SIST EN 1253-5:2017

Gullies for buildings - Part 5: Gullies with light liquids closure

This draft European Standard specifies requirements for the design, construction, performance, application and marking as well as test methods of factory made gullies with a light liquid closure for buildings.
Light liquid closures for buildings shall be applied to avoid uncontrolled discharge of light liquids into drainage systems in case of emergency.
This draft European Standard does not apply to installations for separation of light liquids covered by EN 858-1.

Abläufe für Gebäude - Teil 5: Abläufe mit Leichtflüssigkeitssperren

Diese Europäische Norm legt Anforderungen an die Ausführung, Konstruktion, Funktion, Anwendung und Kennzeichnung sowie Prüfverfahren für werkmäßig hergestellte Abläufe mit Leichtflüssigkeitssperre für Gebäude fest.
Leichtflüssigkeitssperren für Gebäude müssen eingesetzt werden, um im Notfall das unkontrollierte Ableiten von Leichtflüssigkeiten in die Entwässerungsanlage zu verhindern.
Diese Norm gilt nicht für Abscheideranlagen für Leichtflüssigkeiten nach EN 858-1.

Avaloirs et siphons pour bâtiments - Partie 5 : Siphons avec obturateur pour liquides légers

Le présent projet de Norme européenne spécifie des exigences relatives à la conception, à la fabrication, aux performances, à l'installation, au marquage ainsi que les méthodes d'essai applicables aux siphons avec obturateur pour liquides légers fabriqués en usine et destinés aux bâtiments.
Les obturateurs pour liquides légers destinés aux bâtiments doivent être utilisés pour éviter tout rejet non maîtrisé de liquides légers dans les réseaux d'évacuation en cas d'urgence.
Le présent projet de Norme européenne n'est pas applicable aux installations de séparation des liquides légers telles que spécifiées dans l'EN 858-1.

Odtoki v stavbah - 5. del: Odtoki z zaporo lahkih tekočin

Ta osnutek evropskega standarda določa zahteve za načrtovanje, izdelavo, učinkovitost, uporabo in označevanje ter preskusne metode za tovarniško izdelane odtoke z zaporo lahkih tekočin za stavbe.
Zaporo lahkih tekočin za stavbe je treba uporabiti za preprečevanje nenadzorovanega izpusta lahkih tekočin v kanalizacijske sisteme v nujnih primerih.
Ta osnutek evropskega standarda se ne uporablja za naprave za ločevanje lahkih tekočin, zajete v standardu EN 858-1.

General Information

• Status: Published
• Public Enquiry End Date: 29-Oct-2015
• Publication Date: 27-Feb-2017
• ICS: 91.140.80 - Drainage systems
• Technical Committee: IOVO - Water supply and waste water engineering
• Current Stage: 6060 - National Implementation/Publication (Adopted Project)
• Start Date: 21-Feb-2017
• Due Date: 28-Apr-2017
• Completion Date: 28-Feb-2017
• Ref Project: EN 1253-5:2017 - Gullies for buildings - Part 5: Gullies with light liquids closure

Relations

• Replaces: SIST EN 1253-5:2004 - Gullies for buildings - Part 5: Gullies with light liquids closure
• Effective Date: 01-Apr-2017
• Replaces: SIST EN 1253-5:2004 - Gullies for buildings - Part 5: Gullies with light liquids closure
• Effective Date: 08-Jun-2022

Standards Content (Sample)

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Abläufe für Gebäude - Teil 5: Abläufe mit LeichtflüssigkeitssperrenAvaloirs et siphons pour bâtiments - Partie 5 : Siphons avec obturateur pour liquides légersGullies for buildings - Part 5: Gullies with light liquids closure91.140.80Drenažni sistemiDrainage systemsICS:Ta slovenski standard je istoveten z:EN 1253-5:2017SIST EN 1253-5:2017en,fr,de01-april-2017SIST EN 1253-5:2017SLOVENSKI
STANDARDSIST EN 1253-5:20041DGRPHãþD



SIST EN 1253-5:2017



EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 1253-5
February
t r s y ICS
{ sä s v rä z r Supersedes EN
s t w uæ wã t r r uEnglish Version
Gullies for buildings æ Part
wã Gullies with light liquids closure Avaloirs et siphons pour bâtiments æ Partie
w ã Siphons avec obturateur pour liquides légers
Abläufe für Gebäude æ Teil
wã Abläufe mit Leichtflüssigkeitssperren This European Standard was approved by CEN on
s v December
t r s xä
egulations which stipulate the conditions for giving this European Standard the status of a national standard without any alterationä Upætoædate lists and bibliographical references concerning such national standards may be obtained on application to the CENæCENELEC Management Centre or to any CEN memberä
translation under the responsibility of a CEN member into its own language and notified to the CENæCENELEC Management Centre has the same status as the official versionsä
CEN members are the national standards bodies of Austriaá Belgiumá Bulgariaá Croatiaá Cyprusá Czech Republicá Denmarká Estoniaá Finlandá Former Yugoslav Republic of Macedoniaá Franceá Germanyá Greeceá Hungaryá Icelandá Irelandá Italyá Latviaá Lithuaniaá Luxembourgá Maltaá Netherlandsá Norwayá Polandá Portugalá Romaniaá Serbiaá Slovakiaá Sloveniaá Spainá Swedená Switzerlandá Turkey and United Kingdomä
EUROPEAN COMMITTEE FOR STANDARDIZATION COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre:
Avenue Marnix 17,
B-1000 Brussels
9
t r s y CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Membersä Refä Noä EN
s t w uæ wã t r s y ESIST EN 1253-5:2017



EN 1253-5:2017 (E) 2 Contents Page European foreword . 3 1 Scope . 4 2 Normative references . 4 3 Terms and definitions . 4 4 Types . 4 5 Materials . 4 6 Requirements . 5 6.1 General . 5 6.2 Inflow . 5 6.3 Security height . 5 6.4 Tightness . 5 6.5 Maintenance . 6 6.6 Flow rates . 6 7 Test methods . 7 7.1 General . 7 7.2 Closing ability and tightness . 7 7.3 Security height . 7 8 Marking . 7 9 Evaluation of conformity . 8 Bibliography . 9
SIST EN 1253-5:2017



EN 1253-5:2017 (E) 3 European foreword This document (EN 1253-5:2017) has been prepared by Technical Committee CEN/TC 165 “Wastewater engineering”, the secretariat of which is held by DIN. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by August 2017, and conflicting national standards shall be withdrawn at the latest by August 2017. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN shall not be held responsible for identifying any or all such patent rights. This document supersedes EN 1253-5:2003. This is the fifth part in EN 1253, a series of standards relating to different types of floor gullies, roof drains and access covers for drainage systems inside buildings. The EN 1253 series under the main title Gullies for buildings actually consists of the following parts: — Part 1: Trapped floor gullies with a depth water seal of at least 50 mm; — Part 2: Roof drains and floor gullies without trap; — Part 3: Evaluation of conformity; — Part 4: Access covers; — Part 5: Gullies with light liquids closure. Since the latest versions of EN 1253-5 the most significant technical changes are the following: a) introduction of the new standards on trapped floor gullies wi
...