EN IEC 61810-10:2019

Electromechanical elementary relays - Part 10: Additional functional aspects and safety requirements for high-capacity relays

IEC 61810-10:2019, with functional and safety aspects, applies to electromechanical elementary relays (non-specified time all-or-nothing relays) with high capability requirements like breaking or short circuit capabilities and similar for incorporation into low-voltage equipment. These relays may have a specific design to extinguish the electric arc between contacts (e.g. by magnetic blow-out), or use an insulation coordination not covered by IEC 61810-1 (e.g. by gas filled contact chambers), or require safety assessments not covered by IEC 61810-1 (e.g. for higher loads). It defines additional requirements for high-capacity relays with generic performance intended for use in applications in smart grids, electric vehicles and other applications where, for example, battery charge/discharge switching is used, such as: • electrical energy storage (EES) systems, • solar photovoltaic energy systems, • electric road vehicles (EV) and electric industrial trucks, • power electronic systems and equipment, • secondary cells and batteries, • road vehicles. Compliance with the requirements of this standard is verified by the type tests indicated.

Elektromechanische Elementarrelais - Teil 10: Hochleistungsrelais - Zusätzliche funktionale Aspekte und Sicherheitsanforderungen

Relais électromécaniques élémentaires - Partie 10: Aspects fonctionnels et exigences de sécurité supplémentaires pour les relais à grande capacité

L'IEC 61810-10:2019, qui comporte des aspects fonctionnels et de sécurité, s'applique aux relais électromécaniques élémentaires (relais de tout ou rien à temps non spécifié) dont de grandes capacités sont exigées, telles qu'un pouvoir de coupure ou une capacité de court-circuit et des capacités analogues, destinés à être incorporés dans des matériels basse tension. Ces relais peuvent être conçus de manière spécifique afin d'éteindre les arcs électriques entre des contacts (par exemple, par soufflage magnétique) ou d'utiliser une coordination de l'isolement non couverte par l'IEC 61810-1 (par exemple, chambres de contact remplies de gaz), ou exiger des évaluations de sécurité non couvertes par l'IEC 61810-1 (par exemple, pour des charges supérieures). Elle définit des exigences supplémentaires pour les relais à grande capacité à performances génériques destinés à être utilisés dans des applications dans les réseaux intelligents, dans les véhicules électriques et dans d'autres applications dans lesquelles, par exemple, la commutation charge/décharge de batterie est utilisée, telles que: • systèmes de stockage d'énergie électrique (EES – electrical energy storage), • systèmes d'énergie solaire photovoltaïque, • véhicules électriques routiers (EV – electric vehicle) et chariots électriques de manutention, • systèmes et matériels d'électronique de puissance, • accumulateurs et batteries, • véhicules routiers. La conformité aux exigences de la présente norme est vérifiée par les essais de type indiqués.

Elektromehanski osnovni releji - 10. del: Dodatni funkcionalni vidiki in varnostne zahteve za visoko zmogljive releje

General Information

• Status: Published
• Publication Date: 19-Sep-2019
• Withdrawal Date: 14-Aug-2022
• ICS: 29.120.70 - Relays
• Technical Committee: CLC/SR 94 - All-or-nothing electrical relays
• Drafting Committee: IEC/TC 94 - IEC_TC_94
• Current Stage: 6060 - Document made available - Publishing
• Start Date: 20-Sep-2019
• Completion Date: 20-Sep-2019
• Ref Project: SIST EN IEC 61810-10:2021 - Electromechanical elementary relays - Part 10: Additional functional aspects and safety requirements for high-capacity relays

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN IEC 61810-10:2021
01-junij-2021
Elektromehanski osnovni releji - 10. del: Dodatni funkcionalni vidiki in varnostne
zahteve za visoko zmogljive releje
Electromechanical elementary relays - Part 10: Additional functional aspects and safety
requirements for high-capacity relays
Ta slovenski standard je istoveten z: EN IEC 61810-10:2019
ICS:
29.120.70 Releji Relays
SIST EN IEC 61810-10:2021 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
SIST EN IEC 61810-10:2021

---------------------- Page: 2 ----------------------
SIST EN IEC 61810-10:2021


EUROPEAN STANDARD EN IEC 61810-10

NORME EUROPÉENNE

EUROPÄISCHE NORM
September 2019
ICS 29.120.70

English Version
Electromechanical elementary relays - Part 10: Additional
functional aspects and safety requirements for high-capacity
relays
(IEC 61810-10:2019)
Relais électromécaniques élémentaires - Partie 10: Aspects Elektromechanische Elementarrelais - Teil 10:
fonctionnels et exigences de sécurité supplémentaires pour Hochleistungsrelais - Zusätzliche funktionale Aspekte und
les relais à grande capacité Sicherheitsanforderungen
(IEC 61810-10:2019) (IEC 61810-10:2019)
This European Standard was approved by CENELEC on 2019-08-15. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.



European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2019 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
 Ref. No. EN IEC 61810-10:2019 E

---------------------- Page: 3 ----------------------
SIST EN IEC 61810-10:2021
EN IEC 61810-10:2019 (E)
European foreword
The text of document 94/453/FDIS, future edition 1 of IEC 61810-10, prepared by IEC/TC 94 "All-or-
nothing electrical relays" was submitted to the IEC-CENELEC parallel vote and approved by
CENELEC as EN IEC 61810-10:2019.
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2020-05-15
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2022-08-15
document have to be withdrawn

Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.

Endorsement notice
The text of the International Standard IEC 61810-10:2019 was approved by CENELEC as a European
Standard without any modification.

In the official version, for Bibliography, the following notes have to be added for the standards
indicated:
IEC 60038 NOTE Harmonized as EN 60038
IEC 60060-1 NOTE Harmonized as EN 60060-1
IEC 60068-2-20 NOTE Harmonized as EN 60068-2-20
IEC 60085 NOTE Harmonized as EN 60085
IEC 60364-4-44 NOTE Harmonized as HD 60364-4-444
IEC 60664 (series) NOTE Harmonized as EN 60664 (series)
IEC 60695-2-10 NOTE Harmonized as EN 60695-2-10
IEC 60947-2:2016 NOTE Harmonized as EN 60947-2:2017 (not modified)
IEC 60947-5-1 NOTE Harmonized as EN 60947-5-1
IEC 61210 NOTE Harmonized as EN 61210
IEC 61810-7:2006 NOTE Harmonized as EN 61810-7:2006 (not modified)
IEC 61984 NOTE Harmonized as EN 61984
2

---------------------- Page: 4 ----------------------
SIST EN IEC 61810-10:2021
EN IEC 61810-10:2019 (E)
Annex ZA
(normative)

Normative references to international publications
with their corresponding European publications
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only th
...