ISO 16300-2:2019
(Main)Automation systems and integration — Interoperability of capability units for manufacturing application solutions — Part 2: Capability templates and software unit cataloguing
Automation systems and integration — Interoperability of capability units for manufacturing application solutions — Part 2: Capability templates and software unit cataloguing
This document specifies a set of template definitions to describe the capability of a software unit of an automation solution that can be mapped to the functional requirements of a target manufacturing application. This document specifies how to develop and manage a software unit catalogue in terms of capability properties and defines mapping rules from capability profiles to a software unit catalogue.
Systèmes d'automatisation et intégration — Interopérabilité des unités de capacité pour les solutions d'applications industrielles — Partie 2: Modèles de capacités et cataloguage des unités logicielles
General Information
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 16300-2
First edition
2019-04
Automation systems and
integration — Interoperability of
capability units for manufacturing
application solutions —
Part 2:
Capability templates and software unit
cataloguing
Systèmes d'automatisation et intégration — Interopérabilité des
unités de capacité pour les solutions d'applications industrielles —
Partie 2: Modèles de capacités et cataloguage des unités logicielles
Reference number
ISO 16300-2:2019(E)
©
ISO 2019
---------------------- Page: 1 ----------------------
ISO 16300-2:2019(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2019
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2019 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 16300-2:2019(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Overview of software unit catalogue . 3
4.1 Capability profiling defined in the ISO 16100 series . 3
4.2 Objectives of the software unit catalogue . 5
5 Software unit catalogue and software capability description dictionary .7
6 Procedure for software unit cataloguing . 8
6.1 Overall procedure of software unit cataloguing . 8
6.2 Capability profiling using software unit catalogue . 9
Annex A (informative) Capability element template .13
Bibliography .15
© ISO 2019 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO 16300-2:2019(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.