SIST EN 61184:2008/A1:2011
Bayonet lampholders
Bayonet lampholders
This International Standard applies to bayonet lampholders B15d and B22d for connection of lamps and semi-luminaires to a supply voltage of 250 V. This standard also covers lampholders which are integral with a luminaire or intended to be built into appliances. It covers the requirements for the lampholder only. For all other requirements, such as protection against electric shock in the area of the terminals, the requirements of the relevant appliance standard shall be observed and tested after building into the appropriate equipment, when that equipment is tested according to its own standard. Lampholders for use by luminaire manufacturers only are not for retail sale. B15 denotes the cap/holder fit as defined by IEC 60061-1, sheet 7004-11 and IEC 60061-2, sheet 7005-16 with the corresponding gauges. B22 denotes the cap/holder fit as defined by IEC 60061-1, sheet 7004-10 and IEC 60061-2, sheet 7005-10 with the corresponding gauges.
Bajonett-Lampenfassungen
Douilles à baïonnette
Le contenu du corrigendum de décembre 2012 a été pris en considération dans cet exemplaire.
Bajonetni okovi za žarnice in sijalke
Ta mednarodni standard velja za bajonetne okove za žarnice in sijalke B15d in B22d, namenjene povezovanju sijalk in polovičnih svetilk na napajalno napetost 250 V. Ta standard prav tako zajema okove za sijalke, ki so vgrajeni s svetilko ali so namenjeni vgradnji v gospodinjske aparate. Zajema samo zahteve za okove za sijalke. Za vse druge zahteve, kot je zaščita pred elektrošokom v območju terminalov, se upoštevajo in preskušajo zahteve ustreznih standardov za aparate po vgradnji v primerno opremo, kadar se ta oprema preskuša v skladu s svojim standardom. Okovi za sijalke, ki jih uporabljajo samo proizvajalci svetilk, niso namenjeni maloprodaji. B15 označuje vznožek/prileganje okova, kot je opredeljeno v IEC 60061-1, list 7004-11, in v IEC 60061-2, list 7005-16, z ustreznimi premeri. B22 označuje vznožek/prileganje okova, kot je opredeljeno v IEC 60061-1, list 7004-10, in v IEC 60061-2, list 7005-10, z ustreznimi premeri.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 61184:2008/A1:2011
01-september-2011
Bajonetni okovi za žarnice in sijalke
Bayonet lampholders
Bajonett-Lampenfassungen
Douilles à baïonnette
Ta slovenski standard je istoveten z: EN 61184:2008/A1:2011
ICS:
29.140.10 Grla in držala žarnic Lamp caps and holders
SIST EN 61184:2008/A1:2011 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 61184:2008/A1:2011
---------------------- Page: 2 ----------------------
SIST EN 61184:2008/A1:2011
EUROPEAN STANDARD
EN 61184/A1
NORME EUROPÉENNE
May 2011
EUROPÄISCHE NORM
ICS 29.140.10
English version
Bayonet lampholders
(IEC 61184:2008/A1:2011)
Douilles à baïonnette Bajonett-Lampenfassungen
(CEI 61184:2008/A1:2011) (IEC 61184:2008/A1:2011)
This amendment A1 modifies the European Standard EN 61184:2008; it was approved by CENELEC on
2011-05-25. CENELEC members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this amendment the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.
This amendment exists in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CENELEC member into its own language and notified to the
Central Secretariat has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy,
Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia,
Spain, Sweden, Switzerland and the United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
Management Centre: Avenue Marnix 17, B - 1000 Brussels
© 2011 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 61184:2008/A1:2011 E
---------------------- Page: 3 ----------------------
SIST EN 61184:2008/A1:2011
EN 61184:2008/A1:2011 - 2 -
Foreword
The text of document 34B/1587/FDIS, future amendment 1 to IEC 61184:2008, prepared by SC 34B,
Lamp caps and holders, of IEC TC 34, Lamps and related equipment, was submitted to the
IEC-CENELEC parallel vote and was approved by CENELEC as amendment A1 to EN 61184:2008 on
2011-05-25.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN and CENELEC shall not be held responsible for identifying any or all such patent
rights.
The following dates were fixed:
– latest date by which the amendment has to be
implemented at national level by publication of
an identical national standard or by endorsement (dop) 2012-02-25
– latest date by which the national standards conflicting
with the amendment have to be withdrawn (dow) 2014-05-25
__________
Endorsement notice
The text of amendment 1:2011 to the International Standard IEC 61184:2008 was approved by
CENELEC as an amendment to the European Standard without any modification.
__________
---------------------- Page: 4 ----------------------
SIST EN 61184:2008/A1:2011
IEC 61184
®
Edition 3.0 2011-04
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
AMENDMENT 1
AMENDEMENT 1
Bayonet lampholders
Douilles à baïonnette
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
INTERNATIONALE PRICE CODE
H
CODE PRIX
ICS 29.140.10 ISBN 978-2-88912-465-7
® Registered trademark of the International Electrotechnical Commission
Marque déposée de la Commission Electrotechnique Internationale
---------------------- Page: 5 ----------------------
SIST EN 61184:2008/A1:2011
– 2 – 61184 Amend.1 © IEC:2011
FOREWORD
This amendment has been prepared by subcommittee 34B: Lamp caps and holders, of IEC
technical committee 34: Lamps and related equipment.
The text of this amendment is based on the following documents:
FDIS Report on voting
34B/1587/FDIS 34B/1599/RVD
Full information on the voting for the approval of this amendment can be found in the report
on voting indicated in the above table.
The committee has decided that the contents of this amendment and the base publication will
remain unchanged until the stability date indicated on the IEC web site under
"http://webstore.iec.ch" in the data related to the specific publication. At this date, the
publication will be
• reconfirmed,
• withdrawn,
• replaced by a revised edition, or
• amended.
_____________
1 General
1.1 Scope
Replace, in the penultimate sentence, B15 by B15d.
Replace, in the last sentence, B22 by B22d.
2 Terms and definitions
Add the following two new definitions:
2.25
enclosed reinforced insulated lampholder
lampholder for building-in, so designed that on its own it fulfils the requirements for double or
reinforced insulated parts in class II applications
2.26
partly reinforced insulated lampholder
lampholder for building-in, so designed that some parts of the lampholder require additional
means to fulfil the requirements with regard to double or reinforced insulation
NOTE In some cases, the dimensions might be achieved only after mounting into the luminaire.
---------------------- Page: 6 ----------------------
SIST EN 61184:2008/A1:2011
61184 Amend.1 © IEC:2011 – 3 –
5 Standard ratings
5.2 Standard rated currents
Replace, in the first dashed item, B15 by B15d.
Replace, in the second dashed item, B22 by B22d.
6 Classification
Replace the existing Subclause 6.5 by the following:
6.5 According to protection against electric shock:
− unenclosed lampholders;
− enclosed lampholders;
− independent lampholders;
− partly reinforced insulated lampholders;
− enclosed reinforced insulated lampholders.
NOTE Where a lampholder is used with a working voltage of 50 % or less of its maximum rating, it may be
regarded as equivalent to a reinforced insulated lampholder.
7 Marking
Replace, in Subclause 7.1, the third paragraph (“Lampholders complying with the…”), the
following note and the last paragraph by the following new text:
Enclosed reinforced insulated lampholders offer an adequate level of protection for use in
luminaires where they are accessible in normal use. This information shall be indicated in the
manufacturer’s catalogue ore the like.
For partly reinforced insulated lampholders, sufficient creepage distances and clearances to
outer accessible surfaces will require addi
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.