SIST EN 61754-6:1999/A2:2005
(Amendment)Fibre optic connector interfaces -- Part 6: Type MU connector family
Fibre optic connector interfaces -- Part 6: Type MU connector family
Steckgesichter von Lichtwellenleiter-Steckverbindern -- Teil 6: Bauart MU Steckverbinderfamilie
Interfaces de connecteurs pour fibres optiques -- Partie 6: Famille de connecteurs de type MU
Spojni vmesniki optičnih vlaken – 6. del: Družina konektorjev tipa MU (IEC 61754-6:1997/A2:2004)
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 61754-6:1999/A2:2005
01-november-2005
6SRMQLYPHVQLNLRSWLþQLKYODNHQ±GHO 'UXåLQDNRQHNWRUMHYWLSD08 ,(&
$
Fibre optic connector interfaces -- Part 6: Type MU connector family
Steckgesichter von Lichtwellenleiter-Steckverbindern -- Teil 6: Bauart MU
Steckverbinderfamilie
Interfaces de connecteurs pour fibres optiques -- Partie 6: Famille de connecteurs de
type MU
Ta slovenski standard je istoveten z: EN 61754-6:1997/A2:2005
ICS:
33.180.20 3RYH]RYDOQHQDSUDYH]D Fibre optic interconnecting
RSWLþQDYODNQD devices
SIST EN 61754-6:1999/A2:2005 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 61754-6:1999/A2:2005
---------------------- Page: 2 ----------------------
SIST EN 61754-6:1999/A2:2005
EUROPEAN STANDARD EN 61754-6/A2
NORME EUROPÉENNE
EUROPÄISCHE NORM January 2005
ICS 33.180.20
English version
Fibre optic connector interfaces
Part 6: Type MU connector family
(IEC 61754-6:1997/A2:2004)
Interfaces de connecteurs Steckgesichter von Lichtwellenleiter-
pour fibres optiques Steckverbindern
Partie 6: Famille de connecteurs Teil 6: Bauart MU Steckverbinderfamilie
de type MU (IEC 61754-6:1997/A2:2004)
(CEI 61754-6:1997/A2:2004)
This amendment A2 modifies the European Standard EN 61754-6:1997; it was approved by CENELEC
on 2004-12-01. CENELEC members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this amendment the status of a national standard without any
alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.
This amendment exists in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CENELEC member into its own language and notified to the
Central Secretariat has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Cyprus, Czech
Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia, Slovenia, Spain, Sweden,
Switzerland and United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
Central Secretariat: rue de Stassart 35, B - 1050 Brussels
© 2005 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 61754-6:1997/A2:2005 E
---------------------- Page: 3 ----------------------
SIST EN 61754-6:1999/A2:2005
EN 61754-6:1997/A2:2005 - 2 -
Foreword
The text of document 86B/2014/FDIS, future amendment 2 to IEC 61754-6:1997, prepared by
SC 86B, Fibre optic interconnecting devices and passive components, of IEC TC 86, Fibre optics, was
submitted to the IEC-CENELEC parallel vote and was approved by CENELEC as amendment A2 to
EN 61754-6:1997 on 2004-12-01.
The following dates were fixed:
– latest date by which the amendment has to be implemented
at national level by publication of an identical
national standard or by endorsement (dop) 2005-09-01
– latest date by which the national standards conflicting
with the amendment have to be withdrawn (dow) 2007-12-01
__________
Endorsement notice
The text of amendment 2:2004 to the International Standard IEC 61754-6:1997 was approved by
CENELEC as an amendment to the European Standard without any modification.
__________
---------------------- Page: 4 ----------------------
SIST EN 61754-6:1999/A2:2005
NORME CEI
INTERNATIONALE
IEC
61754-6
INTERNATIONAL
1997
STANDARD
AMENDEMENT 2
AMENDMENT 2
2004-11
Amendement 2
Interfaces de connecteurs
pour fibres optiques –
Partie 6:
Famille de connecteurs de type MU
Amendment 2
Fibre optic connector interfaces –
Part 6:
Type MU connector family
IEC 2004 Droits de reproduction réservés Copyright - all rights reserved
International Electrotechnical Commission, 3, rue de Varembé, PO Box 131, CH-1211 Geneva 20, Switzerland
Telephone: +41 22 919 02 11 Telefax: +41 22 919 03 00 E-mail: inmail@iec.ch Web: www.iec.ch
CODE PRIX
N
Commission Electrotechnique Internationale
PRICE CODE
International Electrotechnical Commission
МеждународнаяЭлектротехническаяКомиссия
Pour prix, voir catalogue en vigueur
For price, see current catalogue
---------------------- Page: 5 ----------------------
SIST EN 61754-6:1999/A2:2005
61754-6 Amend. 2 IEC:2004 – 3 –
FOREWORD
This amendment has been prepared by subcommittee 86B: Fibre optic interconnecting devices
and passive components, of IEC technical committee 86: Fibre optics.
The text of this amendment is based on the following documents:
FDIS RVD
86B/2014/FDIS 86B/2030/RVD
Full information on the voting for the approval of this amendment can be found in the report on
voting indicated in the above table.
The committee has decided that the contents of this amendment and the base publication will
remain unchanged until the maintenance result date indicated on the IEC web site under
"http://webstore.iec.ch" in the data related to the specific publication. At this date, the
publication will be
• reconfirmed,
• withdrawn,
• replaced by a revised edition, or
• amended.
___________
Page 7
3 Interfaces
1)
Add, at the end of the list of standard interfaces, the following new interfaces :
Interface 6-16: Simplex plug connector interface – push/pull, APC 8 degrees
Interface 6-17: 4,5 mm duplex plug connector interface – push/pull, APC 8 degrees
Interface 6-18: 6,25 mm duplex plug connector interface – push/pull, APC 8 degrees
Add, on page 8, the following new Clause 4:
4 MU angled PC connector interfaces
This clause defines the standard interfaces for simplex and duplex plugs that have ferrules with
endfaces polished spherically at an angle (rather than perpendicularly) which are oriented to the
connector key, and are termed angled PC or APC. The standard interfaces contained in this
clause are the following:
– interface 6-16: simplex plug connector interface – push/pull, APC 8 degrees;
– interface 6-17: 4,5 mm duplex plug connector interface – push/pull, APC 8 degrees;
– interface 6-18: 6,25 mm duplex plug connector interface – push/pull, APC 8 degrees.
___________
1)
Please note that interfaces 6-14 and 6-15 are defined in IEC 61754-6-1.
---------------------- Page: 6 ----------------------
SIST EN 61754-6:1999/A2:2005
61754-6 Amend. 2 IEC:2004 – 5 –
The simplex and duplex plugs of interfaces 6-16, 6-17 and 6-18 have ferrules with an endface
polished spherically at an angle of their polished endface, and the nomenclature is angled PC or
APC.
The following standard interfaces are intermateable. It shall be noted however that in order to
obtain the designated optical performance, any plug shall be connected to a counterpart plug
whose ferrule end is polished to the same condition.
Adaptor
Plugs
Interface 6-3 Interface 6-4 Interface 6-5
Interface 6-16 Mate Mate Mate
Interface 6-17 Not Mate Mate Mate
Interface 6-18 Not Mate Not Mate Not Mate
Connector housing
Plugs
Interface 6-8 Interface 6-9 Interface 6-10 Interface 6-11
Interface 6-16 Mate Not Mate Mate Not Mate
Interface 6-17 Mate Not Mate Mate Not Mate
Interface 6-18 Not Mate Not Mate Not Mate Not Mate
---------------------- Page: 7 ----------------------
SIST EN 61754-6:1999/A2:2005
61754-6 Amend. 2 IEC:2004 – 7 –
Optical datum
target
Ferrule
Coupling sleeve
Cross section A-A
(1) Conical (2) Step
Expanded view of ferrule endface
(After polishing, note 1 of Table 14)
Projected from B
IEC 1384/04
Figure 14a – Simplex plug connector interface
---------------------- Page: 8 ----------------------
SIST EN 61754-6:1999/A2:2005
61754-6 Amend. 2 IEC:2004 – 9 –
Plane B
Ferrule
Plane A
Guide key
Expanded view from C direction
(After polishing)
Vertex
Angled PC
reference plane
Ferrule endface geometry
(Expanded view from D direction, after
polishing)
IEC 1385/04
Figure 14b – Simplex plug connector interface
---------------------- Page: 9 ----------------------
SIST EN 61754-6:1999/A2:2005
61754-6 Amend. 2 IEC:2004 – 11 –
Table 14 – Dimensions of the simplex plug connector interfaces
Dimensions
Reference Notes
Minimum Basic Maximum
A 1,2485 mm 1,2495 mm 2
B 2,6 mm 2,7 mm
C 4,6 mm 4,8 mm
D 4,65 mm 4,75 mm
E 4,3 mm 4,4 mm
F 3,3 mm 3,4 mm
G 25° 35°
H 25° 35°
I 6,55 mm - 3
J 4,2 mm 4,5 mm 4
K 5,5 mm -
L 2,4 mm 2,5 mm
M 1,5 mm -
N 0,6 mm -
O 0,5 mm -
P 2,6 mm - 3
Q 1 mm 1,1 mm 3 and 5
R 2,65 mm 2,9 mm 3
S 5,5 mm 5,6 mm
T 4,3 mm 4,5 mm
U - 3,7 mm
V - 2,4 mm
W 6,5 mm 6,6 mm
AA 4,3 mm 4,4 mm
AB 3,85 mm 3,95 mm
AC 0,7 mm 0,9 mm
AD 0,2 mm - Radius
AE 3 mm -
AF 2,2 mm 2,3 mm
EA - 90° - 6
EB 8°
EC 32,5° 45° 7
ED 0,6 mm 0,85 mm
EO 0,00 mm 0,05 mm 8
EP 5 mm 12 mm Radius, 9
---------------------- Page: 10 ----------------------
SI
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.