IEC 60335-2-30:2009/AMD1:2016

Amendment 1 - Household and similar electrical appliances - Safety - Part 2-30: Particular requirements for room heaters

Amendement 1 - Appareils électrodomestiques et analogues - Sécurité - Partie 2-30: Règles particulières pour les appareils de chauffage des locaux

General Information

• Status: Published
• Publication Date: 15-Nov-2016
• ICS: 01 - GENERALITIES. TERMINOLOGY. STANDARDIZATION. DOCUMENTATION
• ICS: 13.120 - Domestic safety
• ICS: 97.100.10 - Electric heaters
• Technical Committee: TC 61 - Safety of household and similar electrical appliances
• Current Stage: PPUB - Publication issued
• Start Date: 31-Dec-2016
• Completion Date: 16-Nov-2016

Relations

• Amends: IEC 60335-2-30:2009 - Household and similar electrical appliances - Safety -Part 2-30: Particular requirements for room heaters
• Effective Date: 05-Sep-2023

Standards Content (Sample)

IEC 60335-2-30 ®
Edition 5.0 2016-11
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
colour
inside
A MENDMENT 1
AM ENDEMENT 1
Household and similar electrical appliances – Safety –
Part 2-30: Particular requirements for room heaters

Appareils électrodomestiques et analogues – Sécurité –
Partie 2-30: Exigences particulières pour les appareils de chauffage des locaux

IEC 60335-2-30:2009-11/AMD1:2016-11(en-fr)

All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form
or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from
either IEC or IEC's member National Committee in the country of the requester. If you have any questions about IEC
copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or
your local IEC member National Committee for further information.

Droits de reproduction réservés. Sauf indication contraire, aucune partie de cette publication ne peut être reproduite
ni utilisée sous quelque forme que ce soit et par aucun procédé, électronique ou mécanique, y compris la photocopie
et les microfilms, sans l'accord écrit de l'IEC ou du Comité national de l'IEC du pays du demandeur. Si vous avez des
questions sur le copyright de l'IEC ou si vous désirez obtenir des droits supplémentaires sur cette publication, utilisez
les coordonnées ci-après ou contactez le Comité national de l'IEC de votre pays de résidence.

IEC Central Office Tel.: [phone]
3, rue de Varembé Fax: [phone]
CH-1211 Geneva 20 [e-mail]
Switzerland www.iec.ch
About the IEC
The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes
International Standards for all electrical, electronic and related technologies.

About IEC publications
The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the
latest edition, a corrigenda or an amendment might have been published.

IEC Catalogue - webstore.iec.ch/catalogue Electropedia - www.electropedia.org
The stand-alone application for consulting the entire The world's leading online dictionary of electronic and
bibliographical information on IEC International Standards, electrical terms containing 20 000 terms and definitions in
Technical Specifications, Technical Reports and other English and French, with equivalent terms in 15 additional
documents. Available for PC, Mac OS, Android Tablets and languages. Also known as the International Electrotechnical
iPad. Vocabulary (IEV) online.

IEC publications search - www.iec.ch/searchpub IEC Glossary - std.iec.ch/glossary
The advanced search enables to find IEC publications by a 65 000 electrotechnical terminology entries in English and
variety of criteria (reference number, text, technical French extracted from the Terms and Definitions clause of
committee,…). It also gives information on projects, replaced IEC publications issued since 2002. Some entries have been
and withdrawn publications. collected from earlier publications of IEC TC 37, 77, 86 and

CISPR.
IEC Just Published - webstore.iec.ch/justpublished
Stay up to date on all new IEC publications. Just Published IEC Customer Service Centre - webstore.iec.ch/csc
details all new publications released. Available online and If you wish to give us your feedback on this publication or
also once a month by email. need further assistance, please contact the Customer Service
Centre: [e-mail].
A propos de l'IEC
La Commission Electrotechnique Internationale (IEC) est la première organisation mondiale qui élabore et publie des
Normes internationales pour tout ce qui a trait à l'électricité, à l'électronique et aux technologies apparentées.

A propos des publications IEC
Le contenu technique des publications IEC est constamment revu. Veuillez vous assurer que vous possédez l’édition la
plus récente, un corrigendum ou amendement peut avoir été publié.

Catalogue IEC - webstore.iec.ch/catalogue Electropedia - www.electropedia.org
Application autonome pour consulter tous les renseignements Le premier dictionnaire en ligne de termes électroniques et
bibliographiques sur les Normes internationales, électriques. Il contient 20 000 termes et définitions en anglais
Spécifications techniques, Rapports techniques et autres et en français, ainsi que les termes équivalents dans 15
documents de l'IEC. Disponible pour PC, Mac OS, tablettes langues additionnelles. Egalement appelé Vocabulaire
Android et iPad. Electrotechnique International (IEV) en ligne.

Recherche de publications IEC - www.iec.ch/searchpub Glossaire IEC - std.iec.ch/glossary
La recherche avancée permet de trouver des publications IEC 65 000 entrées terminologiques électrotechniques, en anglais
en utilisant différents critères (numéro de référence, texte, et en français, extraites des articles Termes et Définitions des
comité d’études,…). Elle donne aussi des informations sur les publications IEC parues depuis 2002. Plus certaines entrées
projets et les publications remplacées ou retirées. antérieures extraites des publications des CE 37, 77, 86 et

CISPR de l'IEC.
IEC Just Published - webstore.iec.ch/justpublished

Restez informé sur les nouvelles publications IEC. Just Service Clients - webstore.iec.ch/csc
Published détaille les nouvelles publications parues. Si vous désirez nous donner des commentaires sur cette
Disponible en ligne et aussi une fois par mois par email. publication ou si vous avez des questions contactez-nous:
[e-mail].
IEC 60335-2-30 ®
Edition 5.0 2016-11
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
colour
inside
A MENDMENT 1
AM ENDEMENT 1
Household and similar electrical appliances – Safety –

Part 2-30: Particular requirements for room heaters

Appareils électrodomestiques et analogues – Sécurité –

Partie 2-30: Exigences particulières pour les appareils de chauffage des locaux

INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
INTERNATIONALE
ICS 13.120, 97.100.10 ISBN 978-2-8322-3729-8

– 2 – IEC 60335-2-30:2009/AMD1:2016
© IEC 2016
FOREWORD
This amendment has been prepared by IEC technical committee 61: Safety of household and
similar electrical appliances.
The text of this amendment is based on the following documents:
FDIS Report on voting
61/5281/FDIS 61/5298/RVD
Full information on the voting for the approval of this amendment can be found in the report
on voting indicated in the above table.
The committee has decided that the contents of this amendment and the base publication will
remain unchanged until the stability date indicated on the IEC web site under
"http://webstore.iec.ch" in the data related to the specific publication. At this date, the
publication will be
• reconfirmed,
• withdrawn,
• replaced by a revised edition, or
• amended.
NOTE The attention of National Committees is drawn to the fact that equipment manufacturers and testing
organizations may need a transitional period following publication of a new, amended or revised IEC publication in
which to make products in accordance with the new requirements and to equip themselves for conducting new or
revised tests.
It is the recommendation of the committee that the content of this publication be adopted for implementation
nationally not earlier than 12 months or later than 36 months from the date of publication.

IMPORTANT – The 'colour inside' logo on the cover page of this publication indicates
that it contains colours which are considered to be useful for the correct
understanding of its contents. Users should therefore print this document using a
colour printer.
_____________
CONTENTS
Replace the title of Clause 3 by the following:
Terms and definitions
FOREWORD
In the list of differences existing in countries, delete the difference listed for Australia
concerning 11.8.
© IEC 2016
1 Scope
Add the following new dashed item to Note 101:
– cab heaters;
Add the following text as a new third paragraph:
This standard also deals with the safety of electric heaters intended for the heating of driver
and passenger compartments of motor vehicles when they are stationary, their rated voltage
being not more than 250 V.
In the first dashed item of Note 102 replace “vehicles” by “moving vehicles”.
Add the following new dashed item to Note 103:
– heaters intended for the heating of caravans.
2 Normative references
Add the following new reference:
IEC 60068-2-6:2007, Environmental testing – Part 2-6: Tests – Test Fc: Vibration (sinusoidal)
3 Definitions
Replace the title of Clause 3 but not the clause number, by the following:
Terms and definitions
Add the following new definition:
3.107
cab heater
fan heater for the heating of driver and passenger compartments of motor vehicles when the
vehicle is stationary
5 General conditions for the tests
5.2 Add the following to the addition:
Three additional samples are needed for the test of 19.113. The test of 19.117 is carried out
on one of these samples.
The test of 21.104 is carried out on a separate appliance.
The test of 21.106 is carried out on a separate appliance.
7 Marking and instructions
7.1 In the second paragraph of the addition, replace "except for colours" by "with or without
colours".
Add the following new text to the addition:

– 4 – IEC 60335-2-30:2009/AMD1:2016
© IEC 2016
Cab heaters shall be marked with the following:
Cab heater
Add the following new subclause:
7.10 Addition:
The different positions of switches and controls on room heaters shall be indicated by figures,
letters or other visual means. This requirement also applies to switches that are part of a
control.
The on position shall be clearly visible to the user when the heater is in its intended position
of use.
7.12 Replace the seventh paragraph of the addition by the following:
The instructions for portable heaters shall include the substance of the following:
– do not use this heater in the immediate surroundings of a bath, a shower or a swimming
pool;
– do not use this heater if it has been dropped;
– do not use if there are visible signs of damage to the heater;
– use this heater on a horizontal and stable surface, or fix it to the wall, as applicable.
Replace the last paragraph of the addition with the following:
The instructions for portable heaters shall include the substance of the following:
WARNING: Do not use this heater in small rooms when they are occupied by persons
not capable of leaving the room on their own, unless constant supervision is
provided.
WARNING: To reduce the risk of fire, keep textiles, curtains, or any other flammable
material a minimum distance of 1 m from the air outlet.
7.12.1 Add the following new paragraph to the addition:
The installation instructions for cab heaters shall state
– the shortest permissible distance between the heater outlet and the interior surfaces of the
motor vehicle;
– that the installation shall be in accordance with any instructions issued by the vehicle
manufacturer.
11 Heating
11.2 Add the following text to the addition as a new third paragraph:
Fixed heaters having a supply cord fitted with a plug are mounted in front of a flush
mounted type socket-outlet installed in the wall of the test corner with the plug inserted unless
– the distance between the heater and the wall does not exceed 30 mm; or
– the instructions state that the heater shall not be located in front of a socket-outlet.
Add the following new paragraphs:

© IEC 2016
For ceiling mounted heat lamp appliances, means for ventilation or ducting are provided in
accordance with the installation instructions.
Cab heaters are placed in the test corner as follows:
A test box as shown in Figure 103 and made of dull black-painted plywood approximately
20 mm thick is used. The wall A can be positioned at different distances from the far end of
the test box.
NOTE 104 The test box simulates the front driver/passenger compartment of a motor vehicle. One wall of the test
corner simulates the driver’s door.
The test box is placed in the test corner, with side B against one wall of the test corner and
the sloping end of the test box against the other wall of the test corner. The test corner shall
be at least 470 mm wide, 760 mm deep and 470 mm high.
NOTE 105 Wall B of the test box, as well as its bottom, can be open to facilitate access before and after the test.
The cab heater is placed in the test box in the most unfavourable position according to the
manufacturer's instructions, if it will fit into the test box, and with the distance L = 0 mm. The
shortest distance to the wall of the test box shall not be less than that stated in the
manufacturer's instructions for the shortest permissible distance between the heater outlet
and the interior surfaces of the motor vehicle. The wall A of the test box may be moved to
increase L to a maximum distance L = 220 mm.
If the manufacturer has not supplied any instructions for the placing of the cab heater or if the
heater cannot fit in the test box, the cab heater is placed in the most unfavourable position on
the floor of the test corner. Heaters containing PTC heating elements are placed away from
the walls if this will lead to higher temperatures.
11.8 Add the following new text to the addition:
For fixed heaters mounted in front of a socket-outlet, the temperature rise of the plug shall
not exceed 45 K.
During the test for cab heaters, the temperature rise of the walls of the cab heater test box
and the test corner shall not exceed 65 K.
The temperature rise of surfaces of cab heaters shall not exceed the values shown in
Table 102.
Table 102 – Maximum temperature rise for surfaces of cab heaters
Surface Temperature rise
K
Parts of the heater exposed to am
...