Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-44: Tests - Flexing of the strain relief of fibre optic devices

This part of IEC 61300 specifies a test to determine the influence of flexing under tensile load of the strain relief of fibre optic devices. The intention is to simulate the number of flexing cycles which would typically be experienced during service life. This test is applied to both single fibre cable and multiple fibre cable.

Lichtwellenleiter-Verbindungselemente und passive Bauteile- Grundlegende Prüf und Messverfahren - Teil 2-44: Prüfungen - Biegen der Zugentlastung von Lichtwellenleiterbauteilen

Dispositifs d'interconnexion et composants passifs à fibres optiques - Procédures fondamentales d’essais et de mesures - Partie 2-44: Essais - Flexion du serre-câble des dispositifs à fibres optiques

L'IEC 61300-2-44:2013 spécifie un essai pour déterminer l'influence de flexions sous une charge de traction du serre-câble des dispositifs à fibres optiques. L'objectif est de simuler le nombre de flexions généralement expérimenté en service. L'essai est appliqué sur des câbles à fibre unique et des câbles à fibres multiples. Cette troisième édition annule et remplace la deuxième édition parue en 2008, et constitue une révision technique. Cette édition inclut les modifications techniques majeures suivantes par rapport à l'édition précédente:
- révision de la Figure 1;
- modification de la longueur de fibre entre le point de flexion et le point d'application de la masse.
Mots clés: flexions sous une charge de traction du serre-câble des dispositifs à fibres optiques

Povezovalne naprave in pasivne komponente optičnih vlaken - Postopki osnovnega preskušanja in merjenja - 2-44. del: Preskusi - Spreminjanje natezne obremenitve povezovanja naprav z optičnimi vlaknii (IEC 61300-2-44:2013)

Ta del standarda IEC 61300 določa preizkus za določitev vpliva upogibanja pod natezno obremenitvijo na kabel naprav z optičnimi vlakni. Namen je simulacija različnih ciklov upogibanja, ki bi se lahko pojavili med uporabo naprave. Ta preizkus se uporablja za kable z enim vlaknom in kable z več vlakni.

General Information

Status
Published
Publication Date
18-Nov-2013
Technical Committee
Current Stage
6060 - National Implementation/Publication (Adopted Project)
Start Date
10-Oct-2013
Due Date
15-Dec-2013
Completion Date
19-Nov-2013

Relations

Buy Standard

Standard
EN 61300-2-44:2013
English language
12 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 61300-2-44:2013
01-december-2013
3RYH]RYDOQHQDSUDYHLQSDVLYQHNRPSRQHQWHRSWLþQLKYODNHQ3RVWRSNL
RVQRYQHJDSUHVNXãDQMDLQPHUMHQMDGHO3UHVNXVL6SUHPLQMDQMHQDWH]QH
REUHPHQLWYHSRYH]RYDQMDQDSUDY]RSWLþQLPLYODNQLL ,(&
Fibre optic interconnecting devices and passive components - Basic test and
measurement procedures - Part 2-44: Tests - Flexing of the strain relief of fibre optic
devices
Dispositifs d'interconnexion et composants passifs à fibres optiques - Procédures
fondamentales d’essais et de mesures - Partie 2-44: Essais - Flexion du serre-câble des
dispositifs à fibres optiques
Ta slovenski standard je istoveten z: EN 61300-2-44:2013
ICS:
33.180.20 3RYH]RYDOQHQDSUDYH]D Fibre optic interconnecting
RSWLþQDYODNQD devices
SIST EN 61300-2-44:2013 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 61300-2-44:2013

---------------------- Page: 2 ----------------------

SIST EN 61300-2-44:2013

EUROPEAN STANDARD
EN 61300-2-44

NORME EUROPÉENNE
September 2013
EUROPÄISCHE NORM

ICS 33.180.20 Supersedes EN 61300-2-44:2008


English version


Fibre optic interconnecting devices and passive components -
Basic test and measurement procedures -
Part 2-44: Tests -
Flexing of the strain relief of fibre optic devices
(IEC 61300-2-44:2013)


Dispositifs d'interconnexion et composants Lichtwellenleiter-Verbindungselemente
passifs à fibres optiques - und passive Bauteile- Grundlegende Prüf
Procédures fondamentales d’essais et de und Messverfahren -
mesures - Teil 2-44: Prüfungen -
Partie 2-44: Essais - Biegen der Zugentlastung von
Flexion du serre-câble des dispositifs à Lichtwellenleiterbauteilen
fibres optiques (IEC 61300-2-44:2013)
(CEI 61300-2-44:2013)



This European Standard was approved by CENELEC on 2013-08-19. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the CEN-CENELEC Management Centre or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the CEN-CENELEC Management Centre has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany,
Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.

CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

CEN-CENELEC Management Centre: Avenue Marnix 17, B - 1000 Brussels


© 2013 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 61300-2-44:2013 E

---------------------- Page: 3 ----------------------

SIST EN 61300-2-44:2013
EN 61300-2-44:2013 - 2 -

Foreword
The text of document 86B/3499/CDV, future edition 3 of IEC 61300-2-44, prepared by SC 86B, "Fibre
optic interconnecting devices and passive components", of IEC TC 86, "Fibre optics" was submitted to the
IEC-CENELEC parallel vote and approved by CENELEC as EN 61300-2-44:2013.
The following dates are fixed:
(dop) 2014-05-19
• latest date by which the document has
to be implemented at national level by
publication of an identical national
standard or by endorsement
• latest date by which the national (dow) 2014-08-19
standards conflicting with the

document have to be withdrawn

This document supersedes EN 61300-2-44:2008.
EN 61300-2-44:2013 includes the following significant technical changes with respect to
EN 61300-2-44:2008:
a) revision of Figure 1;
b) change of fibre length from the flex point to the weight.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC [and/or CEN] shall not be held responsible for identifying any or all such patent
rights.
Endorsement notice
The text of the International Standard IEC 61300-2-44:2013 was approved by CENELEC as a European
Standard without any modification.

---------------------- Page: 4 ----------------------

SIST EN 61300-2-44:2013
- 3 - EN 61300-2-44:2013
Annex ZA
(normative)

Normative references to internati
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.