ISO 21717:2018
(Main)Intelligent transport systems — Partially Automated In-Lane Driving Systems (PADS) — Performance requirements and test procedures
Intelligent transport systems — Partially Automated In-Lane Driving Systems (PADS) — Performance requirements and test procedures
This document contains the basic control strategy, minimum functionality requirements, basic driver interface elements, minimum requirements for diagnostics and reaction to failure, and performance test procedures for Partially Automated In-Lane Driving Systems (PADS). This document is applicable to passenger cars, commercial vehicles and buses. It is not applicable to automated driving systems of level 3 or higher (as defined in SAE J3016:2016).
Titre manque
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 21717
First edition
2018-09
Intelligent transport systems —
Partially Automated In-Lane Driving
Systems (PADS) — Performance
requirements and test procedures
Reference number
ISO 21717:2018(E)
©
ISO 2018
---------------------- Page: 1 ----------------------
ISO 21717:2018(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2018
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2018 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 21717:2018(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Symbols . 3
5 Requirements for longitudinal control . 3
6 Requirements . 3
6.1 Functionality . 3
6.1.1 off state . 4
6.1.2 stand-by state . 4
6.1.3 active state . 4
6.1.4 longit state . 4
6.1.5 longit-lat state . 4
6.2 Basic driver interface and intervention capabilities . 5
6.2.1 General. 5
6.2.2 Operation elements and system reactions . 5
6.2.3 Display elements . 5
6.2.4 Driver monitoring . 5
6.2.5 Symbols .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.