CEN/TC 459/SC 8/WG 1 - Measurement of the coating properties of non­oriented electrical steel

This document describes the mechanical testing methods, relevant for self-bonding coating assemblies with non-oriented electrical steels. In particular, it describes the mechanical testing methods, sample preparation, calibration methods, necessary to obtain reliable results that can be considered a reference for quality evaluation.
This document applies only to self-bonding coatings of non-oriented electrical steels.

This document establishes a classification of surface insulations for electrical steel sheet, strip and laminations according to their general composition, relative insulating ability and function.
These surface insulations are either oxide layers or applied coatings.
The purpose of this classification is to create a nomenclature for the various types of surface insulations and to assist users of surface insulations by providing general information about the chemical nature and use of the surface insulations.
It is not the intent of this classification to specify insulation requirements in terms of specific values of surface insulation resistance. Such requirements are to be agreed between the purchaser and the steel producer, where applicable.
The classification is to be used in conjunction with the various specifications for cold rolled electrical steels (see Clause 2).

This document defines the grades of electrical steel strip and sheet with specified mechanical properties and magnetic polarization. It specifies general requirements, mechanical properties, magnetic polarization, geometric characteristics, tolerances and technological characteristics, as well as inspection procedures.
This document applies to electrical steel strip and sheet for the construction of poles and rims of rotating electrical machines.
The grades are grouped into two classes according to their manufacturing process:
-   hot-rolled grades;
-   cold-rolled grades.
NOTE   These materials correspond to EN 60404 1:2017, D.2.