EN 61300-2-6:2011

Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-6: Tests - Tensile strength of coupling mechanism

IEC 61300-2-6:2010 describes a test to ensure that the coupling mechanism of a connector set or connector and device combination will withstand the axial loads likely to be applied during normal service. This edition includes the following significant technical changes with respect to the previous edition: - Relaxing pre-conditioning hours; - Adding the recommended severity value table for connectors; - Reconsidering the details to be specified section.

Lichtwellenleiter - Verbindungselemente und passive Bauteile - Grundlegende Prüf- und Messverfahren - Teil 2-6: Prüfungen - Zugfestigkeit der Verriegelung

Dispositifs d'interconnexion et composants passifs à fibres optiques - Méthodes fondamentales d'essais et de mesures - Partie 2-6: Essais - Résistance à la traction du mécanisme de couplage

La CEI 61300-2-6:2010 décrits un essai de vérifier que le mécanisme de couplage d'un jeu de connecteurs ou d'une combinaison de connecteur et de dispositif résistera aux charges axiales susceptibles d'être appliquées dans des conditions normales de fonctionnement. La présente édition inclut les modifications techniques significatives suivantes par rapport à l'édition précédent: - Allègement des heures de préconditionnement; - Ajout du tableau des valeurs de sévérité recommandées pour les connecteurs; - Révision de la section Détails à préciser.

Optični spojni elementi in pasivne komponente - Osnovni preskusni in merilni postopki - 2-6. del: Preskusi - Natezna trdnost spojnega mehanizma (IEC 61300-2-6:2010)

Ta del IEC 61300 opisuje preskus, ki zagotavlja, da bo spojni mehanizem konektorskega sestava ali kombinacije konektorja in naprave prenesel vzdolžne obremenitve, do katerih lahko pride med običajno uporabo.

General Information

• Status: Published
• Publication Date: 07-Apr-2011
• Withdrawal Date: 12-Jan-2012
• ICS: 33.180.20 - Fibre optic interconnecting devices
• Technical Committee: CLC/TC 86BXA - Fibre optic interconnect, passive and connectorised components
• Drafting Committee: IEC/SC 86B - IEC_SC_86B
• Parallel Committee: IEC/SC 86B - IEC_SC_86B
• Current Stage: 6060 - Document made available - Publishing
• Completion Date: 08-Apr-2011
• Ref Project: SIST EN 61300-2-6:2011 - Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-6: Tests - Tensile strength of coupling mechanism (IEC 61300-2-6:2010)

Relations

• Replaces: EN 61300-2-6:1997 - Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-6: Tests - Tensile strength of coupling mechanism
• Effective Date: 29-Jan-2023
• Replaced By: EN IEC 61300-2-6:2024 - Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-6: Tests - Tensile strength of coupling mechanism
• Effective Date: 27-Jan-2023

Standards Content (Sample)

SLOVENSKI STANDARD
01-junij-2011
1DGRPHãþD
SIST EN 61300-2-6:1999
2SWLþQLVSRMQLHOHPHQWLLQSDVLYQHNRPSRQHQWH2VQRYQLSUHVNXVQLLQPHULOQL
SRVWRSNLGHO3UHVNXVL1DWH]QDWUGQRVWVSRMQHJDPHKDQL]PD,(&

Fibre optic interconnecting devices and passive components - Basic test and
measurement procedures - Part 2-6: Tests - Tensile strength of coupling mechanism
(IEC 61300-2-6:2010)
Lichtwellenleiter - Verbindungselemente und passive Bauteile - Grundlegende Prüf- und
Messverfahren - Teil 2-6: Prüfungen - Zugfestigkeit der Verriegelung (IEC 61300-2-
6:2010)
Dispositifs d'interconnexion et composants passifs à fibres optiques - Méthodes
fondamentales d'essais et de mesures - Partie 2-6: Essais - Résistance à la traction du
mécanisme de couplage (CEI 61300-2-6:2010)
Ta slovenski standard je istoveten z: EN 61300-2-6:2011
ICS:
33.180.20 3RYH]RYDOQHQDSUDYH]D Fibre optic interconnecting
RSWLþQDYODNQD devices
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD
EN 61300-2-6
NORME EUROPÉENNE
April 2011
EUROPÄISCHE NORM
ICS 33.180.20 Supersedes EN 61300-2-6:1997

English version
Fibre optic interconnecting devices and passive components -
Basic test and measurement procedures -
Part 2-6: Tests -
Tensile strength of coupling mechanism
(IEC 61300-2-6:2010)
Dispositifs d'interconnexion et composants Lichtwellenleiter -
passifs à fibres optiques - Verbindungselemente und passive
Méthodes fondamentales d'essais et de Bauteile -
mesures - Grundlegende Prüf- und Messverfahren -
Partie 2-6: Essais - Teil 2-6: Prüfungen -
Résistance à la traction du mécanisme de Zugfestigkeit der Verriegelung
couplage (IEC 61300-2-6:2010)
(CEI 61300-2-6:2010)
This European Standard was approved by CENELEC on 2011-01-13. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the Central Secretariat has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy,
Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia,
Spain, Sweden, Switzerland and the United Kingdom.

CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

Management Centre: Avenue Marnix 17, B - 1000 Brussels

© 2011 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 61300-2-6:2011 E
Foreword
The text of document 86B/3092/FDIS, future edition 2 of IEC 61300-2-6, prepared by SC 86B, Fibre optic
interconnecting devices and passive components, of IEC TC 86, Fibre optics, was submitted to the
IEC-CENELEC parallel vote and was approved by CENELEC as EN 61300-2-6 on 2011-01-13.
This European Standard supersedes EN 61300-2-6:1997.
This EN 61300-2-6:2011 includes the following significant technical changes with respect to
EN 61300-2-6:1997:
a) Rewriting of the entire composition according to the latest IEC Directives;
b) Relaxing pre-conditioning hours;
c) Adding the recommended severity value table for connectors;
d) Reconsidering the details to be specified section.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN and CENELEC shall not be held responsible for identifying any or all such patent
rights.
The following dates were fixed:
– latest date by which the EN has to be implemented
at national level by publication of an identical
national standard or by endorsement (dop) 2011-10-13
– latest date by which the national standards conflicting
with the EN have to be withdrawn (dow) 2012-01-13
Annex ZA has been added by CENELEC.
__________
Endorsement notice
The text of the International Standard IEC 61300-2-6:2010 was approved by CENELEC as a European
Standard without any modification.
__________
- 3 - EN 61300-2-6:2011
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications

The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.

NOTE  When an international publication has been modified by common modifications, indicated by (mod), the relevant EN/HD
applies.
Publication Year Title EN/HD Year

IEC 61300-1 - Fibre optic interconnecting devices and EN 61300-1 -
passive components - Basic test and
measurement procedures -
Part 1: General and guidance
IEC 61300-3-1 - Fibre optic interconnecting devices and EN 61300-3-1 -
passive components - Basic test and
measurement procedures -
Part 3-1: Examinations and measurements -
Visual examination
IEC 61753-1 - Fibre optic interconnecting devices and EN 61753-1 -
passive components performance standard -
Part 1: General and guidance for performance
standards
IEC 61300-2-6 ®
Edition 2.0 2010-12
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
Fibre optic interconnecting devices and passive components – Basic test and
measurement procedures –
Part 2-6: Tests – Tensile strength of coupling mechanism

Dispositifs d’interconnexion et composants passifs à fibres optiques –
Méthodes fondamentales d'essais et de mesures –
Partie 2-6: Essais – Résistance à la traction du mécanisme de couplage

INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
PRICE CODE
INTERNATIONALE
H
CODE PRIX
ICS 33.180.20 ISBN 978-2-88912-298-1
– 2 – 61300-2-6 ã IEC:2010
CONTENTS
FOREW ORD . 3
1 Scope . 5
2 Normativ e references . 5
3 General . 5
4 Apparatus . 5
4.1 General . 5
4.2 Force generator . 6
4.3 Force gauge . 6
4.4 Clamping dev ice . 6
4.5 Specimen mount. 6
4.6 Torque wrench . 7
5 Pr o ce d u re . 7
5.1 Prepare specimens . 7
5.2 Pre-conditioning . 7
5.3 Initial examinations and measurements . 7
5.4 Mount DUT. 7
5.5 Apply load . 7
5.6 Final examinations and measurements . 7
6 Severity . 7
7 Details to be specified . 8

Figure 1 – Example of test apparatus . 6

Table 1 – Recommended severity value . 8

61300-2-6 ã IEC:2010 - 3 -
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
FIBRE OPTIC INTERCONNECTING DEVICES
AND PASSIVE COMPONENTS –
BASIC TEST AND MEASUREMENT PROCEDURES –

Part 2-6: Tests – Tensile strength
of coupling mechanism
FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international
co-opera
...