SIST EN 327:2002/A1:2004
(Amendment)Heat exchangers - Forced convection air cooled refrigerant condensors - Test procedure for establishing performance
Heat exchangers - Forced convection air cooled refrigerant condensors - Test procedure for establishing performance
UAP of 4 months (TC Res 146a/1998) (CC/001115)
Wärmeaustauscher - Ventilatorbelüftete Verflüssiger - Prüfverfahren zur Leistungsfeststellung
Echangeurs thermiques - Condenseurs d'aéroréfrigérant a convection - Procédure d'essai pour la détermination de la perfomance
Prenosniki toplote – Kondenzatorji s prisilno konvekcijo – Postopki preskušanja za ugotavljanje tehničnih karakteristik - Dopolnilo A1
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 327:2002/A1:2004
01-januar-2004
3UHQRVQLNLWRSORWH±.RQGHQ]DWRUMLVSULVLOQRNRQYHNFLMR±3RVWRSNLSUHVNXãDQMD
]DXJRWDYOMDQMHWHKQLþQLKNDUDNWHULVWLN'RSROQLOR$
Heat exchangers - Forced convection air cooled refrigerant condensors - Test procedure
for establishing performance
Wärmeaustauscher - Ventilatorbelüftete Verflüssiger - Prüfverfahren zur
Leistungsfeststellung
Echangeurs thermiques - Condenseurs d'aéroréfrigérant a convection - Procédure
d'essai pour la détermination de la perfomance
Ta slovenski standard je istoveten z: EN 327:2000/A1:2002
ICS:
27.060.30 Grelniki vode in prenosniki Boilers and heat exchangers
toplote
SIST EN 327:2002/A1:2004 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 327:2002/A1:2004
---------------------- Page: 2 ----------------------
SIST EN 327:2002/A1:2004
EUROPEAN STANDARD
EN 327:2000/A1
NORME EUROPÉENNE
EUROPÄISCHE NORM
October 2002
ICS 27.060.30
English version
Heat exchangers - Forced convection air cooled refrigerant
condensers - Test procedure for establishing performance
Echangeurs thermiques - Aérocondenseurs à convection Wärmeaustauscher - Ventilatorbelüftete Verflüssiger -
forcée - Procédure d'essai pour la détermination de la Prüfverfahren zur Leistungsfeststellung
performance
This amendment A1 modifies the European Standard EN 327:2000; it was approved by CEN on 14 September 2002.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this
amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references concerning such
national standards may be obtained on application to the Management Centre or to any CEN member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,
Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2002 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 327:2000/A1:2002 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 327:2002/A1:2004
EN 327:2000/A1:2002 (E)
Contents
page
Foreword.3
Title .3
3 Definitions.3
5 Standard capacity .4
7 Measurements.4
8 Testing methods and equipment.4
2
---------------------- Page: 4 ----------------------
SIST EN 327:2002/A1:2004
EN 327:2000/A1:2002 (E)
Foreword
This document (EN 327:2000/A1:2002) has been prepared by Technical Committee CEN /TC 110 "Heat
exchangers", the secretariat of which is held by BSI.
This European Standard shall be given the status of a national standard, either by publication of an identical text or
by endorsement, at the latest by April 2003, and conflicting national standards shall be withdrawn at the latest by
April 2003.
This amendment is introduced to accommodate newly available refrigerants such as R404A, R407C and R410A.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.