EN ISO 3262-7:1998
(Main)Extenders for paints - Specifications and methods of test - Part 7: Dolomite (ISO 3262-7:1998)
Extenders for paints - Specifications and methods of test - Part 7: Dolomite (ISO 3262-7:1998)
Füllstoffe für Beschichtungsstoffe - Anforderungen und Prüfverfahren - Teil 7: Dolomit (ISO 3262-7:1998)
Dieser Teil von ISO 3262 legt Anforderungen und die entsprechenden Prüfverfahren für Dolomit fest.
Matières de charge pour peintures - Spécifications et méthodes d'essai - Partie 7: Dolomite (ISO 3262-7:1998)
Polnila za barve - Specifikacije in metode preskušanja - 7. del: Dolomit (ISO 3262-7:1998)
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-oktober-1998
Polnila za barve - Specifikacije in metode preskušanja - 7. del: Dolomit (ISO 3262-
7:1998)
Extenders for paints - Specifications and methods of test - Part 7: Dolomite (ISO 3262-
7:1998)
Füllstoffe für Beschichtungsstoffe - Anforderungen und Prüfverfahren - Teil 7: Dolomit
(ISO 3262-7:1998)
Matieres de charge pour peintures - Spécifications et méthodes d'essai - Partie 7:
Dolomite (ISO 3262-7:1998)
Ta slovenski standard je istoveten z: EN ISO 3262-7:1998
ICS:
87.060.10 Pigmenti in polnila Pigments and extenders
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
INTERNATIONAL ISO
STANDARD 3262-7
First edition
1998-07-01
Extenders for paints — Specifications and
methods of test —
Part 7:
Dolomite
Matières de charge pour peintures — Spécifications et méthodes d'essai —
Partie 7: Dolomite
A
Reference number
ISO 3262-7:1998(E)
ISO 3262-7:1998(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO
member bodies). The work of preparing International Standards is normally carried out through ISO technical
committees. Each member body interested in a subject for which a technical committee has been established has the
right to be represented on that committee. International organizations, governmental and non-governmental, in liaison
with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC)
on all matters of electrotechnical standardization.
Draft International Standards adopted by the technical committees are circulated to the member bodies for voting.
Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.
International Standard ISO 3262-7 was prepared by Technical Committee ISO/TC 35, Paints and varnishes,
Subcommittee SC 2, Pigments and extenders.
Together with the other parts (see below), this part of ISO 3262 cancels and replaces ISO 3262:1975, which has been
technically revised. Part 1 comprises the definition of the term extender and a number of test methods that are
applicable to most extenders, whilst part 2 and the following parts specify requirements and, where appropriate,
particular test methods for individual extenders.
At present, the following parts of ISO 3262 are published or in preparation, under the general title Extenders for
paints — Specifications and methods of test:
— Part 1: Introduction and general test methods
— Part 2: Barytes (natural barium sulfate)
— Part 3: Blanc fixe
— Part 4: Whiting
— Part 5: Natural crystalline calcium carbonate
— Part 6: Precipitated calcium carbonate
— Part 7: Dolomite
— Part 8: Natural clay
— Part 9: Calcined clay
© ISO 1998
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying and microfilm, without permission in writing from the publisher.
International Organization for Standardization
Case postale 56 • CH-1211 Genève 20 • Switzerland
Internet iso@iso.ch
Printed in Switzerland
ii
©
ISO ISO 3262-7:1998(E)
— Part 10: Natural talc/chlorite in lamellar form
— Part 11: Natural talc, in lamellar form, containing carbonates
— Part 12: Muscovite-type mica
— Part 13: Natural quartz (ground)
— Part 14: Cristobalite
— Part 15: Vitreous silica
— Part 16: Aluminium hydroxides
— Part 17: Precipitated calcium silicate
— Part 18: Precipitated sodium aluminium silicate
— P
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.