Small craft - Electrical systems - Alternating and direct current installations (ISO 13297:2020)

This document specifies the requirements for the design, construction and installation of the following types of DC and AC electrical systems, installed on small craft either individually or in combination:
a)   extra-low-voltage direct current (DC) electrical systems that operate at nominal potentials of 50 V DC or less;
b)   single-phase alternating current (AC) systems that operate at a nominal voltage not exceeding AC 250 V.
This document does not cover the following:
—     electrical propulsion systems of direct current less than 1 500 V DC, single-phase alternating current up to 1 000 V AC, and three-phase alternating current up to 1 000 V AC, which are addressed by ISO 16315;
—     any conductor that is part of an outboard engine assembly and that does not extend beyond the outboard engine manufacturers supplied cowling;
—     three-phase AC installations that operate at a nominal voltage not exceeding 500 V AC, which are addressed by IEC 60092-507.

Kleine Wasserfahrzeuge - Elektrische Systeme - Wechselstrom- und Gleichstromanlagen (ISO 13297:2020)

Dieses Dokument legt die Anforderungen für die Auslegung, die Herstellung und die Installation der folgenden Arten von elektrischen Gleich  und Wechselstromanlagen fest, die entweder einzeln oder in Kombination in dem Wasserfahrzeug eingebaut sind:
a)   elektrische Kleinspannungs-Gleichstrom-(DC )Systeme, die mit Nennpotenzialen von bis zu DC 50 V betrieben werden;
b)   einphasige Wechselstrom-(AC )Systeme, die mit einer Spannung betrieben werden, die AC 250 V nicht überschreitet.
Dieses Dokument gilt nicht für:
   elektrische Antriebssysteme mit Gleichstrom von weniger als 1 500 V DC, einphasigem Wechselstrom bis 1 000 V AC und Dreiphasen-Wechselstrom bis 1 000 V AC, die in ISO 16315 behandelt werden;
   Leiter, die Teil einer Außenbordmotor-Anlage sind und nicht über die vom Außenbordmotor-Hersteller gelieferte Motorhaube hinausreichen;
   Dreiphasen-Wechselstromanlagen, die mit einer Nennspannung betrieben werden, die 500 V AC nicht übersteigt, und die in IEC 60092 507 behandelt werden.

Petits navires - Installations électriques - Installations à courant alternatif et continu (ISO 13297:2020)

Le présent document spécifie les exigences concernant la conception, la construction et les installations des types suivants d'installations électriques à courants d.c et a.c. réalisées individuellement ou en combinaison sur les petits navires:
a)    les installations électriques à courant continu à très basse tension (d.c.) qui fonctionnent à des tensions nominales inférieures ou égales à 50 V d.c;
b)    les installations électriques à courant alternatif (a.c.) monophasé qui fonctionnent à une tension nominale ne dépassant pas 250 V a.c.
Le présent document ne couvre pas les éléments suivants:
—          les installations électriques de propulsion à courant continu inférieur à 1 500 V d.c., à courant alternatif monophasé jusqu'à 1 000 V a.c. et à courant alternatif triphasé jusqu'à 1 000 V a.c. qui sont traités par l'ISO 16315;
—          tout conducteur qui fait partie d'un ensemble de moteur hors-bord et qui ne s'étend pas au-delà du capot fourni par le fabricant du moteur hors-bord;
—          les installations électriques triphasées a.c. fonctionnant à une tension nominale ne dépassant pas 500 V c.a. qui sont traitées par l'IEC 60092‑507.

Mala plovila - Električni sistemi - Inštalacije za izmenični in enosmerni tok (ISO 13297:2020)

General Information

Status
Published
Publication Date
13-Apr-2021
Withdrawal Date
30-Oct-2021
Technical Committee
Drafting Committee
Current Stage
6060 - Definitive text made available (DAV) - Publishing
Start Date
14-Apr-2021
Completion Date
14-Apr-2021

Relations

Buy Standard

Standard
EN ISO 13297:2021 - BARVE
English language
42 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN ISO 13297:2021
01-junij-2021
Nadomešča:
SIST EN ISO 10133:2017
SIST EN ISO 13297:2018
Mala plovila - Električni sistemi - Inštalacije za izmenični in enosmerni tok (ISO
13297:2020)
Small craft - Electrical systems - Alternating and direct current installations (ISO
13297:2020)
Kleine Wasserfahrzeuge - Elektrische Systeme - Wechselstrom- und
Gleichstromanlagen (ISO 13297:2020)
Petits navires - Installations électriques - Installations à courant alternatif continu (ISO
13297:2020)
Ta slovenski standard je istoveten z: EN ISO 13297:2021
ICS:
47.020.60 Električna oprema ladij in Electrical equipment of ships
konstrukcij na morju and of marine structures
47.080 Čolni Small craft
SIST EN ISO 13297:2021 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
SIST EN ISO 13297:2021

---------------------- Page: 2 ----------------------
SIST EN ISO 13297:2021


EN ISO 13297
EUROPEAN STANDARD

NORME EUROPÉENNE

April 2021
EUROPÄISCHE NORM
ICS 47.080 Supersedes EN ISO 10133:2017, EN ISO 13297:2018
English Version

Small craft - Electrical systems - Alternating and direct
current installations (ISO 13297:2020)
Petits navires - Installations électriques - Installations Kleine Wasserfahrzeuge - Elektrische Systeme -
à courant alternatif et continu (ISO 13297:2020) Wechselstrom- und Gleichstromanlagen (ISO
13297:2020)
This European Standard was approved by CEN on 6 July 2020.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.





EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2021 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 13297:2021 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
SIST EN ISO 13297:2021
EN ISO 13297:2021 (E)
Contents Page
European foreword . 3
Annex ZA (informative) Relationship between this European Standard and the Essential
Requirements of Directive 2013/53/EU aimed to be covered . 4

2

---------------------- Page: 4 ----------------------
SIST EN ISO 13297:2021
EN ISO 13297:2021 (E)
European foreword
This document (EN ISO 13297:2021) has been prepared by Technical Committee ISO/TC 188 "Small
craft" in collaboration with CCMC.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by October 2021, and conflicting national standards shall
be withdrawn at the latest by October 2021.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN ISO 10133:2017 and EN ISO 13297:2018.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EU Directive(s).
For the relationship with EU Directive(s) see informative Annex ZA, which is an integral part of this
document.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland,
Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Republic of
North Macedonia, Romania, Serbia, Slovakia, Slov
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.