Resilient floor coverings - Specification for plain and decorative linoleum

This European Standard specifies the characteristics of plain and decorative linoleum, supplied as either tiles or rolls.
To encourage the consumer to make an informed choice, the standard includes a classification system based on intensity of use, which shows where resilient floor coverings should give satisfactory service (see EN 685). It also includes requirements for marking.
The term 'linoleum' is frequently incorrectly applied to a range of floor coverings, often to those based on polyvinyl chloride or rubber. Such materials are not included in this standard.

Elastische Bodenbeläge - Spezifikation für Linoleum mit und ohne Muster

Diese Europäische Norm legt die Eigenschaften von Linoleum mit und ohne Muster fest, das entweder in Form von Platten oder auch als Rollen geliefert wird. Um den Verbraucher bei seiner Auswahl zu unterstützen, enthält diese Norm ein Klassifizierungssystem (siehe EN 685) auf Basis der Nutzungsintensität, das zeigt, wo für diese Bodenbeläge ein zufriedenstellender Nutzen möglich wäre. Die Norm legt auch die Bedingungen zur Kennzeichnung fest. Der Begriff „Linoleum“ wird häufig fälschlicherweise auch für andere Bodenbeläge, oft für solche auf Basis von Polyvinylchlorid oder Elastomeren, verwendet. Derartige Materialien sind nicht in dieses Dokument eingeschlossen.

Revêtements de sol résilients - Spécification pour le linoléum uni et décoratif

La présente Norme européenne prescrit les caractéristiques du linoléum uni et décoratif sous forme de rouleaux ou de dalles.
Pour aider le consommateur à faire son choix, la présente norme inclut un système de classification basé sur l'intensité d'utilisation, indiquant l'endroit où le revêtement de sol résilient rendrait un service satisfaisant (voir l’EN 685). Elle comprend également des exigences relatives au marquage.
Le terme « linoléum » est fréquemment appliqué de manière incorrecte à une gamme de revêtements de sol, souvent à base de polychlorure de vinyle ou de caoutchouc. Such materials are not included in this standard.

Netekstilne talne obloge - Specifikacija za linolej z vzorcem in brez njega

Ta evropski standard določa značilnosti linoleja z vzorcem ali brez njega, dostavljenega v obliki plošč ali zvitka.
Da bi ta evropski standard potrošnike spodbujal k sprejemanju utemeljenih odločitev, vsebuje klasifikacijski sistem, ki temelji na intenzivnosti uporabe, ki kaže, kje bi se te netekstilne talne obloge lahko zadovoljivo uporabljale (glej EN 685). Vključuje tudi zahteve za označevanje.
Izraz »linolej« se večkrat nepravilno uporablja za različne talne obloge, pogosto za talne obloge na osnovi polivinilklorida ali gume. Taki materiali niso vključeni v ta standard.

General Information

Status
Withdrawn
Public Enquiry End Date
24-Nov-2010
Publication Date
10-Oct-2011
Withdrawal Date
21-Mar-2012
Current Stage
9900 - Withdrawal (Adopted Project)
Start Date
21-Mar-2012
Due Date
13-Apr-2012
Completion Date
22-Mar-2012

Relations

Buy Standard

Standard
EN 548:2011
English language
10 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day
Draft
k FprEN 548:2010
English language
10 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 548:2011
01-november-2011
1DGRPHãþD
SIST EN 548:2005
SIST EN 548:2005/AC:2007
SIST EN 548:2005/AC:2008
Netekstilne talne obloge - Specifikacija za linolej z vzorcem in brez njega
Resilient floor coverings - Specification for plain and decorative linoleum
Elastische Bodenbeläge - Spezifikation für Linoleum mit und ohne Muster
Revêtements de sol résilients - Spécification pour le linoléum uni et décoratif
Ta slovenski standard je istoveten z: EN 548:2011
ICS:
97.150 Netekstilne talne obloge Non-textile floor coverings
SIST EN 548:2011 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 548:2011

---------------------- Page: 2 ----------------------

SIST EN 548:2011


EUROPEAN STANDARD
EN 548

NORME EUROPÉENNE

EUROPÄISCHE NORM
March 2011
ICS 97.150 Supersedes EN 548:2004
English Version
Resilient floor coverings - Specification for plain and decorative
linoleum
Revêtements de sol résilients - Spécifications pour le Elastische Bodenbeläge - Spezifikation für Linoleum mit
linoléum uni et décoratif und ohne Muster
This European Standard was approved by CEN on 6 February 2011.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same
status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.





EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2011 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 548:2011: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN 548:2011
EN 548:2011 (E)
Contents Page
Foreword .3
1 Scope .4
2 Normative references .4
3 Terms and definitions .4
4 Identification .5
5 Requirements .5
5.1 General requirements .5
5.2 Classification requirements .6
6 Marking .8
Annex A (informative) Optional properties .9
Bibliography . 10

2

---------------------- Page: 4 ----------------------

SIST EN 548:2011
EN 548:2011 (E)
Foreword
This document (EN 548:2011) has been prepared by Technical Committee CEN/TC 134 “Resilient, textile and
laminate floor coverings”, the secretariat of which is held by BSI.
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by September 2011, and conflicting national standards shall be
withdrawn at the latest by September 2011.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN 548:2004.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EU Directive(s).
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech
Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain,
Sweden, Switzerland and the United Kingdom.
3

---------------------- Page: 5 ----------------------

SIST EN 548:2011
EN 548:2011 (E)
1 Scope
This European Standard specifies the characteristics of plain and decorative linoleum, supplied as either tiles
or rolls.
To encourage the consumer to make an informed choice, the standard includes a classification system based
on intensity of use, which shows where resilient floor coverings should give satisfactory service (see EN 685).
It also includes requirements for marking.
The term 'linoleum' is frequently incorrectly applied to a range of floor coverings, often to those based on
polyvinyl chloride or rubber. Such materials are not included in this standard.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.
EN 425, Resilient and laminate floor coverings — Castor chair test
EN 426, Resilient floor coverings — Determination of width, length, straightness and flatness of sheet material
EN 427, Resilient floor coverings — Determination of the side length, squareness and straightness of tiles
EN 428, Resilient floor coverings — Determination of overall thickness
EN 429, Resilient floor coverings — Determination of the thickness of lay
...

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Netekstilne talne obloge - Specifikacija za linolej brez vzorca in z vzorcemElastische Bodenbeläge - Spezifikation für Linoleum mit und ohne MusterRevêtements de sol résilients - Spécification pour le linoléum uni et décoratifResilient floor coverings - Specification for plain and decorative linoleum97.150Netekstilne talne oblogeNon-textile floor coveringsICS:Ta slovenski standard je istoveten z:FprEN 548kSIST FprEN 548:2010en,fr,de01-november-2010kSIST FprEN 548:2010SLOVENSKI
STANDARD



kSIST FprEN 548:2010



EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
FINAL DRAFT
FprEN 548
August 2010 ICS 97.150 Will supersede EN 548:2004English Version
Resilient floor coverings - Specification for plain and decorative linoleum
Revêtements de sol résilients - Spécification pour le linoléum uni et décoratif
Elastische Bodenbeläge - Spezifikation für Linoleum mit und ohne Muster This draft European Standard is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee CEN/TC 134.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre:
Avenue Marnix 17,
B-1000 Brussels © 2010 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. FprEN 548:2010: EkSIST FprEN 548:2010



FprEN 548:2010 (E) 2 Contents Page Foreword .31 Scope .42 Normative references .43 Terms and definitions .44 Identification .55 Requirements .55.1 General requirements .55.2 Classification requirements .66 Marking .8Annex A (informative)
Optional properties .9Bibliography . 10 kSIST FprEN 548:2010



FprEN 548:2010 (E) 3 Foreword This document (FprEN 548:2010) has been prepared by Technical Committee CEN/TC 134 “Resilient, textile and laminate floor coverings”, the secretariat of which is held by BSI. This document is currently submitted to the Unique Acceptance Procedure. This document will supersede EN 548:2004.
kSIST FprEN 548:2010



FprEN 548:2010 (E) 4 1 Scope This European Standard specifies the characteristics of plain and decorative linoleum, supplied as either tiles or rolls. To encourage the consumer to make an informed choice, the standard includes a classification system based on intensity of use, which shows where resilient floor coverings should give satisfactory service (see EN 685). It also includes requirements for marking. The term 'linoleum' is frequently incorrectly applied to a range of floor coverings, often to those based on polyvinyl chloride or rubber. Such materials are not included in this standard. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 426, Resilient floor coverings — Determination of width, length, straightness and flatness and of sheet material EN 427, Resilient floor coverings — Determination of the side length, squareness and straightness of tiles EN 428, Resilient floor coverings — Determination of overall thickness EN 429, Resilient floor coverings — Determination of the thickness of layers EN 430, Resilient floor coverings — Determination of mass per unit area EN 433, Resilient floor coverings — Determination of residual indentation after static loading EN 435, Resilient floor coverings — Determination of flexibility EN 669, Resilient floor coverings — Determination of dimensional stability linoleum tiles, caused by changes in atmospheric humidity EN 670, R
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.