ISO 5768:1996

Cinematography — Image produced by camera aperture Type W on 16 mm motion-picture film — Position and dimensions

Cinématographie — Champ d'image enregistré par caméra type W sur film cinématographique 16 mm — Position et dimensions

General Information

• Status: Withdrawn
• Publication Date: 27-Nov-1996
• Withdrawal Date: 27-Nov-1996
• ICS: 37.060.20 - Motion picture films. Cartridges
• Technical Committee: ISO/TC 36 - Cinematography
• Drafting Committee: ISO/TC 36 - Cinematography
• Current Stage: 9599 - Withdrawal of International Standard
• Completion Date: 03-Dec-1998

Relations

• Revised: ISO 5768:1998 - Cinematography — Image produced by camera aperture Type W on 16 mm motion-picture film — Position and dimensions
• Effective Date: 15-Apr-2008
• Revises: ISO 5768:1981 - Cinematography — Image produced by camera aperture Type W on 16 mm motion-picture film — Position and dimensions
• Effective Date: 15-Apr-2008

Standards Content (Sample)

I NTE R NAT1 ONAL
IS0
STANDARD 5768
Second edition
1996-1 2-01
Cinematography - Image produced by
camera aperture Type W on 16 mm
motion-picture film - Position and
dimensions
Cinématographie - Champ d'image enregistré par caméra type W sur film
cinématographique 16 mm - Position et dimensions
Reference number
IS0 5768:1996(E)

---------------------- Page: 1 ----------------------
IS0 5768:1996(E)
Foreword
IS0 (the International Organization for Standardization) is a worldwide
federation of national standards bodies (IS0 member bodies). The work of
preparing International Standards is normally carried out through IS0
technical committees. Each member body interested in a subject for
which a technical committee has been established has the right to be
represented on that committee. International organizations, governmental
and non-governmental, in liaison with ISO, also take part in the work. IS0
collaborates closely with the International Electrotechnical Commission
(IEC) on all matters of electrotechnical standardization.
Draft International Standards adopted by the technical committees are
circulated to the member bodies for voting. Publication as an International
Standard requires approval by at least 75 % of the member bodies casting
a vote.
International Standard IS0 5768 was prepared by Technical Committee
lSO/TC 36, Cinematography.
This second edition cancels and replaces the first edition (IS0 5768:1981),
of which it constitutes a technical revision.
Annexes A and B of this International Standard are for information only.
O IS0 1996
All rights reserved Unless otherwise specified, no part of this publication may be
reproduced or utilized in any form or by any means, electronic or mechanical, including
photocopying and microfilm, without permission in writing from the publisher
International Organization for Standardization
Case Postale 56 CH-1 21 1 Genève 20 Switzerland
Printed in Switzerland
Il

---------------------- Page: 2 ----------------------
INTERNATIONAL STANDARD 0 IS0 IS0 5768:1996(E)
Cinematography - Image produced by camera aperture
Type W on 16 mm motion-picture film - Position and
dimensions
1 Scope
This International Standard specifies the dimensions and location of the image area produced by the camera
aperture Type W on 16 mm motion-picture film intended for enlargement to non-anamorphic 35 mm motion-picture
film with an image aspect ratio of 1,66:1 or greater.
L
This International Standard also specifies the dimensions and location of the corresponding image area on a 35 mm
internegative or duplicate negative and the enlargement ratio in optical printing from 16 mm Type W originals.
2 Dimensions
The dimensions shall be as given in figures 1 and 2 and tables 1 and 2.
NOTE - Inch dimensions reflect the practice in those countries using the Imperial system of measurement
Centre of intended image
area and optical axis
A
\
Direction of
tilm travel
L
IQ
I
.
0
NOTE - The film IS shown as seen from the inside of the camera loo
...