EN 14617-1:2005
(Main)Agglomerated stone - Test methods - Part 1: Determination of apparent density and water absorption
Agglomerated stone - Test methods - Part 1: Determination of apparent density and water absorption
This document specifies a method for determining the apparent density and water absorption of agglomerated stone products.
Künstlich hergestellter Stein - Prüfverfahren - Teil 1: Bestimmung der Rohdichte und der Wasseraufnahme
Dieses Dokument legt ein Verfahren zur Bestimmung der Rohdichte und der Wasseraufnahme von Produkten
aus künstlich hergestelltem Stein fest.
Pierre agglomérée - Méthodes d'essai - Partie 1: Détermination de la masse volumique apparente et du coefficient d'absorption d'eau
Le présent document spécifie une méthode de détermination de la masse volumique apparente et du coefficient d'absorption d'eau des produits en pierres agglomérées.
Aglomeriran kamen - Preskusne metode - 1. del: Ugotavljanje prostorninske mase in vpijanja vode
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-julij-2005
Aglomeriran kamen - Preskusne metode - 1. del: Ugotavljanje prostorninske mase
in vpijanja vode
Agglomerated stone - Test methods - Part 1: Determination of apparent density and
water absorption
Künstlich hergestellter Stein - Prüfverfahren - Teil 1: Bestimmung der Rohdichte und der
Wasseraufnahme
Pierre agglomérée - Méthodes d'essai - Partie 1: Détermination de la masse volumique
apparente et du coefficient d'absorption d'eau
Ta slovenski standard je istoveten z: EN 14617-1:2005
ICS:
91.100.15 Mineralni materiali in izdelki Mineral materials and
products
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD
EN 14617-1
NORME EUROPÉENNE
EUROPÄISCHE NORM
March 2005
ICS 91.100.15
English version
Agglomerated stone - Test methods - Part 1: Determination of
apparent density and water absorption
Pierre agglomérée - Méthodes d'essai - Partie 1: Künstlich hergestellter Stein - Prüfverfahren - Teil 1:
Détermination de la masse volumique apparente et du Bestimmung der Rohdichte und der Wasseraufnahme
coefficient d'absorption d'eau
This European Standard was approved by CEN on 3 February 2005.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the Central Secretariat or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official
versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2005 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 14617-1:2005: E
worldwide for CEN national Members.
Contents
Page
Foreword.3
1 Scope .4
2 Normative References.4
3 Terms and definitions .4
4 Apparatus .4
5 Preparation of the specimens .4
6 Test procedure.5
7 Expression of results .5
8 Test report .6
Bibliography .7
Foreword
This document (EN 14617-1:2005) has been prepared by Technical Committee CEN/TC 246 "Natural stones”, the
secretariat of which is held by UNI.
This European Standard shall be given the status of a national standard, either by publication of an identical text or
by endorsement, at the latest by September 2005, and conflicting national standards shall be withdrawn at the
latest by September 2005.
Test methods for agglomerated stones consist of the following:
EN 14617-1, Agglomerated stone - Test methods – Part 1: Determination of apparent density and water absorption
EN 14617-2, Agglomerated stone – Test methods – Part 2: Determination of flexural strength (bending)
prEN 14617-3, Agglomerated stone - Test methods – Part 3: Determination of slipperiness
EN 14617-4, Agglomerated stone - Test methods – Part 4: Determination of the abrasion resistance
EN 14617-5, Agglomerated stone - Test methods – Part 5: Determination of freeze and thaw resistance
EN 14617-6, Agglomerated stone - Test methods – Part 6: Determination of thermal shock resistance
prEN 14617-7, Agglomerated stone – Test methods – Part 7: Determination of ageing
prEN 14617-8, Agglomerated stone – Test methods – Part 8: Determination of resistance to fixing (dowel hole)
EN 14617-9, Agglomerated stone - Test methods – Part 9: Determination of impact resistance
EN 14617-10, Agglomerated stone – Test methods – Part 10: Determination of chemical resistance
EN 14617-11, Agglomerated stone – Test methods – Part 11: Determination of linear thermal expansion coefficient
EN 14617-12, Agglomerated stone – Test methods – Part 12: Determination of dimensional stability
EN 14617-13, Agglomerated stone – Test methods – Part 13: Determination of electrical resistivity
prEN 14617-14, Agglomerated stone – Test methods – Part 14: Determination of surface hardness
EN 14617-15, Agglomerated stone – Test methods – Part 15: Determination of compressive strength
EN 14617-16, Agglomerated stone – Test methods – Part 16: Determination of dimensions, geometric characteristics
and surface quality of modular tiles
prEN 14617-17, Agglomerated stone – Test methods – Part 17: Determination of biological resistance
According to the CEN
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.