ASTM A701-05(2010)
(Specification)Standard Specification for Ferromanganese-Silicon
Standard Specification for Ferromanganese-Silicon
ABSTRACT
This specification covers ferromanganese-silicon alloy. The alloys which are available in different sizes shall conform to the required chemical composition for manganese, carbon, silicon, phosphorus, arsenic, tin, lead, and chromium.
SCOPE
1.1 This specification covers a manganese-silicon alloy.
General Information
Relations
Standards Content (Sample)
NOTICE: This standard has either been superseded and replaced by a new version or withdrawn.
Contact ASTM International (www.astm.org) for the latest information
Designation: A701 – 05 (Reapproved 2010)
Standard Specification for
Ferromanganese-Silicon
This standard is issued under the fixed designation A701; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (´) indicates an editorial change since the last revision or reapproval.
1. Scope 4. Chemical Requirements
1.1 This specification covers a manganese-silicon alloy. 4.1 The alloy shall conform to the chemical requirements as
specified in Table 1 and Table 2.
2. Referenced Documents
4.2 The manufacturer shall furnish an analysis of each
2.1 ASTM Standards:
shipment showing the percentage of each element specified.
A1025 Specification for Ferroalloys and Other Alloying
5. Size
Materials, General Requirements
5.1 The alloy is available in the sizes shown in Table 3.
3. General Conditions for Delivery
5.2 The sizes listed in Table 3 are typical of the product as
3.1 Materials furnished to this specification shall conform to
shipped from the seller’s plant. Some deterioration of size can
the requirements of SpecificationA1025, including any supple- be expected in transit.
mentary requirements that are indicated in the purchase order.
6. Chemical Analysis
Failure to comply with the general requirements of Specifica-
tionA1025 constitutes nonconformance with this specification. 6.1 Chemical methods are subject to agreement between the
Incaseofconflictbetweentherequrementsofthisspecification purchaser and supplier.
and Specification A1025, this specification shall prevail. 6.2 Special Analysis Requirements—Analysis for additional
elements other than those listed in Tables 1 and 2 shall be
agreed upon between the purchaser and the manufacturer. Such
This specification is under the jurisdiction of ASTM Committee A01 on Steel,
elements in trace quantities shall be reported as less than “<”
Stainless Steel and Related Alloys and is the direct responsibility of Subcommittee
the limit of analytical equipment. This shall be agreed upon
A01.18 on Castings.
Current edition approved April 1, 2010. Published May 2010. Originally
between the purchaser and the manufacturer.
approved in 1974. Last previous edition approved in 2005 as A701 – 05. DOI:
10.1520
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.