SIST EN 29313:1999

Resistance spot welding equipment - Cooling tubes (ISO 9313:1989)

Specifies diameters and cut-off angles of cooling tubes. Establishes also designation, materials and marking.

Widerstandspunkt-Schweißeinrichtungen - Kühlrohre (ISO 9313:1989)

Matériel de soudage par points par résistance - Tubes de refroidissement (ISO 9313:1989)

La présente Norme internationale prescrit les dimensions et tolérances des tubes de refroidissement pour équipements de soudage par points.

Naprave za elektrouporovno točkovno varjenje – Hladilne cevke (ISO 9313:1989)

General Information

• Status: Published
• Publication Date: 30-Nov-1999
• ICS: 25.160.30 - Welding equipment
• Technical Committee: VAR - Welding
• Current Stage: 6060 - National Implementation/Publication (Adopted Project)
• Start Date: 01-Dec-1999
• Due Date: 01-Dec-1999
• Completion Date: 01-Dec-1999
• Ref Project: EN 29313:1992 - Resistance spot welding equipment - Cooling tubes (ISO 9313:1989)

Standards Content (Sample)

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Widerstandspunkt-Schweißeinrichtungen - Kühlrohre (ISO 9313:1989)Matériel de soudage par points par résistance - Tubes de refroidissement (ISO 9313:1989)Resistance spot welding equipment - Cooling tubes (ISO 9313:1989)25.160.30Varilna opremaWelding equipmentICS:Ta slovenski standard je istoveten z:EN 29313:1992SIST EN 29313:1999en01-december-1999SIST EN 29313:1999SLOVENSKI
STANDARD



SIST EN 29313:1999



SIST EN 29313:1999



SIST EN 29313:1999



SIST EN 29313:1999



is0 9313:1989 E) Foreword IS0 (the International Organization for Standardization) is a worldwide federation of national standards bodies (IS0 member bodies). The work of preparing International Standards is normally carried out through IS0 technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with ISO, also take part in the work. IS0 collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the IS0 Council. They are approved in accordance with IS0 procedures requiring at least 75 % approval by the member bodies voting. International Standard IS0 9313 was prepared by Technical Committee ISO/TC 44, Welding and allied processes. 0 IS0 1989 All rights reserved. No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Organization for Standardization Case postale 56 l CH-1211 Geneve 20 l Switzerland Printed in Switzerland SIST EN 29313:1999



INTERNATIONAL STANDARD IS0 9313: 1989 (E) Resistance spot welding equipment - Cooling tubes 1 Scope This International Standard specifies dimensions and tolerances of cooling tubes for resistance spot welding equip- ment. The end of the tube shall be cut off at an angle to ensure a suf- ficient flow of water. Table 1 - Cooling tube dimensions 2 Normative references The following standards contain provisions which, through reference in this text, constitute provisions of this International Standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, an
...