ISO 20602:2019/Amd 1:2021

Ships and marine technology — Check valves for use in low temperature applications — Design and testing requirements — Amendment 1

Navires et technologie maritime — Clapets de retenue destinés aux applications à basse température — Exigences de conception et d'essai — Amendement 1

General Information

• Status: Published
• Publication Date: 09-Dec-2021
• ICS: 47.020.30 - Piping systems
• Technical Committee: ISO/TC 8/SC 3 - Piping and machinery
• Drafting Committee: ISO/TC 8/SC 3 - Piping and machinery
• Current Stage: 6060 - International Standard published
• Start Date: 10-Dec-2021
• Due Date: 30-Oct-2022
• Completion Date: 10-Dec-2021

Relations

• Amends: ISO 20602:2019 - Ships and marine technology — Check valves for use in low temperature applications — Design and testing requirements
• Effective Date: 18-Dec-2021

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 20602
First edition
2019-05
AMENDMENT 1
2021-12
Ships and marine technology — Check
valves for use in low temperature
applications — Design and testing
requirements
AMENDMENT 1
Navires et technologie maritime — Clapets de retenue destinés aux
applications à basse température — Exigences de conception et
d'essai
AMENDEMENT 1
Reference number
ISO 20602:2019/Amd.1:2021(E)
© ISO 2021

---------------------- Page: 1 ----------------------
ISO 20602:2019/Amd.1:2021(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2021
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: [phone]
Email: [e-mail]
Website: www.iso.org
Published in Switzerland
ii
  © ISO 2021 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 20602:2019/Amd.1:2021(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/dir
...