ISO 80000-9:2009/Amd 1:2011
(Amendment)Quantities and units — Part 9: Physical chemistry and molecular physics — Amendment 1
Quantities and units — Part 9: Physical chemistry and molecular physics — Amendment 1
ISO 80000-9 gives names, symbols, and definitions for quantities and units of physical chemistry and molecular physics. Where appropriate, conversion factors are also given.
Grandeurs et unités — Partie 9: Chimie physique et physique moléculaire — Amendement 1
Veličine in enote - 9. del: Fizikalna kemija in molekulska fizika - Dopolnilo 1
Standard ISO 80000-9 podaja imena, simbole in definicije za veličine in enote s področja fizikalne kemije in molekulske fizike. Kjer je primerno, so navedeni tudi pretvorniki (pretvorni dejavniki).
General Information
Relations
Buy Standard
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 80000-9
First edition
2009-04-01
AMENDMENT 1
2011-06-01
Quantities and units —
Part 9:
Physical chemistry and molecular
physics
AMENDMENT 1
Grandeurs et unités —
Partie 9: Chimie physique et physique moléculaire
AMENDEMENT 1
Reference number
ISO 80000-9:2009/Amd.1:2011(E)
©
ISO 2011
---------------------- Page: 1 ----------------------
ISO 80000-9:2009/Amd.1:2011(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2011
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2011 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 80000-9:2009/Amd.1:2011(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
Amendment 1 to ISO 80000-9:2009 was prepared by Technical Committee ISO/TC 12, Quantities and units,
in collaboration with IEC/TC 25, Quantities and units.
© ISO 2011 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO 80000-9:2009/Amd.1:2011(E)
Quantities and units —
...
NORME ISO
INTERNATIONALE 80000-9
Première édition
2009-04-01
AMENDEMENT 1
2011-06-01
Grandeurs et unités —
Partie 9:
Chimie physique et physique moléculaire
AMENDEMENT 1
Quantities and units —
Part 9: Physical chemistry and molecular physics
AMENDMENT 1
Numéro de référence
ISO 80000-9:2009/Amd.1:2011(F)
©
ISO 2011
---------------------- Page: 1 ----------------------
ISO 80000-9:2009/Amd.1:2011(F)
DOCUMENT PROTÉGÉ PAR COPYRIGHT
© ISO 2011
Droits de reproduction réservés. Sauf prescription différente, aucune partie de cette publication ne peut être reproduite ni utilisée sous
quelque forme que ce soit et par aucun procédé, électronique ou mécanique, y compris la photocopie et les microfilms, sans l'accord écrit
de l'ISO à l'adresse ci-après ou du comité membre de l'ISO dans le pays du demandeur.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Publié en Suisse
ii © ISO 2011 – Tous droits réservés
---------------------- Page: 2 ----------------------
ISO 80000-9:2009/Amd.1:2011(F)
Avant-propos
L'ISO (Organisation internationale de normalisation) est une fédération mondiale d'organismes nationaux de
normalisation (comités membres de l'ISO). L'élaboration des Normes internationales est en général confiée
aux comités techniques de l'ISO. Chaque comité membre intéressé par une étude a le droit de faire partie du
comité technique créé à cet effet. Les organisations internationales, gouvernementales et non
gouvernementales, en liaison avec l'ISO participent également aux travaux. L'ISO collabore étroitement avec
la Commission électrotechnique internationale (CEI) en ce qui concerne la normalisation électrotechnique.
Les Normes internationales sont rédigées conformément aux règles données dans les Directives ISO/CEI,
Partie 2.
La tâche principale des comités techniques est d'élaborer les Normes internationales. Les projets de Normes
internationales adoptés par les comités techniques sont soumis aux comités membres pour vote. Leur
publication comme Normes internationales requiert l'approbation de 75 % au moins des comités membres
votants.
L'attention est appelée sur le fait que certains des éléments du présent document peuvent faire l'objet de
droits de propriété intellectuelle ou de droits analogues. L'ISO ne saurait être tenue pour responsable de ne
pas avoir identifié de tels droits de propriété et averti de leur existence.
L'Amendement 1 à l'ISO 80000-9:2009 a été élaboré par le comité technique ISO/TC 12, Grandeurs et unités,
en collaboration avec le comité d'études CEI/CE 25, Grandeurs et unités.
© ISO 2011 – Tous droits réservés iii
----------------------
...
SIST ISO 80000-9:2013/A1
SLOVENSKI
STANDARD
oktober 2013
Veličine in enote – 9. del: Fizikalna kemija in molekulska fizika –
Dopolnilo 1
Quantities and units – Part 9: Physical chemistry and molecular physics –
Amendment 1
Grandeurs et unités – Partie 9: Chimie physique et physique moléculaire –
Amendement 1
Referenčna oznaka
ICS 01.060; 07.030 SIST ISO 80000-9:2013/A1:2013(sl)
Nadaljevanje na straneh od 2 do 5
© 2013-10: Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST ISO 80000-9:2013/A1 : 2013
NACIONALNI UVOD
Dopolnilo k standardu SIST ISO 80000-9 (sl), Veličine in enote – 9. del: Fizikalna kemija in molekulska
fizika, 2013, ima status slovenskega dopolnila in je enakovredno mednarodnemu dopolnilu
ISO 80000-9 (en), Quantities and units – Part 9: Physical chemistry and molecular physics –
Amendment 1, 2011-06.
NACIONALNI PREDGOVOR
Dopolnilo ISO 80000-9:2009/Amd.1:2011 je pripravil tehnični odbor ISO/TC 12 Veličine, enote, simboli
v sodelovanju z IEC/TC 25 Veličine in enote.
Slovensko dopolnilo SIST ISO 80000-9:2013/A1:2013 je prevod mednarodnega dopolnila
ISO 80000-9:2009/Amd.1:2011. V primeru spora glede besedila slovenskega prevoda v tem dopolnilu
je odločilno izvirno mednarodno dopolnilo v angleškem jeziku. Slovensko izdajo dopolnila je pripravil
tehnični odbor SIST/TC TRS Tehnično risanje, veličine, enote, simboli in grafični simboli.
OPOMBA
– Nacionalni uvod in nacionalni predgovor nista sestavni del dopolnila.
2
---------------------- Page: 2 ----------------------
SIST ISO 80000-9:2013/A1 : 2013
Predgovor
ISO (Mednarodna organizacija za standardizacijo) je svetovna zveza nacionalnih organov za
standarde (članov ISO). Mednarodne standarde navadno pripravljajo tehnični odbori ISO. Vsak član,
ki želi delovati na določenem področju, za katero je bil ustanovljen tehnični odbor, ima pravico biti
zastopan v tem odboru. Pri delu sodelujejo tudi vladne in nevladne mednarodne organizacije,
povezane z ISO. V vseh zadevah, ki so povezane s standardizacijo na področju elektrotehnike, ISO
tesno sodeluje z Mednarodno elektrotehniško komisijo (IEC).
Mednarodni standardi so pripravljeni v skladu s pravili, podanimi v Direktivah ISO/IEC, 2. del.
Glavna naloga tehničnih odborov je priprava mednarodnih standardov. Osnutki mednarodnih
standardov, ki jih sprejmejo tehnični odbori, se pošljejo vsem članom v glasovanje. Za objavo
mednarodnega standarda je treba pridobiti soglasje najmanj 75 % članov,
...
SLOVENSKI STANDARD
SIST ISO 80000-9:2013/A1:2013
01-oktober-2013
9HOLþLQHLQHQRWH GHO )L]LNDOQDNHPLMDLQPROHNXOVNDIL]LND'RSROQLOR
Quantities and units - Part 9: Physical chemistry and molecular physics - Amendment 1
Grandeurs et unités - Partie 9: Chimie physique et physique moléculaire - Amendement
1
Ta slovenski standard je istoveten z: ISO 80000-9:2009/Amd 1:2011
ICS:
01.060 9HOLþLQHLQHQRWH Quantities and units
07.030 Fizika. Kemija Physics. Chemistry
SIST ISO 80000-9:2013/A1:2013 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST ISO 80000-9:2013/A1:2013
---------------------- Page: 2 ----------------------
SIST ISO 80000-9:2013/A1:2013
INTERNATIONAL ISO
STANDARD 80000-9
First edition
2009-04-01
AMENDMENT 1
2011-06-01
Quantities and units —
Part 9:
Physical chemistry and molecular
physics
AMENDMENT 1
Grandeurs et unités —
Partie 9: Chimie physique et physique moléculaire
AMENDEMENT 1
Reference number
ISO 80000-9:2009/Amd.1:2011(E)
©
ISO 2011
---------------------- Page: 3 ----------------------
SIST ISO 80000-9:2013/A1:2013
ISO 80000-9:2009/Amd.1:2011(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2011
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2011 – All rights reserved
---------------------- Page: 4 ----------------------
SIST ISO 80000-9:2013/A1:2013
ISO 80000-9:2009/Amd.1:2011(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this docume
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.