ASTM F934-96(2008)
(Specification)Standard Specification for Standard Colors for Polymer-Coated Chain Link Fence Materials
Standard Specification for Standard Colors for Polymer-Coated Chain Link Fence Materials
ABSTRACT
This specification covers standard colors for coated chain link fence materials such as chain link fence fabric, tension wire, posts, rails, gate frames, and fittings. Standard polymer colors include dark green, olive green, brown, and black.
SCOPE
1.1 This specification covers standard colors for coated chain link fence materials such as chain link fence fabric, tension wire, posts, rails, gate frames, and fittings.
General Information
Relations
Standards Content (Sample)
NOTICE: This standard has either been superseded and replaced by a new version or withdrawn.
Contact ASTM International (www.astm.org) for the latest information
Designation:F934 −96(Reapproved 2008)
Standard Specification for
Standard Colors for Polymer-Coated Chain Link Fence
Materials
ThisstandardisissuedunderthefixeddesignationF934;thenumberimmediatelyfollowingthedesignationindicatestheyearoforiginal
adoption or, in the case of revision, the year of last revision.Anumber in parentheses indicates the year of last reapproval.Asuperscript
epsilon (´) indicates an editorial change since the last revision or reapproval.
1. Scope G90 Practice for Performing Accelerated Outdoor Weather-
ing of Nonmetallic Materials Using Concentrated Natural
1.1 This specification covers standard colors for coated
Sunlight
chain link fence materials such as chain link fence fabric,
tension wire, posts, rails, gate frames, and fittings.
3. Color
2. Referenced Documents
3.1 Unless otherwise stipulated by the purchaser, determine
2.1 ASTM Standards: the color in accordance with the standard contained in Table 1.
D1729 Practice for Visual Appraisal of Colors and Color
3.2 Determine compliance with this requirement by com-
Differences of Diffusely-Illuminated Opaque Materials
parison of specimens of the coated materials to standard flat
D2244 Practice for Calculation of Color Tolerances and
specimens of fused film of approximately the thickness speci-
Color Differences from Instrumentally Measured Color
fied for the coating to be applied to the materials, and
Coordinates
1 1
measuring at least 1 ⁄2 by 1 ⁄2 in. [38 by 38 mm].
3.3 Prepare standard flat specimens for the evaluation of
This specification is under the jurisdiction ofASTM Committee F14 on Fences
colorcoatingbyduplicatingtheproductionprocessasnearlyas
and is the direct responsibility of Subcommittee F14.40 on Chain Link Fence and
possible including temperature, particle size, etc.
Wire Accessories.
CurrenteditionapprovedJune1,2008.PublishedJuly2008.Originallyapproved
3.4 Determine the color of the standard flat specimens in
in 1985. Last previous edition approved in 2003 as F934 - 96(2003). DOI:
accordance with Test Method D2244 and Practice D1729.
10.1520/F0934-96R08.
For referenced ASTM standards, visit the ASTM website, www.ast
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.