ISO 3616:2001/Amd 1:2017

Textile glass — Chopped-strand and continuous-filament mats — Determination of average thickness, thickness under load and recovery after compression — Amendment 1

Verre textile — Mats à fils coupés et mats à fils continus — Détermination de l'épaisseur moyenne, de l'épaisseur sous charge et de la recouvrance après compression — Amendement 1

General Information

• Status: Withdrawn
• Publication Date: 13-Aug-2017
• ICS: 59.100.10 - Textile glass materials
• Technical Committee: ISO/TC 61/SC 13 - Composites and reinforcement fibres
• Drafting Committee: ISO/TC 61/SC 13/WG 1 - Reinforcements and reinforcement products
• Current Stage: 9599 - Withdrawal of International Standard
• Completion Date: 19-Dec-2022

Relations

• Amends: ISO 3616:2001 - Textile glass — Chopped-strand and continuous-filament mats — Determination of average thickness, thickness under load and recovery after compression
• Effective Date: 23-Apr-2020
• Revised: ISO 3616:2022 - Textile glass — Chopped-strand and continuous-filament mats — Determination of average thickness, thickness under load and recovery after compression
• Effective Date: 06-Jun-2022

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 3616
Second edition
2001-04-01
AMENDMENT 1
2017-08
Textile glass — Chopped-strand
and continuous-filament mats —
Determination of average thickness,
thickness under load and recovery
after compression
AMENDMENT 1
Verre textile — Mats à fils coupés et mats à fils continus —
Détermination de l’épaisseur moyenne, de l’épaisseur sous charge et
de la recouvrance après compression
AMENDEMENT 1
Reference number
ISO 3616:2001/Amd.1:2017(E)
©
ISO 2017

---------------------- Page: 1 ----------------------
ISO 3616:2001/Amd.1:2017(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2017, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. [phone]
Fax [phone]
[e-mail]
www.iso.org
ii © ISO 2017 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 3616:2001/Amd.1:2017(E)

Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the
different types of ISO documents should be noted. This document was d
...