Standard Specification for Woven High Stretch Fabrics Used in Apparel

SIGNIFICANCE AND USE
4.1 Upon mutual agreement between the purchaser and the supplier, woven high stretch fabrics used in apparel should meet all of the requirements listed in Table 1 of this specification.
4.2 It is recognized that, for purposes of fashion or aesthetics, the ultimate consumer of articles made from these fabrics may find acceptable products that do not conform to all of the requirements listed in Table 1. Therefore, one or more of the requirements in Table 1 may be modified by mutual agreement between the purchaser and the supplier.  
4.2.1 In such cases, any references to the specifications should specify that: “This product meets ASTM specifications XXXX except for the following characteristic(s).”  
4.3 Where no pre-purchase agreement has been reached between the purchaser and supplier, and in case of controversy, the requirements listed in Table 1 are intended to be used as a guide only. As noted in 4.2, ultimate consumer demands dictate varying performance parameters for a particular product.  
4.4 The uses and significance of particular properties and test methods are discussed in the appropriate sections of the specified test methods.
SCOPE
1.1 This specification covers the performance requirements for woven high stretch fabrics used in apparel.  
1.2 The following safety hazards caveat pertains only to the test methods described in this performance specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

General Information

Status
Historical
Publication Date
31-Jan-2014
Technical Committee
Drafting Committee
Current Stage
Ref Project

Buy Standard

Technical specification
ASTM D7507-14 - Standard Specification for Woven High Stretch Fabrics Used in Apparel
English language
3 pages
sale 15% off
Preview
sale 15% off
Preview
Technical specification
REDLINE ASTM D7507-14 - Standard Specification for Woven High Stretch Fabrics Used in Apparel
English language
3 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

NOTICE: This standard has either been superseded and replaced by a new version or withdrawn.
Contact ASTM International (www.astm.org) for the latest information
Designation: D7507 − 14
Standard Specification for
1
Woven High Stretch Fabrics Used in Apparel
This standard is issued under the fixed designation D7507; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (´) indicates an editorial change since the last revision or reapproval.
1. Scope 116 Colorfastness to Crocking: Rotary Vertical Crockmeter
Method
1.1 This specification covers the performance requirements
132 Colorfastness to Drycleaning
for woven high stretch fabrics used in apparel.
135 Dimensional Changes of Fabrics after Home Launder-
1.2 The following safety hazards caveat pertains only to the
ing
test methods described in this performance specification:This
158 Dimensional Changes on Drycleaning in Perchloroeth-
standard does not purport to address all of the safety concerns,
ylene: Machine Method
if any, associated with its use. It is the responsibility of the user
172 Colorfastness to Non-Chlorine Bleach in Home Laun-
of this standard to establish appropriate safety and health
dering
practices, and determine the applicability of regulatory limi-
5
2.3 Other Documents:
tations prior to use.
16 CFR 1610 Standard for Flammability of Clothing Tex-
tiles
2. Referenced Documents (see Note 1)
2
NOTE 1—Reference to test methods in this specification give only the
2.1 ASTM Standards:
permanent part of the designation of ASTM, AATCC, or other test
D123 Terminology Relating to Textiles
methods. The current editions of each test method cited shall prevail.
D2905 Practice for Statements on Number of Specimens for
3
Textiles (Withdrawn 2008)
3. Terminology
D3107 Test Methods for Stretch Properties of Fabrics Wo-
3.1 Definitions: For definitions of textile terms used in this
ven from Stretch Yarns
specification, refer to Terminology D123 and the AATCC
D3775 Test Method for Warp (End) and Filling (Pick) Count
Glossary.
of Woven Fabrics
3.1.1 woven high stretch fabric, n—woven fabrics with
D3776 Test Methods for Mass Per Unit Area (Weight) of
greater than 15 % elastic fiber content.
Fabric
4
2.2 AATCC Test Methods:
4. Significance and Use
8 Colorfastness to Crocking: AATCC Crockmeter Method
4.1 Upon mutual agreement between the purchaser and the
15 Colorfastness to Perspiration
supplier, woven high stretch fabrics used in apparel should
16 Colorfastness to Light
meet all of the requirements listed in Table 1 of this specifi-
61 Colorfastness to Laundering, Home and Commercial:
cation.
Accelerated
4.2 It is recognized that, for purposes of fashion or
81 pH of the Water-Extraction from West Processed Textiles
109 Colorfastness to Ozone in the Atmosphere Under Low aesthetics, the ultimate consumer of articles made from these
fabrics may find acceptable products that do not conform to all
Humidity’s
of the requirements listed in Table 1. Therefore, one or more of
the requirements in Table 1 may be modified by mutual
1
This specification is under the jurisdiction of ASTM Committee D13 on
agreement between the purchaser and the supplier.
Textiles and is the direct responsibility of Subcommittee D13.61 on Apparel.
4.2.1 In such cases, any references to the specifications
Current edition approved Feb. 1, 2014. Published March 2014. Originally
approved in 2010. Last previous edition approved in 2010 as D7507-10. DOI:
should specify that: “This product meets ASTM specifications
10.1520/D7507-14.
XXXX except for the following characteristic(s).”
2
For referenced ASTM standards, visit the ASTM website, www.astm.org, or
contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM
4.3 Where no pre-purchase agreement has been reached
Standards volume information, refer to the standard’s Document Summary page on
between the purchaser and supplier, and in case of controversy,
the ASTM website.
3 the requirements listed in Table 1 are intended to be used as a
The last approved version of this historical standard is referenced on
www.astm.org.
4
Available from American Association of Textile Chemists and Colorists
5
(AATCC), P.O. Box 12215, Research Triangle Park, NC 27709, http:// Available from Superintendent of Documents, Government Printing Office,
www.aatcc.org. Washington, DC 20402.
Copyright © ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States
1

---------------------- Page: 1 ----------------------
D7507 − 14
TABLE 1 Specification Requirements
Characteristic Requirements Section
One-Way Stretch Two-Way Stretch
Dimensional Change to Home Laundering 3 Cycles ±3 % ±5 % 7.1.1
Dimensional Change to Drycleaning ±2 % 7.1.2
1 Cycle
A
Colorfastness to Accelerated Laundering-General 7.2.1
Color change Grade 4
Staining Grade 3
Col
...

This document is not an ASTM standard and is intended only to provide the user of an ASTM standard an indication of what changes have been made to the previous version. Because
it may not be technically possible to adequately depict all changes accurately, ASTM recommends that users consult prior editions as appropriate. In all cases only the current version
of the standard as published by ASTM is to be considered the official document.
Designation: D7507 − 10 D7507 − 14
Standard Specification for
1
Woven High Stretch Fabrics Used in Apparel
This standard is issued under the fixed designation D7507; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (´) indicates an editorial change since the last revision or reapproval.
1. Scope
1.1 This specification covers the performance requirements for woven high stretch fabrics used in apparel.
1.2 The following safety hazards caveat pertains only to the test methods described in this performance specification:This
standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user
of this standard to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior
to use.
2. Referenced Documents (see Note 1)
2
2.1 ASTM Standards:
D123 Terminology Relating to Textiles
3
D2905 Practice for Statements on Number of Specimens for Textiles (Withdrawn 2008)
D3107 Test Methods for Stretch Properties of Fabrics Woven from Stretch Yarns
D3775 Test Method for Warp (End) and Filling (Pick) Count of Woven Fabrics
D3776 Test Methods for Mass Per Unit Area (Weight) of Fabric
4
2.2 AATCC Test Methods:
8 Colorfastness to Crocking: AATCC Crockmeter Method
15 Colorfastness to Perspiration
16 Colorfastness to Light
61 Colorfastness to Laundering, Home and Commercial: Accelerated
81 pH of the Water-Extraction from West Processed Textiles
109 Colorfastness to Ozone in the Atmosphere Under Low Humidity’s
116 Colorfastness to Crocking: Rotary Vertical Crockmeter Method
132 Colorfastness to Drycleaning
135 Dimensional Changes of Fabrics after Home Laundering
158 Dimensional Changes on Drycleaning in Perchloroethylene: Machine Method
172 Colorfastness to Non-Chlorine Bleach in Home Laundering
5
2.3 Other Documents:
16 CFR 1610 Standard for Flammability of Clothing Textiles
NOTE 1—Reference to test methods in this specification give only the permanent part of the designation of ASTM, AATCC, or other test methods. The
current editions of each test method cited shall prevail.
3. Terminology
3.1 Definitions: For definitions of textile terms used in this specification, refer to Terminology D123 and the AATCC Glossary.
3.1.1 woven high stretch fabric, n—woven fabrics with greater than 15 % elastic fiber content.
1
This specification is under the jurisdiction of ASTM Committee D13 on Textiles and is the direct responsibility of Subcommittee D13.61 on Apparel.
Current edition approved Feb. 1, 2010Feb. 1, 2014. Published March 2010March 2014. Originally approved in 2010. Last previous edition approved in 2010 as D7507-10.
DOI: 10.1520/D7507-10.10.1520/D7507-14.
2
For referenced ASTM standards, visit the ASTM website, www.astm.org, or contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM Standards
volume information, refer to the standard’s Document Summary page on the ASTM website.
3
The last approved version of this historical standard is referenced on www.astm.org.
4
Available from American Association of Textile Chemists and Colorists (AATCC), P.O. Box 12215, Research Triangle Park, NC 27709, http://www.aatcc.org.
5
Available from Superintendent of Documents, Government Printing Office, Washington, DC 20402.
Copyright © ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States
1

---------------------- Page: 1 ----------------------
D7507 − 14
4. Significance and Use
4.1 Upon mutual agreement between the purchaser and the supplier, woven high stretch fabrics used in apparel should meet all
of the requirements listed in Table 1 of this specification.
4.2 It is recognized that, for purposes of fashion or aesthetics, the ultimate consumer of articles made from these fabrics may
find acceptable products that do not conform to all of the requirements listed in Table 1. Therefore, one or more of the requirements
in Table 1 may be modified by mutual agreement between the purchaser and the supplier.
4.2.1 In such cases, any references to the specifications should specify that: “This product meets ASTM specifications XXXX
except for the following characteristic(s).”
4.3 Where no pre-purchase agreement has been reached between the purchaser and supplier, and in case of controversy, the
requirements listed in Table 1 are intended to be used as a guide only. As not
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.