SIST EN 13087-8:2001/A1:2005
(Amendment)Protective helmets - Test methods - Part 8: Electrical properties
Protective helmets - Test methods - Part 8: Electrical properties
This European Standard describes methods of test for protective helmets. The purpose of these tests is to enable assessment of the performance of the helmet as specified in the appropriate helmet standard. This standard specifies the methods of test for electrical properties. Additional text from CENELEC excluding reference to EN 50365:2002.
Schutzhelme - Prüfverfahren - Teil 8: Elektrische Eigenschaften
Casques de protection - Méthodes d'essai - Partie 8 : Propriétés électriques
Varovalne čelade - Preskusne metode - 8. del: Električne lastnosti
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 13087-8:2001/A1:2005
01-april-2005
9DURYDOQHþHODGH3UHVNXVQHPHWRGHGHO(OHNWULþQHODVWQRVWL
Protective helmets - Test methods - Part 8: Electrical properties
Schutzhelme - Prüfverfahren - Teil 8: Elektrische Eigenschaften
Casques de protection - Méthodes d'essai - Partie 8 : Propriétés électriques
Ta slovenski standard je istoveten z: EN 13087-8:2000/A1:2005
ICS:
13.340.20 Varovalna oprema za glavo Head protective equipment
SIST EN 13087-8:2001/A1:2005 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
EUROPEAN STANDARD
EN 13087-8:2000/A1
NORME EUROPÉENNE
EUROPÄISCHE NORM
January 2005
ICS 13.340.20
English version
Protective helmets - Test methods - Part 8: Electrical properties
Casques de protection - Méthodes d'essai - Partie 8 : Schutzhelme - Prüfverfahren - Teil 8: Elektrische
Propriétés électriques Eigenschaften
This amendment A1 modifies the European Standard EN 13087-8:2000; it was approved by CEN on 9 December 2004.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this
amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references concerning such
national standards may be obtained on application to the Central Secretariat or to any CEN member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.