European Radio Message System (ERMES). A general
description of the base station is given and detailed Radio Frequency (RF) characteristics defined.
2 Normative references
This ETS incorporates by dated or undated reference, provisions from other publications. These
normative references are cited at the appropriate places in the text and the publications are listed
hereafter. For dated references subsequent amendments to, or revisions of any of these publications
apply to this ETS only when incorporated in it by amendment or revision. For undated references the latest
edition of the publication referred to applies.
[1] ETS 300 133-1: "Paging Systems (PS); European Radio Message System
(ERMES) Part 1: General aspects".
[2] ETS 300 133-2: "Paging Systems (PS); European Radio Message System
(ERMES) Part 2: Service aspects".
[3] ETS 300 133-3: "Paging Systems (PS); European Radio Message System
(ERMES) Part 3: Network aspects".
[4] ETS 300 133-4: "Paging
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.