kSIST FprEN IEC 61347-2-2:2024
(Main)Controlgear for electric light sources - Safety - Part 2-2: Particular requirements for electronic step-down convertors for filament lamps
Controlgear for electric light sources - Safety - Part 2-2: Particular requirements for electronic step-down convertors for filament lamps
IEC 61347-2-2:2024 specifies safety requirements for electronic step-down convertors for use on DC supplies of up to 1 500 V or AC supplies of up to 1 000 V at 50 Hz or 60 Hz, and with a rated output voltage ≤ 50 V (RMS) at a frequency deviating from the supply frequency, or 120 V ripple free DC between conductors and between any conductor and earth, associated with tungsten-halogen lamps as specified in IEC 60357, and other filament lamps.
This third edition cancels and replaces the second edition published in 2011. This edition constitutes a technical revision.
This edition includes the following significant technical changes with respect to the previous edition:
a) alignment with respect to the fourth edition of IEC 61347-1;
- introduction of dated references to the fourth edition of IEC 61347-1 as appropriate;
- deletion of the clauses and subclauses which are either no longer relevant or now covered in IEC 61347-1;
b) scope extension to 1 500 V for direct current;
c) scope clarification;
d) deletion of unused definitions;
e) revision of information and marking requirements;
f) revision of compliance conditions for the measurement of the output voltage during fault condition testing and during thermal testing.
Geräte für Lampen - Teil 2-2: Besondere Anforderungen an gleich- oder wechselstromversorgte elektronische Konverter für Glühlampen
Appareillages de lampes - Partie 2-2: Exigences particulières pour les convertisseurs abaisseurs électroniques alimentés en courant continu ou alternatif pour lampes à incandescence
L'IEC 61347-2-2:2024 spécifie les exigences de sécurité applicables aux convertisseurs abaisseurs électroniques destinés à être utilisés sur des alimentations en courant continu jusqu'à 1 500 V ou sur des alimentations en courant alternatif jusqu'à 1 000 V à 50 Hz ou 60 Hz et de tension de sortie assignée ≤ 50 V (en valeur efficace) à une fréquence différente de celle de la tension d'alimentation, ou 120 V en courant continu lissé entre conducteurs et entre un conducteur et la terre, associés à des lampes tungstène‑halogène, comme cela est spécifié dans l'IEC 60357, et d'autres lampes à incandescence.
Cette troisième édition annule et remplace la deuxième édition parue en 2011. Cette édition constitue une révision technique.
Cette édition inclut les modifications techniques majeures suivantes par rapport à l'édition précédente:
a) alignement sur la quatrième édition de l'IEC 61347-1;
- ajout de références datées à la quatrième édition de l'IEC 61347-1, le cas échéant;
- suppression des articles et paragraphes qui ne sont plus pertinents ou qui sont désormais couverts dans l'IEC 61347-1;
b) extension du domaine d'application à 1 500 V pour le courant continu;
c) clarification du domaine d'application;
d) suppression des définitions non utilisées;
e) révision des exigences relatives aux informations et aux marquages;
f) révision des conditions de conformité pour le mesurage de la tension de sortie lors des essais en conditions de défaut et lors des essais thermiques.
Stikalne naprave za sijalke - Varnost - 2-2. del: Posebne zahteve za elektronske pretvornike za žarnice
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
oSIST prEN IEC 61347-2-2:2023
01-september-2023
Stikalne naprave za sijalke - Varnost - 2-2. del: Posebne zahteve za elektronske
pretvornike za žarnice
Controlgear for electric light sources - Safety - Part 2-2: Particular requirements for
electronic step-down convertors for filament lamps
Geräte für Lampen - Teil 2-2: Besondere Anforderungen an gleich- oder
wechselstromversorgte elektronische Konverter für Glühlampen
Appareillages de lampes - Partie 2-2: Exigences particulières pour les convertisseurs
abaisseurs électroniques alimentés en courant continu ou alternatif pour lampes à
incandescence
Ta slovenski standard je istoveten z: prEN IEC 61347-2-2:2023
ICS:
29.130.01 Stikalne in krmilne naprave Switchgear and controlgear
na splošno in general
29.140.99 Drugi standardi v zvezi z Other standards related to
žarnicami lamps
oSIST prEN IEC 61347-2-2:2023 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN IEC 61347-2-2:2023
---------------------- Page: 2 ----------------------
oSIST prEN IEC 61347-2-2:2023
34C/1579/CDV
COMMITTEE DRAFT FOR VOTE (CDV)
PROJECT NUMBER:
IEC 61347-2-2 ED3
DATE OF CIRCULATION: CLOSING DATE FOR VOTING:
2023-06-23 2023-09-15
SUPERSEDES DOCUMENTS:
34C/1552/CD, 34C/1560A/CC
IEC SC 34C : AUXILIARIES FOR LAMPS
SECRETARIAT: SECRETARY:
United Kingdom Mr Petar Luzajic
OF INTEREST TO THE FOLLOWING COMMITTEES: PROPOSED HORIZONTAL STANDARD:
Other TC/SCs are requested to indicate their interest, if
any, in this CDV to the secretary.
FUNCTIONS CONCERNED:
EMC ENVIRONMENT QUALITY ASSURANCE SAFETY
SUBMITTED FOR CENELEC PARALLEL VOTING NOT SUBMITTED FOR CENELEC PARALLEL VOTING
Attention IEC-CENELEC parallel voting
The attention of IEC National Committees, members of
CENELEC, is drawn to the fact that this Committee Draft
for Vote (CDV) is submitted for parallel voting.
The CENELEC members are invited to vote through the
CENELEC online voting system.
This document is still under study and subject to change. It should not be used for reference purposes.
Recipients of this document are invited to submit, with their comments, notification of any relevant patent rights of
which they are aware and to provide supporting documentation.
Recipients of this document are invited to submit, with their comments, notification of any relevant “In Some
Countries” clauses to be included should this proposal proceed. Recipients are reminded that the CDV stage is
the final stage for submitting ISC clauses. (SEE AC/22/2007 OR NEW GUIDANCE DOC).
TITLE:
Controlgear for electric light sources - Safety - Part 2-2: Particular requirements for electronic
step-down convertors for filament lamps
PROPOSED STABILITY DATE: 2027
NOTE FROM TC/SC OFFICERS:
Copyright © 2023 International Electrotechnical Commission, IEC. All rights reserved. It is permitted to
download this electronic file, to make a copy and to print out the content for the sole purpose of preparing
National Committee positions. You may not copy or "mirror" the file or printed version of the document, or any
part of it, for any other purpose without permission in writing from IEC.
---------------------- Page: 3 ----------------------
oSIST prEN IEC 61347-2-2:2023
IEC CDV 61347-2-2 © IEC 2023 2 34C/1579/CDV
1 CONTENTS
2 FOREWORD. 3
3 1 Scope . 6
4 2 Normative references . 6
5 3 Terms and definitions . 6
6 4 General requirements . 7
7 5 General notes on tests . 7
8 6 Marking . 7
9 6.1 Marking and information . 7
10 6.1.1 Mandatory marking . 7
11 6.1.2 Information to be provided . 7
12 6.2 Durability and legibility of marking . 7
13 6.3 Built-in and integral controlgear . 7
14 7 Terminals .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.