CEN/TC 132/WG 6 - Aluminium foil and finstock

This document specifies the tolerances on dimensions for single and double-rolled aluminium and aluminium alloy foil supplied in accordance with EN 546-1.

This document specifies the tolerances on dimensions and form for wrought aluminium and wrought aluminium alloy finstock supplied in accordance with EN 683-1.

This document specifies the requirements for special properties of wrought aluminium and wrought aluminium alloy foil and their tests. It applies to flat rolled products.
It does not apply to lacquered, painted, embossed or laminated products.
The technical conditions for inspection and delivery of foil are specified in EN 546-1.

This document specifies the technical conditions for inspection and delivery of wrought aluminium and aluminium alloy foil. The gauge range covered is 6 m to 200 m.
It does not apply to lacquered, painted, embossed or laminated products.

This document specifies the technical conditions for inspection and delivery of wrought aluminium and wrought aluminium alloy finstock.
The gauge range covered is 60 µm to 400 µm.
It does not apply to cladded finstock.

This document specifies the mechanical properties of wrought aluminium and aluminium alloy foil.
The chemical composition limits of these materials are specified in EN 573-3.
The designations of aluminium and aluminium alloys and the temper designations used in this standard are specified in EN 573-3 and the temper designation are defined EN 515.

This document specifies the mechanical properties of wrought aluminium and wrought aluminium alloy finstock.
The chemical composition limits of these materials are specified in EN 573-3, unless otherwise agreed between supplier and purchaser.
The designations of wrought aluminium and wrought aluminium alloys and the temper designations used in this standard are specified in EN 573-3, and the temper designations are defined in EN 515.

This part of EN 546 specifies the requirements for special properties of wrought aluminium and aluminium alloy foil and their tests. It applies to flat rolled products. It does not apply to lacquered, painted, embossed or laminated products. The chemical composition of these alloys is specified in EN 573-3.

This part of EN 683 specifies the requirements for tolerances on dimensions and form for aluminium and aluminium alloy finstock supplied in accordance with prEN 683-1.

This part of EN 683 specifies the mechanical properties of wrought aluminium and aluminium alloy finstock. It applies to flat rolled products. The chemical composition limits of these materials are specified in EN 573-3. The designations of wrought aluminium and aluminium alloys and the temper designations used in this standard are specified in EN 573-1 and EN 573-2 and EN 515 respectively.

This part of EN 546 specifies the mechanical properties of wrought aluminium and aluminium alloy foil. It applies to flat rolled products. The chemical composition limits of these materials are specified in EN 573-3. The designations of aluminium and aluminium alloys and the temper designations used in this standard are in accordance with EN 573 parts 1 and 2 and EN 515 respectively.

This Part of EN 546 specifies the technical conditions for inspection and delivery of wrought aluminium and aluminium alloy foil. It does not apply to lacquered, painted, embossed or laminated products. The gauge range covered is 6 micrometers to 200 micrometers.

This part of EN 546 specifies the requirements for tolerances on dimensions for single and double-rolled aluminium and aluminium alloy foil supplied in accordance with EN 546-1.

This Part of EN 683 specifies the technical conditions for inspection and delivery of wrought aluminium and aluminium alloy finstock. The gauge range covered is 80 mm to 350 mm.