EN ISO 734-2:2010

Oilseed meals - Determination of oil content - Part 2: Rapid extraction method (ISO 734-2:2008, corrected version 2009-06-01)

ISO 734-2:2008 specifies an extraction method which may be used to assess the efficiency of a de-oiling process by comparing the oil content of the oilseed with the residual oil content of the corresponding extraction meals, pellets and expeller cakes.
It is not applicable to disputed cases, for which ISO 734-1 is applicable.
It is applicable to oilseed meals obtained from oilseeds by expelling or by extraction with a solvent, as well as to the pellets made from the residues.

Ölsamenschrote - Bestimmung des Ölgehaltes - Teil 2: Schnellextraktionsverfahren (ISO 734-2:2008, korrigierte Fassung 2009-06-01)

Dieser Teil von ISO 734 legt ein Extraktionsverfahren fest, das zur Beurteilung der Wirksamkeit von Ölgewinnungsverfahren durch Vergleich des Ölgehaltes der Ölsamen mit dem Restölgehalt in den jeweiligen Extraktionsschroten, Pellets und Ölkuchen verwendet werden darf.
Das Verfahren ist nicht anwendbar auf strittige Fälle, für die ISO 734 1 anwendbar ist.
Das Verfahren ist anwendbar auf Ölsamenschrote, die durch Pressen oder durch Extraktion mit einem Lösemittel aus Ölsamen gewonnen wurden, sowie auf die aus den Rückständen hergestellten Pellets.

Tourteaux de graines oléagineuses - Détermination de la teneur en huile - Partie 2: Méthode rapide par extraction (ISO 734-2:2008, version corrigée 2009-06-01)

L'ISO 734-2:2008 spécifie une méthode par extraction permettant d'estimer le niveau d'efficacité du processus de délipidation par comparaison entre la teneur en huile d'un tourteau de graines oléagineuses et la teneur en huile résiduelle des farines, granulés et tourteaux en plaque correspondants.
Elle ne s'applique pas en cas de litige, auquel cas c'est l'ISO 734‑1 qui s'applique.
La présente partie de l'ISO 734 s'applique aux tourteaux de graines oléagineuses obtenus par pression ou par extraction des graines oléagineuses à l'aide d'un solvant, ainsi qu'aux granulés élaborés à partir de ces tourteaux.

Obroki iz oljnic - Določevanje olja - 2. del: Metoda hitre ekstrakcije (ISO 734-2:2008, popravljena verzija 2009-06-01)

Ta del ISO 734 določa metodo ekstrakcije, ki se lahko uporablja za ocenjevanje učinkovitosti postopka odstranjevanja olja z primerjavo vsebnosti olja oljnic z ostankom olja ustreznih ekstrahiranim obrokov, peletov in pogač.  Ne velja za sporne primere, za katere velja ISO 734-1. Velja za obroke iz oljnic, pridobljenih iz oljnic z izločanjem ali ekstrakcijo s topilom, in za pelete, izdelane iz ostankov.

General Information

• Status: Withdrawn
• Publication Date: 06-Apr-2010
• Withdrawal Date: 01-Dec-2015
• ICS: 67.200.20 - Oilseeds
• Technical Committee: CEN/TC 307 - Oilseeds, vegetables and animal fats and oils and their by-products - Methods of sampling and analys
• Drafting Committee: CEN/TC 307 - Oilseeds, vegetables and animal fats and oils and their by-products - Methods of sampling and analys
• Current Stage: 9960 - Withdrawal effective - Withdrawal
• Completion Date: 02-Dec-2015
• Ref Project: SIST EN ISO 734-2:2010 - Oilseed meals - Determination of oil content - Part 2: Rapid extraction method (ISO 734-2:2008, corrected version 2009-06-01)

Relations

• Replaces: EN ISO 734-2:2008 - Oilseed meals - Determination of oil content - Part 2: Rapid extraction method (ISO 734-2:2008)
• Effective Date: 08-Jun-2022
• Replaced By: EN ISO 22630:2015 - Oilseed meals - Determination of oil content - Rapid extraction method (ISO 22630:2015)
• Effective Date: 09-Dec-2015

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN ISO 734-2:2010
01-november-2010
1DGRPHãþD
SIST EN ISO 734-2:2009
2EURNLL]ROMQLF'RORþHYDQMHROMDGHO0HWRGDKLWUHHNVWUDNFLMH,62
SRSUDYOMHQDYHU]LMD
Oilseed meals - Determination of oil content - Part 2: Rapid extraction method (ISO 734-
2:2008, corrected version 2009-06-01)
Ölsamenschrote - Bestimmung des Ölgehaltes - Teil 2: Schnellextraktionsverfahren (ISO
734-2:2008, korrigierte Fassung 2009-06-01)
Tourteaux de graines oléagineuses - Détermination de la teneur en huile - Partie 2:
Méthode rapide par extraction (ISO 734-2:2008, version corrigée 2009-06-01)
Ta slovenski standard je istoveten z: EN ISO 734-2:2010
ICS:
67.200.20 Oljnice Oilseeds
SIST EN ISO 734-2:2010 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN ISO 734-2:2010

---------------------- Page: 2 ----------------------

SIST EN ISO 734-2:2010


EUROPEAN STANDARD
EN ISO 734-2

NORME EUROPÉENNE

EUROPÄISCHE NORM
April 2010
ICS 67.200.20 Supersedes EN ISO 734-2:2008
English Version
Oilseed meals - Determination of oil content - Part 2: Rapid
extraction method (ISO 734-2:2008, corrected version 2009-06-
01)
Tourteaux de graines oléagineuses - Détermination de la Ölsamenschrote - Bestimmung des Ölgehaltes - Teil 2:
teneur en huile - Partie 2: Méthode rapide par extraction Schnellextraktionsverfahren (ISO 734-2:2008, korrigierte
(ISO 734-2:2008, version corrigée 2009-06-01) Fassung 2009-06-01)
This European Standard was approved by CEN on 13 March 2010.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN Management Centre or to any CEN member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the
official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.






EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2010 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 734-2:2010: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN ISO 734-2:2010
EN ISO 734-2:2010 (E)
Contents Page
Foreword .3

2

---------------------- Page: 4 ----------------------

SIST EN ISO 734-2:2010
EN ISO 734-2:2010 (E)
Foreword
The text of ISO 734-2:2008, corrected version 2009-06-01 has been prepared by Technical Committee
ISO/TC 34 “Food products” of the International Organization for Standardization (ISO) and has been taken
over as EN ISO 734-2:2010 by Technical Committee CEN/TC 307 “Oilseeds, vegetable and animal fats and
oils and their by-products - Methods of sampling and analysis” the secretariat of which is held by AFNOR.
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by October 2010, and conflicting national standards shall be withdrawn at
the latest by October 2010.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN ISO 734-2:2008.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech
Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain,
Sweden, Switzerland and the United Kingdom.
Endorsement notice
The text of ISO 734-2:2008, corrected version 2009-06-01 has been approved by CEN as a EN ISO 734-
2:2010 without any modification.

3

---------------------- Page:
...