EN 3841-510:2004

Aerospace series - Circuit breakers - Test methods - Part 510: Strength of signal contact terminals

This standard specifies a method of verifying the strength of signal contact terminals of circuit breakers.
It shall be used together with EN 3841-100.

Luft- und Raumfahrt - Schutzschalter - Prüfverfahren - Teil 510: Festigkeit der Signalkontakt-Anschlüsse

Série aérospatiale - Disjoncteurs - Méthodes d'essais - Partie 510 : Résistance des éléments de raccordement auxiliaires

La présente norme spécifie une méthode pour vérifier la résistance des éléments de raccordement auxiliaires des disjoncteurs.
Elle doit être utilisée conjointement avec EN 3841-100.

Aeronavtika - Odklopniki - 510. del: Trdnost priključkov signalnih kontaktov

General Information

• Status: Published
• Publication Date: 21-Dec-2004
• Withdrawal Date: 29-Jun-2005
• ICS: 49.060 - Aerospace electric equipment and systems
• Technical Committee: ASD-STAN - Aerospace
• Drafting Committee: ASD-STAN/D 2 - Electrical
• Current Stage: 6060 - Definitive text made available (DAV) - Publishing
• Start Date: 22-Dec-2004
• Completion Date: 22-Dec-2004
• Ref Project: SIST EN 3841-510:2005 - Aerospace series - Circuit breakers - Test methods - Part 510: Strength of signal contact terminals

Standards Content (Sample)

SLOVENSKI STANDARD
01-april-2005
$HURQDYWLND2GNORSQLNLGHO7UGQRVWSULNOMXþNRYVLJQDOQLKNRQWDNWRY
Aerospace series - Circuit breakers - Test methods - Part 510: Strength of signal contact
terminals
Luft- und Raumfahrt - Schutzschalter - Prüfverfahren - Teil 510: Festigkeit der
Signalkontakt-Anschlüsse
Série aérospatiale - Disjoncteurs - Méthodes d'essais - Partie 510 : Résistance des
éléments de raccordement auxiliaires
Ta slovenski standard je istoveten z: EN 3841-510:2004
ICS:
49.060 /HWDOVNDLQYHVROMVND Aerospace electric
HOHNWULþQDRSUHPDLQVLVWHPL equipment and systems
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD
EN 3841-510
NORME EUROPÉENNE
EUROPÄISCHE NORM
December 2004
ICS 49.060
English version
Aerospace series - Circuit breakers - Test methods - Part 510:
Strength of signal contact terminals
Série aérospatiale - Disjoncteurs - Méthodes d'essais - Luft- und Raumfahrt - Schutzschalter - Prüfverfahren - Teil
Partie 510 : Résistance des éléments de raccordement 510: Festigkeit der Signalkontakt-Anschlüsse
auxiliaires
This European Standard was approved by CEN on 10 September 2004.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the Central Secretariat or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official
versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2004 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 3841-510:2004: E
worldwide for CEN national Members.

Contents Page
Foreword.3
1 Scope .4
2 Normative references .4
3 Method .4

Foreword
This document (EN 3841-510:2004) has been prepared by the European Association of Aerospace
Manufacturers -
...