ISO 14828:2003/Amd 1:2010

Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the long-term specific ring relaxation stiffness under wet conditions and calculation of the wet relaxation factor — Amendment 1

Tubes en plastiques thermodurcissables renforcés de verre (PRV) — Détermination de la rigidité annulaire spécifique à long terme en relaxation, en conditions mouillées, et calcul du facteur de relaxation au mouillé — Amendement 1

General Information

• Status: Withdrawn
• Publication Date: 18-Aug-2010
• Withdrawal Date: 18-Aug-2010
• ICS: 23.040.20 - Plastics pipes
• Technical Committee: ISO/TC 138/SC 6 - Reinforced plastics pipes and fittings for all applications
• Drafting Committee: ISO/TC 138/SC 6/WG 1 - Methods of test
• Current Stage: 9599 - Withdrawal of International Standard
• Completion Date: 18-Apr-2016

Relations

• Amends: ISO 14828:2003 - Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the long-term specific ring relaxation stiffness under wet conditions and calculation of the wet relaxation factor
• Effective Date: 14-Aug-2021

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 14828
First edition
2003-12-01
AMENDMENT 1
2010-09-01

Glass-reinforced thermosetting plastics
(GRP) pipes — Determination of the long-
term specific ring relaxation stiffness
under wet conditions and calculation of
the wet relaxation factor

AMENDMENT 1
Tubes en plastiques thermodurcissables renforcés de verre (PRV) —
Détermination de la rigidité annulaire spécifique à long terme en
relaxation, en conditions mouillées, et calcul du facteur de relaxation au
mouillé

AMENDEMENT 1




Reference number
ISO 14828:2003/Amd.1:2010(E)
©
ISO 2010

---------------------- Page: 1 ----------------------
ISO 14828:2003/Amd.1:2010(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.


COPYRIGHT PROTECTED DOCUMENT


©  ISO 2010
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [e-mail]
Web www.iso.org
Published in Switzerland

ii © ISO 2010 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 14828:2003/Amd.1:2010(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subjec
...