ISO 17387:2008

Intelligent transport systems — Lane change decision aid systems (LCDAS) — Performance requirements and test procedures

ISO 17387:2008 specifies system requirements and test methods for Lane Change Decision Aid Systems (LCDAS). LCDAS are fundamentally intended to warn the driver of the subject vehicle against potential collisions with vehicles to the side and/or to the rear of the subject vehicle, and moving in the same direction as the subject vehicle during lane change manoeuvres. This standardization addresses LCDAS for use on forward moving cars, vans and straight trucks in highway situations.

Systèmes intelligents de transport — Systèmes d'aide à la décision de changement de voie — Exigences de performances et méthodes d'essai

General Information

• Status: Published
• Publication Date: 15-Apr-2008
• ICS: 03.220.20 - Road transport
• ICS: 35.240.60 - IT applications in transport
• Technical Committee: ISO/TC 204 - Intelligent transport systems
• Drafting Committee: ISO/TC 204/WG 14 - Vehicle/roadway warning and control systems
• Current Stage: 9092 - International Standard to be revised
• Completion Date: 31-Oct-2023

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 17387
First edition
2008-05-01

Intelligent transport systems — Lane
change decision aid systems (LCDAS) —
Performance requirements and test
procedures
Systèmes intelligents de transport — Systèmes d'aide à la décision de
changement de voie — Exigences de performances et méthodes
d'essai




Reference number
ISO 17387:2008(E)
©
ISO 2008

---------------------- Page: 1 ----------------------
ISO 17387:2008(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.


COPYRIGHT PROTECTED DOCUMENT


©  ISO 2008
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [e-mail]
Web www.iso.org
Published in Switzerland

ii © ISO 2008 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 17387:2008(E)
Contents Page
Foreword. iv
Introduction . v
1 Scope . 1
2 Terms and definitions. 1
3 Classification. 4
3.1 Coverage zone classification . 4
3.2 Target vehicle closing speed classification. 5
4 Functional requirements. 8
4.1 LCDAS state diagram . 8
4.2 System performance . 10
4.3 User interface. 15
4.4 Operation with trailers. 16
4.5 Self-test requirements. 16
5 Test requirements. 16
5.1 Test target vehicle . 16
5.2 Environmental conditions. 16
5.3 Blind spot warning test requirements . 16
5.4 Closing vehicle warning test requirements . 24
5.5 Lane change warning test requirements. 29
Annex A (informative) Blind spot warning example cases .
...