prEN ISO 18862

Coffee and coffee products - Determination of acrylamide - Methods using HPLC-MS/MS and GC-MS after derivatization (ISO/DIS 18862:2024)

ISO 18862:2016 specifies methods for the determination of acrylamide in coffee and coffee products by extraction with water, clean-up by solid-phase extraction and determination by HPLC-MS/MS and GC-MS. It was validated in a method validation study on roasted coffee, soluble coffee, coffee substitutes and coffee products with ranges from 53 μg/kg to 612,1 μg/kg.

Kaffee und Kaffee-Erzeugnisse- Bestimmung von Acrylamid- Verfahren mittels HPLC-MS/MS und mittels GC-MS nach Derivatisierung (ISO/DIS 18862:2024)

Café et dérivés du café - Dosage de l'acrylamide - Méthodes par CLHP-SM/SM et CG-SM après dérivation (ISO/DIS 18862:2024)

Le présent document spécifie des méthodes de dosage de l'acrylamide dans le café et les dérivés du café par extraction à l'eau, purification par extraction en phase solide et dosage par CLHP-SM/SM et CG-SM. Il a été validé au cours d'une étude de validation de la méthode réalisée sur du café torréfié, du café soluble, des substituts de café et des dérivés du café dans des plages de concentration allant de 53 μg/kg à 612,1 μg/kg.

Kava in proizvodi iz kave - Določevanje akrilamida - Metode z uporabo HPLC-MS/MS in GC-MS po derivatizaciji (ISO/DIS 18862:2024)

General Information

• Status: Not Published
• Publication Date: 08-Mar-2026
• ICS: 67.140.20 - Coffee and coffee substitutes
• Technical Committee: CEN/TC 275 - Food analysis - Horizontal methods
• Drafting Committee: CEN/TC 275/WG 13 - Neoformed contaminants
• Current Stage: 4060 - Closure of enquiry - Enquiry
• Start Date: 08-Nov-2024
• Completion Date: 08-Nov-2024
• Ref Project: oSIST prEN ISO 18862:2024 - Coffee and coffee products - Determination of acrylamide - Methods using HPLC-MS/MS and GC-MS after derivatization (ISO/DIS 18862:2024)

Relations

• Revises: EN ISO 18862:2019 - Coffee and coffee products - Determination of acrylamide - Methods using HPLC-MS/MS and GC-MS after derivatization (ISO 18862:2016)
• Effective Date: 05-Jun-2024

Standards Content (Sample)

SLOVENSKI STANDARD
01-oktober-2024
Kava in proizvodi iz kave - Določevanje akrilamida - Metode z uporabo HPLC-
MS/MS in GC-MS po derivatizaciji (ISO/DIS 18862:2024)
Coffee and coffee products - Determination of acrylamide - Methods using HPLC-MS/MS
and GC-MS after derivatization (ISO/DIS 18862:2024)
Kaffee und Kaffee-Erzeugnisse- Bestimmung von Acrylamid- Verfahren mittels HPLC-
MS/MS und mittels GC-MS nach Derivatisierung (ISO/DIS 18862:2024)
Café et dérivés du café - Dosage de l'acrylamide - Méthodes par CLHP-SM/SM et CG-
SM après dérivation (ISO/DIS 18862:2024)
Ta slovenski standard je istoveten z: prEN ISO 18862
ICS:
67.140.20 Kava in kavni nadomestki Coffee and coffee substitutes
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

DRAFT
International
Standard
ISO/DIS 18862
ISO/TC 34/SC 15
Coffee and coffee products —
Secretariat: ICONTEC
Determination of acrylamide —
Voting begins on:
Methods using HPLC-MS/MS and GC-
2024-08-16
MS after derivatization
Voting terminates on:
2024-11-08
Café et dérivés du café — Dosage de l'acrylamide — Méthodes
par CLHP-SM/SM et CG-SM après dérivation
ICS: 67.140.20
THIS DOCUMENT IS A DRAFT CIRCULATED
FOR COMMENTS AND APPROVAL. IT
IS THEREFORE SUBJECT TO CHANGE
AND MAY NOT BE REFERRED TO AS AN
INTERNATIONAL STANDARD UNTIL
PUBLISHED AS SUCH.
This document is circulated as received from the committee secretariat.
IN ADDITION TO THEIR EVALUATION AS
BEING ACCEPTABLE FOR INDUSTRIAL,
TECHNOLOGICAL, COMMERCIAL AND
USER PURPOSES, DRAFT INTERNATIONAL
STANDARDS MAY ON OCCASION HAVE TO
ISO/CEN PARALLEL PROCESSING
BE CONSIDERED IN THE LIGHT OF THEIR
POTENTIAL TO BECOME STANDARDS TO
WHICH REFERENCE MAY BE MADE IN
NATIONAL REGULATIONS.
RECIPIENTS OF THIS DRAFT ARE INVITED
TO SUBMIT, WITH THEIR COMMENTS,
NOTIFICATION OF ANY RELEVANT PATENT
RIGHTS OF WHICH THEY ARE AWARE AND TO
PROVIDE SUPPORTING DOCUMENTATION.
Reference number
ISO/DIS 18862:2024(en)
DRAFT
ISO/DIS 18862:2024(en)
International
Standard
ISO/DIS 18862
ISO/TC 34/SC 15
Coffee and coffee products —
Secretariat: ICONTEC
Determination of acrylamide —
Voting begins on:
Methods using HPLC-MS/MS and GC-
MS after derivatization
Voting terminates on:
Café et dérivés du café — Dosage de l'acrylamide — Méthodes
par CLHP-SM/SM et CG-SM après dérivation
ICS: 67.140.20
THIS DOCUMENT IS A DRAFT CIRCULATED
FOR COMMENTS AND APPROVAL. IT
IS THEREFORE SUBJECT TO CHANGE
AND MAY NOT BE REFERRED TO AS AN
INTERNATIONAL STANDARD UNTIL
PUBLISHED AS SUCH.
This document is circulated as received from the committee secretariat.
IN ADDITION TO THEIR EVALUATION AS
BEING ACCEPTABLE FOR INDUSTRIAL,
© ISO 2024
TECHNOLOGICAL, COMMERCIAL AND
USER PURPOSES, DRAFT INTERNATIONAL
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
STANDARDS MAY ON OCCASION HAVE TO
ISO/CEN PARALLEL PROCESSING
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
BE CONSIDERED IN THE LIGHT OF THEIR
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
POTENTIAL TO BECOME STANDARDS TO
WHICH REFERENCE MAY BE MADE IN
or ISO’s member body in the country of the requester.
NATIONAL REGULATIONS.
ISO copyright office
RECIPIENTS OF THIS DRAFT ARE INVITED
CP 401 • Ch. de Blandonnet 8
TO SUBMIT, WITH THEIR COMMENTS,
CH-1214 Vernier, Geneva
NOTIFICATION OF ANY RELEVANT PATENT
Phone: [phone]
RIGHTS OF WHICH THEY ARE AWARE AND TO
PROVIDE SUPPORTING DOCUMENTATION.
Email: [e-mail]
Website: www.iso.org
Published in Switzerland Reference number
ISO/DIS 18862:2024(en)
ii
ISO/DIS 18862:2024(en)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principle . 1
5 Reagents . 1
6 Apparatus . 3
7 Sampling . 4
8 Procedure . 4
8.1 General .4
8.2 Preparation of the sample extract .4
8.3 Clean-up of the extracts .5
8.3.1 Carrez precipitation .5
8.3.2 Solid phase extraction .5
8.4 HPLC-MS/MS measurement . .5
8.4.1 High-performance liquid chromatography (HPLC) .5
8.4.2 Identification and quantification by mass spectrometry (HPLC-MS/MS) .5
8.5 Measurement with GC-MS .6
8.5.1 Derivatization and sample preparation for gas chromatography .6
8.5.2 Gas chromatography .6
8.5.3 Identification and quantification by mass spectrometry .6
9 Calibration . 7
9.1 General advice .7
9.2 Determination of linearity and definition of the working range .7
9.3 Calibration with internal standard solution .7
9.4 Determination of the laboratory specific recovery .7
10 Evaluation . 7
10.1 Criteria for identification .7
10.2 Calculation and final results .8
11 Precision data . 8
11.1 General .8
11.2 Repeatability .8
11.3 Reproducibility .8
11.4 Recovery .9
12 Measurement uncertainty . 9
13 Test report . 9
Annex A (informative) Performance characteristics . 10
Annex B (informative) Examples of absorber materials .11
Annex C (informative) Examples of columns and analysis conditions.12
Annex D (Informative) Examples for sample preparation and chromatographic conditions
using LC-MS/MS .18
Bibliography .25

iii
ISO/DIS 18862:2024(en)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out through
ISO technical committees. Each member body interested in a subject for which a technical committee
has been established has the right to be represented on that committee. International organizations,
governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely
with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are described
in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the different types
of ISO documents should be noted. This document was drafted in accordance with the editorial rules of the
ISO/IEC Directives, Part 2 (see www.iso.org/directives).
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of any patent
rights identified during the development of the document will be in the Introduction and/or on the ISO list of
patent declarations received (see www.iso.org/patents).
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation on the meaning of ISO specific terms and expressions related to conformity assessment,
as well as information about ISO's adherence to the World Trade Organization (WTO) principles in the
Technical Barriers
...