EN 60195:2016

Method of measurement of current noise generated in fixed resistors

IEC 60195:2016 specifies a method of measurement and associated test conditions to assess the "noisiness", or magnitude of current noise, generated in fixed resistors of any given type. The method applies to all classes of fixed resistors. The aim is to provide comparable results for the determination of the suitability of resistors for use in electronic circuits having critical noise requirements. This edition includes the following significant technical changes with respect to the previous edition: - harmonization of the allocation of isolation resistors RM in the recommended operating conditions given in Table 2; - correction of erroneous numeric values of the contribution of system noise, f(T - S) in Table 3; - addition of advice on the prescription of requirements in a relevant component specification; - addition of a set of recommended measuring conditions for specimens with a rated dissipation of less than 100 mW; - complete editorial revision.

Messverfahren für das Stromrauschen in Festwiderständen

Méthode pour la mesure du bruit produit en charge par les résistances fixes

L'IEC 60195:2016 spécifie une méthode de mesure et des conditions d'essai associées pour évaluer l'absence de bruit ou l'amplitude du bruit en charge généré dans des résistances fixes d'un type quelconque. La méthode s'applique à toutes les classes de résistances fixes. Elle a pour but de fournir des résultats comparables pour déterminer l'aptitude des résistances utilisées dans des circuits électroniques dont les exigences relatives au bruit sont critiques. Cette édition inclut les modifications techniques majeures suivantes par rapport à l'édition précédente: - harmonisation de l'affectation des résistances d'isolement RM dans les conditions de fonctionnement recommandées données dans le Tableau 2; - correction des valeurs numériques erronées de la contribution du bruit du système, f(T - S) dans le Tableau 3; - ajout d'un conseil pour prescrire des exigences dans une spécification de composant applicable; - ajout d'un ensemble de conditions de mesure recommandées pour des spécimens dont la dissipation assignée est inférieure à 100 mW; - révision éditoriale complète.

Metoda za merjenje tokovnega šuma, ki ga povzročajo stalni upori (IEC 60195:2016)

Ta mednarodni standard določa metodo za merjenje in s tem povezane preskusne pogoje za vrednotenje »šumnosti« ali razsežnosti tokovnega šuma, ki ga povzročajo stalni upori katere koli vrste. Metoda se uporablja za vse razrede stalnih uporov. Cilj je zagotoviti primerljive rezultate za določitev ustreznosti uporov za uporabo v elektronskih vezjih, za katere veljajo zahteve glede kritičnega šuma.
Tokovni šum v uporovnih materialih kaže na zrnato strukturo takšnega materiala. Za nekatere uporovne tehnologije, ki uporabljajo homogene plasti, se upošteva kot pokazatelj napak, ki so obravnavane kot glavni vzrok za neobičajno staranje sestavnega dela pod vplivom temperature in časa.
Metoda, opisana v tem mednarodnem standardu, ni zahteva iz splošne specifikacije, zato se uporablja, če jo predpisuje specifikacija ustreznega sestavnega dela ali se o tem dogovorita kupec in proizvajalec.

General Information

• Status: Published
• Publication Date: 14-Jul-2016
• ICS: 31.040.10 - Fixed resistors
• Technical Committee: CLC/TC 40XB - CLC/TC 40XB
• Drafting Committee: IEC/TC 40 - IEC_TC_40
• Current Stage: 9093 - Decision to confirm - Review Enquiry
• Completion Date: 03-Apr-2019
• Ref Project: SIST EN 60195:2016 - Method of measurement of current noise generated in fixed resistors (IEC 60195:2016)

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 60195:2016
01-oktober-2016
0HWRGD]DPHUMHQMHWRNRYQHJDãXPDNLJDSRY]URþDMRVWDOQLXSRUL,(&

Method of measurement of current noise generated in fixed resistors (IEC 60195:2016)
Ta slovenski standard je istoveten z: EN 60195:2016
ICS:
17.140.20 Emisija hrupa naprav in Noise emitted by machines
opreme and equipment
31.040.10 Fiksni upor Fixed resistors
SIST EN 60195:2016 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 60195:2016

---------------------- Page: 2 ----------------------

SIST EN 60195:2016


EUROPEAN STANDARD EN 60195

NORME EUROPÉENNE

EUROPÄISCHE NORM
July 2016
ICS 31.040.10

English Version
Method of measurement of current noise generated in fixed
resistors
(IEC 60195:2016)
Méthode pour la mesure du bruit produit en charge par les Messverfahren für das Stromrauschen in Festwiderständen
résistances fixes (IEC 60195:2016)
(IEC 60195:2016)
This European Standard was approved by CENELEC on 2016-05-12. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.



European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2016 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
 Ref. No. EN 60195:2016 E

---------------------- Page: 3 ----------------------

SIST EN 60195:2016
EN 60195:2016
European foreword
The text of document 40/2431/FDIS, future edition 2 of IEC 60195, prepared by IEC/TC 40
“Capacitors and resistors for electronic equipment" was submitted to the IEC-CENELEC parallel vote
and approved by CENELEC as EN 60195:2016.

The following dates are fixed:
(dop) 2017-02-12
• latest date by which the document has to be
implemented at national level by
publication of an identical national
standard or by endorsement
• latest date by which the national (dow) 2019-05-12
standards conflicting with the
document have to be withdrawn


Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC [and/or CEN] shall not be held responsible for identifying any or all such
patent rights.
Endorsement notice
The text of the International Standard IEC 60195:2016 was approved by CENELEC as a European
Standard without any modification.
In the official version, for Bibliography, the following notes have to be added for the standards
indicated:

IEC 60027 (series) NOTE Harmonized as EN 60027 (series).

2

---------------------- Page: 4 ----------------------

SIST EN 60195:2016
 EN 60195:2016

Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications
The following documents, in whole or in part, are normatively referenced in this document and are
indispensable for its application. For dated references, only the edition cited applies. For undated
references, the latest edition of the referenced document (including any amendments) applies.
NOTE 1 When an International Publication has been modified by common modifications, indicated by (mod), the relevant

EN/HD applies.

NOTE 2 Up-to-date information on the latest versions of the European Standards listed in this annex is available here:
www.cenelec.eu.
Publication Year Title EN/HD Year
IEC 60068-1 2013 Environmental testing -- Part 1: General EN 60068-1 2014
and guidance

3

---------------------- Page: 5 ----------------------

SIST EN 60195:2016

---------------------- Page: 6 ----------------------

SIST EN 60195:2016



IEC 60195

®


Edition 2.0 2016-04




INTERNATIONAL



STANDARD



...