EN 820-1:2002

Advanced technical ceramics - Methods of testing monolithic ceramics - Thermonechanical properties - Part 1: Determination of flexural strength at elevated temperatures

This Part of this European Standard specifies a method of determining the three-point or four-point flexural strength of advanced monolithic technical ceramics at elevated temperatures as agreed between parties to the test. The test can be performed in any appropriate atmosphere.

Hochleistungskeramik - Monolithische Keramik - Thermomechanische Eigenschaften - Teil 1: Bestimmung der Biegefestigkeit bei erhöhten Temperaturen

Dieser Teil von EN 820 legt ein Verfahren zur Bestimmung der Drei Punkt  oder Vier Punkt Biegefestigkeit, je nach Absprache zwischen den Vertragspartnern, von monolithischen keramischen Hochleistungswerkstoffen bei erhöhten Temperaturen fest. Die Prüfung kann in jeder geeigneten Atmosphäre durchgeführt werden.

Céramiques techniques avancées - Méthode d'essai des céramiques monolithiques - Propriétés thermodynamiques - Partie 1: détermnation de la résistance à la flexion à températures élevées

La présente partie de cette Norme européenne spécifie une méthode de détermination de la résistance à la flexion en trois ou quatre points des céramiques techniques avancées de type monolithique aux températures élevées, comme convenu entre les parties concernées par l'essai. Cet essai peut être exécuté dans n'importe quelle atmosphère adéquate.

Advanced technical ceramics - Methods of testing monolithic ceramics - Thermonechanical properties - Part 1: Determination of flexural strength at elevated temperatures

General Information

• Status: Published
• Publication Date: 15-Oct-2002
• ICS: 81.060.30 - Advanced ceramics
• Technical Committee: CEN/TC 184 - Advanced technical ceramics
• Drafting Committee: CEN/TC 184 - Advanced technical ceramics
• Current Stage: 9093 - Decision to confirm - Review Enquiry
• Completion Date: 25-Jun-2019
• Mandate: M/BC/CEN/90/4 - Request concerning the realisation of a standardization programme in the field of advanced technical ceramics
• Ref Project: SIST EN 820-1:2004 - Advanced technical ceramics - Methods of testing monolithic ceramics - Thermonechanical properties - Part 1: Determination of flexural strength at elevated temperatures

Relations

• Replaces: ENV 820-1:1993 - Advanced technical ceramics - Monolithic ceramics - Thermomechanical properties - Part 1: Determination of flexural strength at elevated temperature
• Effective Date: 22-Dec-2008

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 820-1:2004
01-januar-2004
1DGRPHãþD
SIST ENV 820-1:2000
Advanced technical ceramics - Methods of testing monolithic ceramics -
Thermonechanical properties - Part 1: Determination of flexural strength at
elevated temperatures
Advanced technical ceramics - Methods of testing monolithic ceramics -
Thermonechanical properties - Part 1: Determination of flexural strength at elevated
temperatures
Hochleistungskeramik - Monolithische Keramik - Thermomechanische Eigenschaften -
Teil 1: Bestimmung der Biegefestigkeit bei erhöhten Temperaturen
Céramiques techniques avancées - Méthode d'essai des céramiques monolithiques -
Propriétés thermodynamiques - Partie 1: détermnation de la résistance a la flexion a
températures élevées
Ta slovenski standard je istoveten z: EN 820-1:2002
ICS:
81.060.30 Sodobna keramika Advanced ceramics
SIST EN 820-1:2004 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 820-1:2004

---------------------- Page: 2 ----------------------

SIST EN 820-1:2004
EUROPEAN STANDARD
EN 820-1
NORME EUROPÉENNE
EUROPÄISCHE NORM
October 2002
ICS 81.060.30 Supersedes ENV 820-1:1993
English version
Advanced technical ceramics - Methods of testing monolithic
ceramics - Thermonechanical properties - Part 1: Determination
of flexural strength at elevated temperatures
Céramiques techniques avancées - Méthode d'essai des Hochleistungskeramik - Monolithische Keramik -
céramiques monolithiques - Propriétés thermodynamiques Thermomechanische Eigenschaften - Teil 1: Bestimmung
- Détermination de la résistance à la flexion à températures der Biegefestigkeit bei erhöhten Temperaturen
élevées
This European Standard was approved by CEN on 8 August 2002.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official
versions.
CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,
Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2002 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 820-1:2002 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN 820-1:2004
EN 820-1:2002 (E)
Contents
page
Foreword.3
1 Scope .4
2 Normative references .4
3 Terms and definitions.4
4 Apparatus .5
4.1 General.5
4.2 Test jig.5
4.3 Heating device.6
4.4 Test machine .6
4.5 Linear measuring devices.6
4.6 Drying oven .7
5 Test pieces.
...