Rubber — Analysis by pyrolytic gas-chromatographic methods — Part 1: Identification of polymers (single polymers and polymer blends) — Amendment 1

Caoutchouc — Méthodes d'analyse par pyrolyse et chromatographie en phase gazeuse — Partie 1: Identification des polymères (un seul polymère ou un mélange de polymères) — Amendement 1

General Information

Status
Withdrawn
Publication Date
04-Jul-2010
Withdrawal Date
04-Jul-2010
Current Stage
9599 - Withdrawal of International Standard
Start Date
11-Feb-2020
Completion Date
11-Feb-2020
Ref Project

RELATIONS

Buy Standard

Standard
ISO 7270-1:2003/Amd 1:2010
English language
2 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (sample)

INTERNATIONAL ISO
STANDARD 7270-1
First edition
2003-04-15
AMENDMENT 1
2010-07-15
Rubber — Analysis by pyrolytic gas-
chromatographic methods —
Part 1:
Identification of polymers (single
polymers and polymer blends)
AMENDMENT 1
Caoutchouc — Méthodes d'analyse par pyrolyse et chromatographie en
phase gazeuse —
Partie 1: Identification des polymères (un seul polymère ou un mélange
de polymères)
AMENDEMENT 1
Reference number
ISO 7270-1:2003/Amd.1:2010(E)
ISO 2010
---------------------- Page: 1 ----------------------
ISO 7270-1:2003/Amd.1:2010(E)
PDF disclaimer

This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but

shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In

downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat

accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.

Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation

parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In

the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.

COPYRIGHT PROTECTED DOCUMENT
© ISO 2010

All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,

electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or

ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2010 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 7270-1:2003/Amd.1:2010(E)
Foreword

ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies

(ISO member bodies). The work of preparing International Standards is normally carried out through ISO

technical committees. Each member body interested in a subject for which a technical committee has been

established has the right to be represented on that committee. International organizations, governmental and

non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the

International Electrotechnical Commission (IEC) on all matters of electrotechnical standardiza

...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.