SIST EN 61290-5-1:2007
(Main)Optical amplifiers - Test methods -- Part 5-1: Reflectance parameters - Optical spectrum analyzer method
Optical amplifiers - Test methods -- Part 5-1: Reflectance parameters - Optical spectrum analyzer method
This part of IEC 61290 applies to all commercially available optical amplifiers (OAs) and optically amplified sub-systems. It applies to OAs using optically pumped fibres (OFAs based on either rare-earth doped fibres or on the Raman effect), semiconductor OAs (SOAs), and waveguides (POWAs) The object of this standard is to establish uniform requirements for accurate and reliable measurements, by means of the optical spectrum analyzer test method, of the following OA parameters, as defined in IEC 61291-1: a) maximum input reflectance; b) minimum input reflectance; c) output reflectance.
Lichtwellenleiter-Verstärker - Prüfverfahren - Teil 5-1: Reflexionsparameter - Verfahren mit optischem Spektralanalysator
Amplificateurs optiques - Méthodes d'essais -- Partie 5-1: Paramètres de réflectance - Méthode d'analyseur de spectre optique
La présente partie de la CEI 61290 s'applique à tous les amplificateurs optiques (OA, Optical Amplifiers en anglais) et sous-systèmes à amplification optique, disponibles sur le marché. Elle s'applique aux OA utilisant des fibres pompées optiquement (AFO basés sur des fibres dopées aux terres rares ou sur l'effet Raman), des semi-conducteurs (SOA), et des guides d'ondes (POWA).
Metode preskušanja optičnega ojačevalnika – 5-1. del: Parametri odbojnosti – Metoda analize optičnega spektra (IEC 61290-5-1:2006)
General Information
Relations
Standards Content (Sample)
SLOVENSKI SIST EN 61290-5-1:2006
STANDARD
oct 2006
Optični ojačevalniki – Preskusne metode – 5-1. del: Parametri odbojnosti –
Metoda z analizatorjem optičnega spektra (IEC 61290-5-1:2006)
Optical amplifiers - Test methods – Part 5-1: Reflectance parameters – Optical
spectrum analyzer method (IEC 61290-5-1:2006)
ICS 33.180.30 Referenčna številka
SIST EN 61290-5-1:2006(en)
© Standard je založil in izdal Slovenski inštitut za standardizacijo. Razmnoževanje ali kopiranje celote ali delov tega dokumenta ni dovoljeno
---------------------- Page: 1 ----------------------
EUROPEAN STANDARD
EN 61290-5-1
NORME EUROPÉENNE
July 2006
EUROPÄISCHE NORM
ICS 33.180.30 Supersedes EN 61290-5-1:2000
English version
Optical amplifiers -
Test methods
Part 5-1: Reflectance parameters -
Optical spectrum analyzer method
(IEC 61290-5-1:2006)
Amplificateurs optiques - Lichtwellenleiter-Verstärker -
Méthodes d'essais Prüfverfahren
Partie 5-1: Paramètres de réflectance - Teil 5-1: Reflexionsparameter -
Méthode d'analyseur de Verfahren mit optischem
spectre optique
Spektralanalysator
(CEI 61290-5-1:2006) (IEC 61290-5-1:2006)
This European Standard was approved by CENELEC on 2006-06-01. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the Central Secretariat has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Cyprus, the Czech
Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain,
Sweden, Switzerland and the United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
Central Secretariat: rue de Stassart 35, B - 1050 Brussels
© 2006 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 61290-5-1:2006 E
---------------------- Page: 2 ----------------------
EN 61290-5-1:2006 - 2 -
Foreword
The text of document 86C/697/FDIS, future edition 2 of IEC 61290-5-1, prepared by SC 86C, Fibre optic
systems and active devices, of IEC TC 86, Fibre optics, was submitted to the IEC-CENELEC parallel vote
and was approved by CENELEC as EN 61290-5-1 on 2006-06-01.
This European Standard supersedes EN 61290-5-1:2000.
The applicability of the standard has been extended to all commercially available optical amplifiers - not
just optical fiber amplifiers.
The following dates were fixed:
– latest date by which the EN has to be implemented
at national level by publication of an identical
national standard or by endorsement (dop) 2007-03-01
– latest date by which the national standards conflicting
with the EN have to be withdrawn (dow) 2009-06-01
Annex ZA has been added by CENELEC.
__________
Endorsement notice
The text of the International Standard IEC 61290-5-1:2006 was approved by CENELEC as a European
Standard without any modification.
__________
---------------------- Page: 3 ----------------------
- 3 - EN 61290-5-1:2006
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications
The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.
NOTE When an international publication has been modified by common modifications, indicated by (mod), the relevant EN/HD
applies.
Publication Year Title EN/HD Year
1) 2)
IEC 61291-1 - Optical fibre amplifiers EN 61291-1 1998
Part 1: Generic specification
1)
Undated reference.
2)
Valid edition at date of issue.
---------------------- Page: 4 ----------------------
NORME CEI
INTERNATIONALE
IEC
61290-5-1
INTERNATIONAL
Deuxième édition
STANDARD
Second edition
2006-05
Amplificateurs optiques –
Méthodes d'essais –
Partie 5-1:
Paramètres de réflectance –
Méthode d'analyseur de spectre optique
Optical amplifiers –
Test methods –
Part 5-1:
Reflectance parameters –
Optical spectrum analyzer method
IEC 2006 Droits de reproduction réservés Copyright - all rights reserved
Aucune partie de cette publication ne peut être reproduite ni No part of this publication may be reproduced or utilized in any
utilisée sous quelque forme que ce soit et par aucun procédé, form or by any means, electronic or mechanical, including
électronique ou mécanique, y compris la photocopie et les photocopying and microfilm, without permission in writing from
microfilms, sans l'accord écrit de l'éditeur. the publisher.
International Electrotechnical Commission, 3, rue de Varembé, PO Box 131, CH-1211 Geneva 20, Switzerland
Telephone: +41 22 919 02 11 Telefax: +41 22 919 03 00 E-mail: inmail@iec.ch Web: www.iec.ch
CODE PRIX
L
PRICE CODE
Commission Electrotechnique Internationale
International Electrotechnical Commission
МеждународнаяЭлектротехническаяКомиссия
Pour prix, voir catalogue en vigueur
For price, see current catalogue
---------------------- Page: 5 ----------------------
61290-5-1 IEC:2006 – 3 –
CONTENTS
FOREWORD.5
INTRODUCTION.11
1 Scope and object .13
2 Normative references.13
3 Acronyms and abbreviations .13
4 Apparatus.13
5 Test sample.17
6 Procedure.17
6.1 Maximum and minimum input reflectance.17
6.2 Output reflectance .21
7 Calculation .21
7.1 Maximum and minimum input reflectance.21
7.2 Output reflectance .21
8 Test results .21
8.1 Maximum and minimum input reflectance.21
8.2 Output reflectance .23
Figure 1 – Typical arrangement of the optical spectrum analyzer test apparatus for input
reflectance.15
Figure 2 – Set-up for insertion loss measurement of optical coupler and isolator .17
Figure 3 – Set-up for OA input power measurements .19
---------------------- Page: 6 ----------------------
61290-5-1 IEC:2006 – 5 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
OPTICAL AMPLIFIERS –
TEST METHODS –
Part 5-1: Reflectance parameters –
Optical spectrum analyzer method
FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC
Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested
in the subject dealt with may participate in this preparatory work. International, governmental and non-
governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely
with the International Organization for Standardization (ISO) in accordance with conditions determined by
agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
transparently to the maximum extent possible in their national and regional publications. Any divergence
between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in
the latter.
5) IEC provides no marking procedure to indicate its approval and cannot be rendered responsible for any
equipment declared to be in conformity with an IEC Publication.
6) All users should ensure that they have the latest edition of this publication.
7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and
members of its technical committees and IEC National Committees for any personal injury, property damage or
other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and
expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC
Publications.
8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is
indispensable for the correct application of this publication.
9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of
patent rights. IEC shall not be held responsible for identifying any or all such patent rights.
International Standard IEC 61290-5-1 has been prepared by subcommittee 86C: Fibre optic
systems and active devices, of IEC technical committee 86: Fibre optics.
This second edition cancels and replaces the first edition published in 2000. It constitutes a
technical revision. In this edition the applicability has been extended to all commercially
available optical amplifiers—not just optical fiber amplifiers.
---------------------- Page: 7 ----------------------
61290-5-1 IEC:2006 – 7 –
The text of this standard is based on the following documents:
FDIS Report on voting
86C/697/FDIS 86C/702/RVD
Full information on the voting for the approval of this standard can be found in the report on
voting indicated in the above table.
This publication has been drafted in accordance with the ISO/IEC Directives, Part 2.
IEC 61290 consists of the following parts under the general title Optical amplifiers – Test
1
methods:
Part 1-1: Test methods for gain parameters – Optical spectrum analyzer
Part 1-2: Power and gain parameters – Electrical spectrum analyzer method
Part 1-3: Power and gain parameters – Optical power meter method
Part 2-1: Test methods for optical power parameters – Optical spectrum analyzer
Part 2-2: Test methods for optical power parameters – Electrical spectrum analyzer
Part 3: Test methods for noise figure parameters
Part 3-1: Noise figure parameters – Optical spectrum analyzer method
Part 3-2: Test methods for noise figure parameters – Electrical spectrum analyzer method
Part 5-1: Reflectance parameters – Optical spectrum analyser method
Part 5-2: Reflectance parameters – Electrical spectrum analyser method
Part 5-3: Test methods for reflectance parameters – Reflectance tolerance using an
electrical spectrum analyser
Part 6-1: Test methods for pump leakage parameters – Optical demultiplexer
Part 7-1: Test methods for out-of-band insertion losses – Filtered optical power meter
Part 10-1: Multi-channel parameters – Pulse method using an optical switch and optical
spectrum analyzer
Part 10-2: Multi-channel parameters – Pulse method using a gated optical spectrum
analyzer
Part 10-3: Multi-channel parameters – Probe methods
Part 11-
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.