Testing hardened concrete - Part 18: Determination of the chloride migration coefficient

This document describes the procedure for obtaining the non-steady-state chloride migration coefficient of specimens of hardened concrete at a specified age. The test procedure does not take into account any interaction of concrete with the saline solution over time. The test result is a durability indicator with respect to the resistance of the concrete investigated against chloride penetration.
The test procedure does not apply to concrete specimens with surface treatments such as silanes.
If the aggregate is electrically conductive or porous this will influence the magnitude of chloride migration. This fact has to be taken into account when establishing threshold values. It prevents comparison of chloride migration values between concretes if the aggregates show a difference of half an order of magnitude (higher or lower) of chloride migration.
Similar influence may be seen when metallic or electrically conducting fibres or particles are present.

Prüfung von Festbeton - Teil 18: Bestimmung des Chloridmigrationskoeffizienten

Dieses Dokument beschreibt das Verfahren für den Erhalt des nicht stabilen Chloridmigrationskoeffizienten von Festbetonprobekörpern eines bestimmten Alters. Das Prüfverfahren berücksichtigt keine Wechsel¬wirkung von Beton mit der Kochsalzlösung über die Zeit. Das Prüfergebnis ist ein Dauerhaftigkeitsindikator in Bezug auf den Widerstand des untersuchten Betons gegen das Eindringen von Chlorid.
Das Prüfverfahren gilt nicht für Betonprobekörper mit Oberflächenbehandlungen wie Silanen.
Wenn die Gesteinskörnung elektrisch leitfähig oder porös ist, wird dies die Größenordnung der Chlorid-migration beeinflussen. Dieser Umstand wird bei der Festlegung von Grenzwerten berücksichtigt. Es verhindert den Vergleich von Chloridmigrationswerten zwischen Betonen, wenn die Gesteinskörnungen eine Differenz von einer halben Größenordnung (höher oder niedriger) der Chloridmigration aufweisen.
Ein ähnlicher Einfluss kann beobachtet werden, wenn metallische oder elektrisch leitende Fasern oder Partikel vorhanden sind.

Essai sur béton durci - Partie 18: Détermination du coefficient de migration des chlorures

Le présent document spécifie le mode opératoire permettant d’obtenir le coefficient de migration des chlorures en régime non stationnaire d’éprouvettes de béton durci à un âge spécifié (voir Annexe A). Ce mode opératoire d’essai ne prend pas en compte l’interaction du béton avec la solution saline au cours du temps. Le résultat d’essai est un indicateur de durabilité en ce qui concerne la résistance du béton étudié à la pénétration des chlorures.
Le mode opératoire d’essai ne s’applique pas aux éprouvettes de béton ayant subi des traitements de surface, par exemple à base de silanes.
Si le granulat ou tout autre élément incorporé (notamment des fibres métalliques ou des particules conductrices) sont électriquement conducteurs, cela va influer sur l’ampleur de la migration des chlorures. Ce fait est pris en compte lors de l’établissement des valeurs seuils. En effet, la comparaison des valeurs de migration des chlorures entre les bétons est impossible si les granulats induisent une différence d’un demi-ordre de grandeur (en plus ou en moins) en matière de migration des chlorures.

Preskušanje strjenega betona - 18. del: Določanje koeficienta migracije klorida

General Information

Status
Published In Translation
Public Enquiry End Date
14-Jan-2019
Publication Date
24-May-2021
Current Stage
6100 - Translation of adopted SIST standards (Adopted Project)
Start Date
14-Nov-2023
Due Date
12-Nov-2024

Relations

Buy Standard

Standard
EN 12390-18:2021 - BARVE
English language
18 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day
Draft
prEN 12390-18:2019
English language
18 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 12390-18:2021
01-julij-2021
Preskušanje strjenega betona - 18. del: Določanje koeficienta migracije klorida
Testing hardened concrete - Part 18: Determination of the chloride migration coefficient
Prüfung von Festbeton - Teil 18: Bestimmung des Chloridmigrationskoeffizienten
Essai sur béton durci - Partie 18: Détermination du coefficient de migration des chlorures
Ta slovenski standard je istoveten z: EN 12390-18:2021
ICS:
91.100.30 Beton in betonski izdelki Concrete and concrete
products
SIST EN 12390-18:2021 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
SIST EN 12390-18:2021

---------------------- Page: 2 ----------------------
SIST EN 12390-18:2021


EN 12390-18
EUROPEAN STANDARD

NORME EUROPÉENNE

March 2021
EUROPÄISCHE NORM
ICS 91.100.30
English Version

Testing hardened concrete - Part 18: Determination of the
chloride migration coefficient
Essais pour béton durci - Partie 18 : Détermination du Prüfung von Festbeton - Teil 18: Bestimmung des
coefficient de migration des chlorures Chloridmigrationskoeffizienten
This European Standard was approved by CEN on 8 February 2021.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.





EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2021 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 12390-18:2021 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
SIST EN 12390-18:2021
EN 12390-18:2021 (E)
Contents Page
European foreword . 3
1 Scope . 4
2 Normative references . 4
3 Terms and definitions . 4
4 Symbols . 5
5 Principle . 5
6 Apparatus and equipment . 5
7 Preparation of specimens . 8
7.1 Preparing sub-specimens . 8
7.2 Preparing test specimens . 9
8 Procedure. 9
8.1 Installation of the test specimens in the migration cell . 9
8.2 Installation of the migration cell in the migration apparatus . 9
8.3 Test procedure .
...

SLOVENSKI STANDARD
oSIST prEN 12390-18:2019
01-januar-2019
3UHVNXãDQMHVWUMHQHJDEHWRQDGHO'RORþDQMHNRHILFLHQWDPLJUDFLMHNORULGD
Testing hardened concrete - Part 18: Determination of the chloride migration coefficient
Prüfung von Festbeton - Teil 18: Bestimmung des Chloridmigrationskoeffizienten
Essai sur béton durci - Partie 18: Détermination du coefficient de migration des chlorures
Ta slovenski standard je istoveten z: prEN 12390-18
ICS:
91.100.30 Beton in betonski izdelki Concrete and concrete
products
oSIST prEN 12390-18:2019 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
oSIST prEN 12390-18:2019

---------------------- Page: 2 ----------------------
oSIST prEN 12390-18:2019


DRAFT
EUROPEAN STANDARD
prEN 12390-18
NORME EUROPÉENNE

EUROPÄISCHE NORM

November 2018
ICS 91.100.30
English Version

Testing hardened concrete - Part 18: Determination of the
chloride migration coefficient
Essai sur béton durci - Partie 18: Détermination du Prüfung von Festbeton - Teil 18: Bestimmung des
coefficient de migration des chlorures Chloridmigrationskoeffizienten
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee
CEN/TC 104.

If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.

This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and United Kingdom.

Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.


EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2018 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 12390-18:2018 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
oSIST prEN 12390-18:2019
prEN 12390-18:2018 (E)
Contents Page
European foreword . 3
1 Scope . 4
2 Normative references . 4
3 Terms and definitions . 4
4 Symbols . 5
5 Principle . 5
6 Apparatus and equipment . 5
7 Preparation of specimens . 8
7.1 Preparing sub-specimens . 8
7.2 Preparing test specimens . 8
8 Procedure. 9
8.1 Installation of the te
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.