EN 234:2019
(Main)Wallcoverings in roll form - Specification for wallcoverings for subsequent decoration
Wallcoverings in roll form - Specification for wallcoverings for subsequent decoration
This document:
- specifies requirements for dimensions and marking;
- gives the symbols to be used for marking purposes, for matching, methods of application and removal.
The marking requirements of this document are primarily for information for the consumer and to еnаblе optimum use to be made of the product.
This document applies to wallcoverings for subsequent decoration supplied in rolls for hanging on to walls and ceilings by means of an adhesive, covering the whole of the interface between the wallcovering and the support.
Excluded from this document are rigid materials, materials not attached or not wholly attached by adhesive, finished wallpapers, wall vinyls, plastics wallcoverings, textile wallcoverings, heavy duty wallcoverings and non-decorative wallcoverings such as wall linings or those with special properties, e.g. thermal or acoustic insulation.
Wandbekleidungen in Rollen - Festlegungen für Wandbekleidungen für nachträgliche Behandlung
Dieses Dokument
- legt Anforderungen an die Maße und die Kennzeichnung fest,
- enthält die graphischen Symbole, die für die Kennzeichnung, des Ansatzes und der Verfahren für das Aufbringen und Entfernen zu verwenden sind.
Die in diesem Dokument festgelegten Kennzeichnungen dienen in erster Linie der Verbraucherinformation und sollen die bestmögliche Anwendung des Produktes sicherstellen.
Dieses Dokument gilt für Wandbekleidungen in Rollen für nachträgliche Behandlung, die an Wänden und Decken mittels eines Klebstoffes aufgebracht werden, der die Fläche zwischen Wandbekleidung und Untergrund vollständig bedeckt.
Nicht Gegenstand dieses Dokuments sind starre Stoffe, Stoffe, die nicht oder nicht vollständig angeklebt werden, fertige Papier-, Vinyl und Kunststoffwandbekleidungen, Textilwandbekleidungen, Wand-bekleidungen für hohe Beanspruchungen und Wandbekleidungen, die keine dekorative Funktion haben, z. B. Unterlagsstoffe, sowie Wandbekleidungen mit besonderen Eigenschaften, z. B. zur Wärme oder Schalldämmung.
Revêtements muraux en rouleaux - Spécifications pour revêtements muraux pour décoration ultérieure
Le présent document :
- spécifie les exigences relatives aux dimensions et au marquage ;
- indique les symboles à utiliser pour le marquage, les raccords, les méthodes d’application de l’adhésif et de dépose.
Les exigences de marquage du présent document visent principalement à informer le consommateur et à permettre un usage optimal du produit.
Le présent document s’applique aux revêtements muraux pour décoration ultérieure vendus en rouleaux pour être posés sur les murs et les plafonds à l’aide d’un adhésif couvrant la totalité de l’interface entre le revêtement mural et le subjectile.
Sont exclus du présent document, les matériaux rigides, les matériaux qui ne se fixent pas à l’aide d’adhésif, ou pas sur toute leur surface, les papiers peints finis, les revêtements muraux vinyles, les revêtements muraux en plastique, les revêtements muraux en textiles, les revêtements muraux à usage intense et les revêtements muraux non décoratifs tels que les revêtements d’apprêt, ou ceux qui ont des propriétés particulières, telles que l’isolation acoustique ou thermique.
Stenske obloge v zvitkih - Specifikacija za stenske obloge za poznejšo dekoracijo
Ta evropski standard:
– določa zahteve za dimenzije in označevanje;
– podaja simbole, ki jih treba uporabiti za označevanje, ujemanje, metode nanašanja in odstranjevanja.
Zahteve za označevanje tega standarda služijo predvsem kot informacija za potrošnike omogočajo optimalno uporabo izdelka. Ta standard se uporablja za stenske obloge v zvitkih, ki so namenjene nadaljnjemu okraševanju in se uporabljajo za nanašanje na notranje stene in strop s pomočjo lepila, s katerim se prekrije celotno območje med stensko oblogo in podporno površino. Iz tega standarda so izključeni togi materiali, ki delno ali v celoti niso pritrjeni z lepilom, tapete in stenske obloge iz vinila ter umetne mase, stenske obloge iz blaga, stenske obloge za težke obremenitve in stenske obloge, ki niso namenjene okraševanju ali ki imajo posebne lastnosti, npr. toplotna ali zvočna izolacija.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-februar-2020
Nadomešča:
SIST EN 234:2000
SIST EN 234:2000/A1:2000
SIST EN 234:2000/AC:2001
Stenske obloge v zvitkih - Specifikacija za stenske obloge za poznejšo dekoracijo
Wallcoverings in roll form - Specification for wallcoverings for subsequent decoration
Wandbekleidungen in Rollen - Festlegungen für Wandbekleidungen für nachträgliche
Behandlung
Revêtements muraux en rouleaux - Spécifications pour revêtements muraux pour
décoration ultérieure
Ta slovenski standard je istoveten z: EN 234:2019
ICS:
91.180 Notranja zaključna dela Interior finishing
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EN 234
EUROPEAN STANDARD
NORME EUROPÉENNE
December 2019
EUROPÄISCHE NORM
ICS 91.180 Supersedes EN 234:1989
English Version
Wallcoverings in roll form - Specification for wallcoverings
for subsequent decoration
Revêtements muraux en rouleaux - Spécifications pour Wandbekleidungen in Rollen - Festlegungen für
revêtements muraux pour décoration ultérieure Wandbekleidungen für nachträgliche Behandlung
This European Standard was approved by CEN on 11 June 2019.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2019 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 234:2019 E
worldwide for CEN national Members.
Contents Page
European foreword . 3
Introduction . 4
1 Scope . 5
2 Normative references . 5
3 Terms and definitions . 5
4 Dimensions . 6
4.1 General . 6
4.2 Method of measuring dimensions . 6
4.3 Straightness and parallelity of the edges . 6
5 Spongeability, washability and colour fastness to light . 6
6 Мatching, application, removal and miscellaneous symbols . 6
7 Marking, labelling and packaging . 8
7.1 Visible markings . 8
7.2 Additional markings . 9
7.3 Consistency of marking . 9
Annex A (normative) Sampling for testing . 10
European foreword
This document (EN 234:2019) has been prepared by Technical Committee CEN/TC 99 “Wallcoverings”,
the secretariat of which is held by AFNOR.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by June 2020, and conflicting national standards shall be
withdrawn at the latest by June 2020.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN 234:1989, EN 234:1989/A1:1996 and EN 234:1989/AC:1997.
EN 234:1989/A1:1996 and EN 234:1989/AC:1997:
— Annex B, Method of measuring dimensions: Withdrawn as the reference to EN 12956 was added;
— Annex C, Designation: Withdrawn as requirement is obsolete.
According to the CEN-CENELEC Internal Regulations, the national standards organisations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia,
Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland,
Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Republic of North
Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United
Kingdom.
Introduction
Wallcoverings for subsequent decoration are those wallcoverings intended for decoration after hanging,
for example, by the application of paint. They are normally relief or ingrain wallcoverings. These
wallcoverings do not, in general, have as good washability and colour fastness to light before their
subsequent decoration as have finished wallcoverings which are not intended to be decorated after
hanging.
Related European Standards on the vocabulary and symbols used in the wallcovering industry and for
finished wallpapers, wall vinyls and plastics wallcoverings are also published.
Other European Standards covering textile wallcoverings and heavy duty wallcoverings are in
preparation.
1 Scope
This document:
— specifies requirements for dimensions and marking;
— gives the symbols to be used for marking purposes, for matching, methods of application and
removal.
The marking requirements of this document are primarily for information for the consumer and to еnаblе
optimum use to be made of the product.
This document applies to wallcoverings fo
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.