EN 15908:2010

Anaesthetic and respiratory equipment - Non-interchangeable screw-threaded (NIST) low-pressure connectors for medical gases

1.1   This European Standard specifies requirements for connectors intended for use with medical gases.
1.2   This European Standard specifies the dimensions and the allocation of non-interchangeable screw-threaded (NIST) connectors intended to be used at nominal operating pressures not greater than 1 400 kPa.
NOTE   As stated in EN ISO 5359, gas-specific quick-connectors conforming to EN ISO 9170-1 are considered as an alternative to NIST connectors.
1.3   The information to be supplied by the manufacturer is excluded from the scope of this European Standard because information about the use of NIST connectors is supplied by the manufacturer of each medical device to which the connectors are permanently fitted.

Anästhesie- und Beatmungsgeräte - Nichtverwechselbare Verbindungsstücke mit Schraubgewinde (NIST) für niedrigen Druck zur Verwendung mit medizinischen Gasen

1.1   Diese Europäische Norm legt die Anforderungen an Verbindungsstücke zur Verwendung mit medizinischen Gasen fest.
1.2   Diese Europäische Norm legt die Maße und die Zuordnung von nichtverwechselbaren Verbindungsstücken mit Schraubgewinde (NIST) fest, die zur Verwendung bei einem Nenn-Betriebsdruck von nicht mehr als 1 400 kPa vorgesehen sind.
ANMERKUNG   Wie in EN ISO 5359 angegeben, werden gasartspezifische Schnellverbindungsstücke nach EN ISO 9170-1 als Alternative zu NIST-Verbindungsstücken angesehen.
1.3   Die Informationen des Herstellers sind nicht Gegenstand dieser Europäischen Norm, da Informationen über die Anwendung von NIST-Verbindungsstücken vom Hersteller jedes medizinischen Gerätes bereitgestellt werden, an das die Verbindungsstücke fest angebracht sind.

Matériel respiratoire et anesthésique - Raccords basse pression à tête filetée non interchangeables (NIST) pour gaz médicaux

1.1 La présente Norme européenne spécifie les exigences requises pour les raccords destinés à être
utilisés avec les gaz médicaux.
1.2 La présente Norme européenne spécifie les dimensions et l’affectation des raccords à tête filetée non
interchangeables (NIST) destinés à être utilisés sous des pressions nominales de service inférieures ou
égales à 1400 kPa.
NOTE Comme indiqué dans l’EN ISO 5359, les raccords de prise rapide spécifiques à un gaz conformes à
l’EN ISO 9170-1 sont considérés comme une alternative aux raccords NIST.
1.3 Les informations à fournir par le fabricant sont exclues du domaine d’application de la présente Norme
européenne car les informations sur l’utilisation des raccords NIST sont fournies par le fabricant de chaque
appareil médical auquel les raccords sont fixés de manière permanente.

Anestezijska in dihalna oprema - Nizkotlačni priključki z navojem, ki se ne menjajo (NIST)

Ta evropski standard določa zahteve za priključke, namenjene za uporabo pri medicinskih plinih. Ta evropski standard določa mere in dodeljevanje priključkov z navojem, ki se ne menjajo (NIST), namenjenim za uporabo pri nazivnih obratovalnih tlakih, ki ne presegajo 1400 kPa. Informacije, ki jih priskrbi proizvajalec, so izključene iz področja uporabe tega evropskega standarda, ker informacije o uporabi NIST priključkov priskrbi proizvajalec vsake medicinske naprave, na katero so priključki stalno nameščeni.

General Information

• Status: Withdrawn
• Publication Date: 05-Oct-2010
• Withdrawal Date: 17-Jun-2014
• ICS: 11.040.10 - Anaesthetic, respiratory and reanimation equipment
• Technical Committee: CEN/TC 215 - Respiratory and anaesthetic equipment
• Drafting Committee: CEN/TC 215/WG 3 - Medical gas supply systems
• Current Stage: 9960 - Withdrawal effective - Withdrawal
• Completion Date: 18-Jun-2014
• Directive: 2007/47/EC - Directive 2007/47/EC of the European Parliament and of the council of 5 September 2007 amending Council Directive 90/385/EEC on the approximation of the laws of the Member States relating to active implantable medical devices, Council Directive 93/42/EEC concerning medical devices and Directive 98/8/EC concerning the placing of biocidal products on the market
• Directive: 93/42/EEC - Council Directive 93/42/EEC of 14 June 1993 concerning medical devices
• Mandate: M/023 - Standardization mandate to CEN/CENELEC concerning the development of European standards relating to medical devices
• Ref Project: SIST EN 15908:2010 - Anaesthetic and respiratory equipment - Non-interchangeable screw-threaded (NIST) low-pressure connectors for medical gases

Relations

• Replaced By: EN ISO 18082:2014 - Anaesthetic and respiratory equipment - Dimensions of non-interchangeable screw-threaded (NIST) low-pressure connectors for medical gases (ISO 18082:2014)
• Effective Date: 15-Feb-2012

Standards Content (Sample)

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.1,67Anästhesie- und Beatmungsgeräte - Nichtverwechselbare Verbindungsstücke mit Schraubgewinde (NIST) für niedrigen DruckMatériel respiratoire et anesthésique - Raccords à tête filetée non interchangeables (NIST) à basse pression pour gaz médicauxAnaesthetic and respiratory equipment - Non-interchangeable screw-threaded (NIST) low-pressure connectors for medical gases11.040.10Anestezijska, respiratorna in reanimacijska opremaAnaesthetic, respiratory and reanimation equipmentICS:Ta slovenski standard je istoveten z:EN 15908:2010SIST EN 15908:2010en,fr,de01-december-2010SIST EN 15908:2010SLOVENSKI
STANDARD



SIST EN 15908:2010



EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 15908
October 2010 ICS 11.040.10 English Version
Anaesthetic and respiratory equipment - Non-interchangeable screw-threaded (NIST) low-pressure connectors for medical gases
Matériel respiratoire et anesthésique - Raccords basse pression à tête filetée non interchangeables (NIST) pour gaz médicaux
Anästhesie- und Beatmungsgeräte - Nichtverwechselbare Verbindungsstücke mit Schraubgewinde (NIST) für niedrigen Druck zur Verwendung mit medizinischen GasenThis European Standard was approved by CEN on 28 August 2010.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre:
Avenue Marnix 17,
B-1000 Brussels © 2010 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 15908:2010: ESIST EN 15908:2010



FprEN 15908:2010 (E) 2 Contents Page Foreword .3Introduction .41Scope .52Normative references .53Terms and definitions .54General requirements .54.1Safety .54.2Materials .64.3Design, dimensions and allocation of NIST connectors .65Marking . 146Test for durability of markings . 14Annex A (informative)
Environmental aspects . 16Annex ZA (informative)
Relationship between this European Standard and the Essential Requirements of EU Directive 93/42/EEC Medical devices . 17Bibliography . 18
SIST EN 15908:2010



EN 15908:2010 (E) 3 Foreword This document (EN 15908:2010) has been prepared by Technical Committee
...