IEC 60728-1:2007
(Main)Cable networks for television signals, sound signals and interactive services - Part 1: System performance of forward paths
Cable networks for television signals, sound signals and interactive services - Part 1: System performance of forward paths
It deal with cable networks including equipment and associated methods of measurement for headend reception, processing and distribution of television signals, sound signals and their associated data signals and for processing, interfacing and transmitting all kinds of signals for interactive services using all applicable transmission media. This edition includes the following significant technical changes with respect to the previous edition: redrafting of introduction and scope to reflect the current scope of IEC TC 100/TA 5; redrafting of measurement procedure for bit error ratio (BER); updating of performance requirements in Clause 5; inclusion of new Clause 6; inclusion of new Clause 7; inclusion of new Annex K.
General Information
Relations
Standards Content (Sample)
IEC 60728-1
Edition 4.0 2007-09
INTERNATIONAL
STANDARD
Cable networks for television signals, sound signals and interactive services –
Part 1: System performance of forward paths
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form
or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from
either IEC or IEC's member National Committee in the country of the requester.
If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication,
please contact the address below or your local IEC member National Committee for further information.
IEC Central Office
3, rue de Varembé
CH-1211 Geneva 20
Switzerland
Email: inmail@iec.ch
Web: www.iec.ch
About the IEC
The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes
International Standards for all electrical, electronic and related technologies.
About IEC publications
The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the
latest edition, a corrigenda or an amendment might have been published.
ƒ Catalogue of IEC publications: www.iec.ch/searchpub
The IEC on-line Catalogue enables you to search by a variety of criteria (reference number, text, technical committee,…).
It also gives information on projects, withdrawn and replaced publications.
ƒ IEC Just Published: www.iec.ch/online_news/justpub
Stay up to date on all new IEC publications. Just Published details twice a month all new publications released. Available
on-line and also by email.
ƒ Electropedia: www.electropedia.org
The world's leading online dictionary of electronic and electrical terms containing more than 20 000 terms and definitions
in English and French, with equivalent terms in additional languages. Also known as the International Electrotechnical
Vocabulary online.
ƒ Customer Service Centre: www.iec.ch/webstore/custserv
If you wish to give us your feedback on this publication or need further assistance, please visit the Customer Service
Centre FAQ or contact us:
Email: csc@iec.ch
Tel.: +41 22 919 02 11
Fax: +41 22 919 03 00
IEC 60728-1
Edition 4.0 2007-09
INTERNATIONAL
STANDARD
Cable networks for television signals, sound signals and interactive services –
Part 1: System performance of forward paths
INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
PRICE CODE
XG
ICS 33.060.40 ISBN 2-8318-9264-3
– 2 – 60728-1 © IEC:2007(E)
CONTENTS
FOREWORD.9
INTRODUCTION.11
1 Scope.16
2 Normative references .17
3 Terms, definitions, symbols and abbreviations.19
3.1 Terms and definitions .19
3.2 Symbols .29
3.3 Abbreviations .30
4 Methods of measurement at system outlet.32
4.1 General .32
4.2 Mutual isolation between system outlets.34
4.2.1 Introduction .34
4.2.2 Equipment required .34
4.2.3 Connection of the equipment .34
4.2.4 Measurement procedure .35
4.2.5 Presentation of the results.36
4.3 Amplitude response within a channel.36
4.3.1 Introduction .36
4.3.2 Equipment required .36
4.3.3 Connection of the equipment .36
4.3.4 Measurement procedure .37
4.3.5 Presentation of the results.39
4.4 Chrominance-luminance gain and delay inequalities.39
4.4.1 Introduction .39
4.4.2 Equipment required .40
4.4.3 Connection of the equipment .40
4.4.4 Measurement procedure .40
4.4.5 Presentation of the results.42
4.5 Non-linear distortion .42
4.5.1 General .42
4.5.2 Intermodulation.42
4.5.3 Composite beat .42
4.5.4 Composite crossmodulation.47
4.5.5 Intermodulation noise .47
4.5.6 Hum modulation of carriers.47
4.5.7 Differential gain and phase .52
4.6 Carrier-to-noise ratio .56
4.6.1 Introduction .56
4.6.2 Equipment required .56
4.6.3 Connection of the equipment .56
4.6.4 Measurement set-up.57
4.6.5 Measurement procedure .57
4.6.6 Presentation of the results.58
4.7 Echoes .58
4.7.1 Introduction .58
60728-1 © IEC:2007(E) – 3 –
4.7.2 Equipment required .59
4.7.3 Connection of the equipment .60
4.7.4 Measurement procedure .60
4.7.5 Presentation of the results.60
4.8 AM-VSB television, FM radio and FM television signal level .60
4.8.1 General .60
4.8.2 Definitions for NTSC, PAL and SECAM systems.61
4.8.3 Equipment required .61
4.8.4 Measurement procedure .61
4.8.5 Presentation of the results.62
4.9 Data echo rating and data delay inequality .62
4.10 Interference in FM sound radio channels .62
4.11 Methods of measurement for digitally modulated signals .62
4.11.1 Introduction.62
4.11.2 Basic assumptions and measurement interfaces .62
4.11.3 Signal level for digitally modulated signals .65
4.11.4 RF signal-to-noise ratio S /N for digitally modulated signals.66
D,RF
4.11.5 Bit error ratio (BER) .68
4.11.6 BER versus E /N or C/N.69
b 0
4.11.7 Noise margin.72
4.11.8 Modulation error ratio (MER) .74
4.11.9 Phase jitter.76
4.11.10 Phase noise of an RF carrier.78
5 Performance requirements at system outlet .81
5.1 General .81
5.2 Impedance .82
5.3 Requirements at the terminal input .82
5.3.1 Signal level.82
5.3.2 Other parameters .83
5.4 Carrier levels at system outlets .83
5.4.1 Minimum and maximum carrier levels .83
5.4.2 Carrier level differences .84
5.5 Mutual isolation between system outlets.85
5.5.1 Isolation between two subscribers .85
5.5.2 Isolation between individual outlets in one household .85
5.5.3 Isolation between forward and return path .85
5.6 Frequency response within a television channel at any system outlet .86
5.6.1 Amplitude response.86
5.6.2 Group delay.86
5.7 Long-term frequency stability of distributed carrier signals at any system
outlet.87
5.8 Random noise .88
5.9 Interference to television channels .89
5.9.1 Single-frequency interference .89
5.9.2 Single-channel intermodulation interference .90
5.9.3 Multiple frequency intermodulation interference.90
5.9.4 Intermodulation noise .90
5.9.5 Cross-modulation .91
5.10 Video baseband requirements .91
– 4 – 60728-1 © IEC:2007(E)
5.10.1 Differential gain and phase in any television channel.91
5.10.2 Echoes .91
5.10.3 Amplitude and phase response for PALplus signals.91
5.11 Hum modulation of carriers in television channels .91
5.12 Requirements for data signal transmission .92
5.12.1 Data signals carried in the structure of a television signal.92
5.12.2 Data signals other than those carried within the structure of a
television signal.92
5.13 Digitally modulated signals – Additional performance requirements .93
5.13.1 DVB (PSK, QAM, OFDM) performance .93
5.13.2 NICAM performance .94
5.13.3 DAB performance .94
5.14 FM sound radio – Additional performance requirements .95
5.14.1 Amplitude response within an FM channel .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.