IEC 60335-2-11:2008/AMD1:2012

Amendment 1 - Household and similar electrical appliances - Safety - Part 2-11: Particular requirements for tumble dryers

Amendement 1 - Appareils électrodomestiques et analogues - Sécurité - Partie 2-11: Règles particulières pour les sèche-linge à tambour

General Information

• Status: Published
• Publication Date: 24-Oct-2012
• ICS: 13.120 - Domestic safety
• ICS: 97.060 - Laundry appliances
• Technical Committee: TC 61 - Safety of household and similar electrical appliances
• Current Stage: DELPUB - Deleted Publication
• Completion Date: 15-Apr-2019

Relations

• Amends: IEC 60335-2-11:2008 - Household and similar electrical appliances - Safety - Part 2-11: Particular requirements for tumble dryers
• Effective Date: 05-Sep-2023
• Revised: IEC 60335-2-11:2019 - Household and similar electrical appliances - Safety - Part 2-11: Particular requirements for tumble dryers
• Effective Date: 05-Sep-2023

Standards Content (Sample)

IEC 60335-2-11 ®
Edition 7.0 2012-10
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
colour
inside
AMENDMENT 1
AMENDEMENT 1
Household and similar electrical appliances – Safety –
Part 2-11: Particular requirements for tumble dryers

Appareils électrodomestiques et analogues – Sécurité –
Partie 2-11: Règles particulières pour les sèche-linge à tambour

IEC 60335-2-11:2008/A1:2012
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form

or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from
either IEC or IEC's member National Committee in the country of the requester.
If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication,

please contact the address below or your local IEC member National Committee for further information.

Droits de reproduction réservés. Sauf indication contraire, aucune partie de cette publication ne peut être reproduite ni
utilisée sous quelque forme que ce soit et par aucun procédé, électronique ou mécanique, y compris la photocopie et les

microfilms, sans l'accord écrit de la CEI ou du Comité national de la CEI du pays du demandeur.

Si vous avez des questions sur le copyright de la CEI ou si vous désirez obtenir des droits supplémentaires sur cette

publication, utilisez les coordonnées ci-après ou contactez le Comité national de la CEI de votre pays de résidence.

IEC Central Office Tel.: [phone]
3, rue de Varembé Fax: [phone]
CH-1211 Geneva 20 [e-mail]
Switzerland www.iec.ch
About the IEC
The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes
International Standards for all electrical, electronic and related technologies.

About IEC publications
The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the
latest edition, a corrigenda or an amendment might have been published.

Useful links:
IEC publications search - www.iec.ch/searchpub Electropedia - www.electropedia.org
The advanced search enables you to find IEC publications The world's leading online dictionary of electronic and
by a variety of criteria (reference number, text, technical electrical terms containing more than 30 000 terms and
committee,…). definitions in English and French, with equivalent terms in
It also gives information on projects, replaced and additional languages. Also known as the International
withdrawn publications. Electrotechnical Vocabulary (IEV) on-line.

IEC Just Published - webstore.iec.ch/justpublished Customer Service Centre - webstore.iec.ch/csc
Stay up to date on all new IEC publications. Just Published If you wish to give us your feedback on this publication
details all new publications released. Available on-line and or need further assistance, please contact the
also once a month by email. Customer Service Centre: [e-mail].

A propos de la CEI
La Commission Electrotechnique Internationale (CEI) est la première organisation mondiale qui élabore et publie des
Normes internationales pour tout ce qui a trait à l'électricité, à l'électronique et aux technologies apparentées.

A propos des publications CEI
Le contenu technique des publications de la CEI est constamment revu. Veuillez vous assurer que vous possédez
l’édition la plus récente, un corrigendum ou amendement peut avoir été publié.

Liens utiles:
Recherche de publications CEI - www.iec.ch/searchpub Electropedia - www.electropedia.org
La recherche avancée vous permet de trouver des Le premier dictionnaire en ligne au monde de termes
publications CEI en utilisant différents critères (numéro de électroniques et électriques. Il contient plus de 30 000
référence, texte, comité d’études,…). termes et définitions en anglais et en français, ainsi que
Elle donne aussi des informations sur les projets et les les termes équivalents dans les langues additionnelles.
publications remplacées ou retirées. Egalement appelé Vocabulaire Electrotechnique
International (VEI) en ligne.
Just Published CEI - webstore.iec.ch/justpublished
Service Clients - webstore.iec.ch/csc
Restez informé sur les nouvelles publications de la CEI.
Just Published détaille les nouvelles publications parues. Si vous désirez nous donner des commentaires sur
Disponible en ligne et aussi une fois par mois par email. cette publication ou si vous avez des questions
contactez-nous: [e-mail].
IEC 60335-2-11 ®
Edition 7.0 2012-10
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
colour
inside
AMENDMENT 1
AMENDEMENT 1
Household and similar electrical appliances – Safety –

Part 2-11: Particular requirements for tumble dryers

Appareils électrodomestiques et analogues – Sécurité –

Partie 2-11: Règles particulières pour les sèche-linge à tambour

INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
PRICE CODE
INTERNATIONALE
CODE PRIX G
ICS 13.120; 97.060 ISBN 978-2-83220-432-0

– 2 – 60335-2-11 Amend. 1 © IEC:2012

FOREWORD
This amendment has been prepared by committee 61: Safety of household and similar

electrical appliances.
The text of this amendment is based on the following documents:

FDIS Report on voting
61/4434/FDIS 61/4493/RVD
Full information on the voting for the approval of this amendment can be found in the report
on voting indicated in the above table.
The committee has decided that the contents of this amendment and the base publication will
remain unchanged until the stability date indicated on the IEC web site under
"http://webstore.iec.ch" in the data related to the specific publication. At this date, the
publication will be
• reconfirmed,
• withdrawn,
• replaced by a revised edition, or
• amended.
NOTE The attention of National Committees is drawn to the fact that equipment manufacturers and testing
organizations may need a transitional period following publication of a new, amended or revised IEC publication in
which to make products in accordance with the new requirements and to equip themselves for conducting new or
revised tests.
It is the recommendation of the committee that the content of this publication be adopted for implementation
nationally not earlier than 12 months or later than 36 months from the date of publication.

IMPORTANT – The 'colour inside' logo on the cover page of this publication
indicates that it contains colours which are considered to be useful for the correct
understanding of its contents. Users should therefore print this document using a
colour printer.
_____________
Contents
Replace the title of Clause 3 by the following:
Terms and definitions
Replace the title of Annex CC by the following:
Equipment protection by type of protection "n"

60335-2-11 Amend. 1 © IEC:2012 – 3 –

FOREWORD
In Note 2, replace the title of Annex CC by the following:

Equipment protection by type of protection "n"

3 Definitions
Replace the title of Clause 3 but not the clause number, by the following:

Terms and definitions
Add the following new definition:
3.103
cool down period
final part of the tumble dryer cycle where the drum is continuously rotated with reduced
power to the heating element and with air circulation in order to reduce the possibility of
spontaneous combustion of the clothes load
NOTE Continuous rotation does not mean rotation in same direction if the intended operation is to reverse
direction in normal use.
7 Marking and instructions
7.12 Delete the fifth dashed item from the third paragraph.
11 Heating
11.8 Add the following to the addition:
The exhaust temperature of the air from the drum, measured at the first lint filter after the air
passes the clothes load, shall be measured for the purposes of 22.105.
19 Abnormal operation
19.9 Replace the existing text by the following.

Addition:
The running overload test is carried out on appliances that have overload protective devices
incorporating electronic circuits to protect the windings of the drum motor. However the test is
not carried out if the protective device senses the winding temperature directly.
20 Stability and mechanical hazards
20.101 Delete the last sentence of the requirement.
Add the following new subclause:
20.104 For appliances having a door on a vertical surface with an opening exceeding
200 mm and a drum having a volume exceeding 60 dm , it shall not be possible to start the

– 4 – 60335-2-11 Amend. 1 © IEC:2012

drum motor after closing the door until a separate means which controls the movement of the

drum is operated manually.
NOTE The volume can be calculated from the maximum depth and the maximum inner diameter of the drum.

Compliance is checked by the following test.

The appliance is supplied at rated voltage, and the door is opened and then closed.

If compliance relies on the operation of an electronic circuit, the test is repeated under the

following conditions applied separately:

– the fault conditions in a) to g) of 19.11.2 are applied one at a time to the electronic
circuit;
– the electromagnetic phenomena tests of 19.11.4.2 and 19.11.4.5 are applied to the
appliance.
The drum motor shall not start.
If the electronic circuit is programmable, the software shall contain measures to control the
fault/error conditions specified in Table R1 and is evaluated in accordance with the relevant
requirements of Annex R.
22 Construction
22.104 Replace the requirement by the following:
The operation of protective devices for the heating circuit shall not disable the cool down
period, if any.
Add the following new subclause:
22.105 In order to reduce the risk of spontaneous combustion of the clothes load, the drying
cycle shall conclude with a cool down period to reduce the temperature of the normal
clothes load to a suitable value.
This requirement is not applicable to appliances having a drying cycle air temperature not
exceeding 55 °C.
Compliance is checked by the following test.

The appliance is operated under the conditions in Clause 11 and the exhaust temperature of
the air from the drum shall be measured at the first lint filter after the air passes the clothes
load in the drum.
At end of the cool down period the air temperature shall not exceed 55 °C.
29 Clearances, creepage distances and solid insulation
29.2 Add the following new paragraph
The requirement for a minimum CTI value of 250 is not applicable to functional insulation if
the working voltage does not exceed 50 V.

60335-2-11 Amend. 1 © IEC:2012 – 5 –

Annexes
Add, before Annex AA, the following new Annex R:

Annex R
(normative)
Software evaluation
R.2.2.5 Modification:
For programmable electronic circuits with functions requiring software incorporating
measures to control the fault/error conditions specified in Table R.1 or Table R.2, detection of
a fault/error shall occur before compliance with Clause 19 and with 20.104 is impaired.
R.2.2.9 Modification:
The software and safety-related hardware under its control shall be initialized and shall
terminate before compliance with Clause 19 and with 20.104 is impaired.
Annex BB – Tumble dryers that use a refrigerating system incorporating sealed motor-
compressors for carrying out the drying process
2 Normative references
Replace the existing reference to IEC 60079-15 by the following:
IEC 60079-15:2010, Explosive atmospheres – Part 15: Equipment protection by type of
protection "n"
Add the following new reference:
ISO 7010:2011, Graphical symbols – Safety colours and safety signs – Registered safety
signs
7.6 Replace the existing text by the following:

Symbol ISO 7010 W021 Warning; Risk of fire / Flammable materials

22 Construction
22.205 In the requirement, replace “The insulation” by “For tumble dryers that use
flammable refrigerants, the insulation”

Annex CC
Replace existing Annex CC by the following.

– 6 – 60335-2-11 Amend. 1 © IEC:2012

Annex CC
(normative)
Equipment protection by type of protection "n"

Where reference is made to IEC 60079-15, the following clauses are applicable as modified

below.
11 Supplementary requirements for non-sparking luminaires

All of the subclauses of Clause 11 are applicable, except 11.2.4.1, 11.2.4.5, 11.2.5, 11.2.6,
11.2.7, 11.3.4, 11.3.5, 11.3.6 and 11.4.
16 General supplementary requirements for equipment producing arcs,
sparks or hot surfaces
Clause 16 is applicable.
17 Supplementary requirements for enclosed-break devices and non-incendive
components producing arcs, sparks or hot surfaces
Clause 17 is applicable.
18 Supplementary requirements for hermetically sealed devices producing arcs,
sparks or hot surfaces
Clause 18 is applicable.
19 Supplementary requirements for sealed devices producing arcs, sparks or hot
surfaces
All of the subclauses of Clause 19 are applicable, except 19.1 and 19.6, which are replaced
by the following.
19.1 Non-metallic materials
Seals are tested using 22.5. However if the device is tested in the appliance, then 22.5.1 and
22.5.2 are not applicable. After the tests of Clause 19 in IEC 60335-2-11, by inspection, no
damage that could impair the type of protection shall be evident.
19.6 Type tests
The type tests described in 22.5 shall be performed where relevant.
20 Supplementary requirements for restricted-breathing enclosures protecting
equipment producing arcs, sparks or hot surfaces
Clause 20 is applicable.
60335-2-11 Amend. 1 © IEC:2012 – 7 –

Bibliography
Delete reference to ISO 13732-1.

_____________
– 8 – 603
...