IEC TR 62697-3:2018

Test methods for quantitative determination of corrosive sulfur compounds in unused and used insulating liquids - Part 3: Test method for quantitative determination of elemental sulfur

IEC TR 62697-3:2018(E) specifies a test method for the quantitative determination of elemental sulfur in used and unused insulating liquids over a 2 mg kg–1 to 400 mg kg–1 concentration range.

General Information

• Status: Published
• Publication Date: 13-Feb-2018
• ICS: 01 - GENERALITIES. TERMINOLOGY. STANDARDIZATION. DOCUMENTATION
• ICS: 29.040.10 - Insulating oils
• Technical Committee: TC 10 - Fluids for electrotechnical applications
• Current Stage: PPUB - Publication issued
• Start Date: 12-Mar-2018
• Completion Date: 14-Feb-2018

Standards Content (Sample)

IEC TR 62697-3 ®
Edition 1.0 2018-02
TECHNICAL
REPORT
colour
inside
Test methods for quantitative determination of corrosive sulfur compounds in
unused and used insulating liquids –
Part 3: Test method for quantitative determination of elemental sulfur
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form
or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from
either IEC or IEC's member National Committee in the country of the requester. If you have any questions about IEC
copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or
your local IEC member National Committee for further information.

IEC Central Office Tel.: [phone]
3, rue de Varembé [e-mail]
CH-1211 Geneva 20 www.iec.ch
Switzerland
About the IEC
The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes
International Standards for all electrical, electronic and related technologies.

About IEC publications
The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the
latest edition, a corrigenda or an amendment might have been published.

IEC Catalogue - webstore.iec.ch/catalogue Electropedia - www.electropedia.org
The stand-alone application for consulting the entire The world's leading online dictionary of electronic and
bibliographical information on IEC International Standards, electrical terms containing 21 000 terms and definitions in
Technical Specifications, Technical Reports and other English and French, with equivalent terms in 16 additional
documents. Available for PC, Mac OS, Android Tablets and languages. Also known as the International Electrotechnical
iPad. Vocabulary (IEV) online.

IEC publications search - webstore.iec.ch/advsearchform IEC Glossary - std.iec.ch/glossary
The advanced search enables to find IEC publications by a 67 000 electrotechnical terminology entries in English and
variety of criteria (reference number, text, technical French extracted from the Terms and Definitions clause of
committee,…). It also gives information on projects, replaced IEC publications issued since 2002. Some entries have been
and withdrawn publications. collected from earlier publications of IEC TC 37, 77, 86 and

CISPR.
IEC Just Published - webstore.iec.ch/justpublished

Stay up to date on all new IEC publications. Just Published IEC Customer Service Centre - webstore.iec.ch/csc
details all new publications released. Available online and If you wish to give us your feedback on this publication or
also once a month by email. need further assistance, please contact the Customer Service
Centre: [e-mail].
IEC TR 62697-3 ®
Edition 1.0 2018-02
TECHNICAL
REPORT
colour
inside
Test methods for quantitative determination of corrosive sulfur compounds in

unused and used insulating liquids –

Part 3: Test method for quantitative determination of elemental sulfur

INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
ICS 29.040.10 ISBN 978-2-8322-5361-8

– 2 – IEC TR 62697-3:2018 © IEC 2018
CONTENTS
FOREWORD . 4
INTRODUCTION . 6
1 Scope . 8
2 Normative references . 8
3 Terms and definitions . 8
4 Sampling . 9
5 Procedure . 9
5.1 Principle . 9
5.1.1 Determination with gas chromatography . 9
5.1.2 Determination with differential pulse voltammetry . 9
5.2 Significance and use . 9
5.3 Interferences. 10
5.3.1 Co-eluting compounds . 10
5.3.2 Electron capture detector (ECD) . 10
5.3.3 Flame photometric detector (FPD) . 10
5.3.4 Mass spectrometer (MS) . 10
5.3.5 Interference from the matrix . 10
5.4 Apparatus . 10
5.4.1 Balance . 10
5.4.2 Gas chromatography system . 11
5.4.3 Differential pulsed voltammetry . 11
5.5 Reagents and materials . 11
5.5.1 Purity of reagents . 11
5.5.2 Gases . 11
5.5.3 Solvents . 12
5.6 Standard materials . 12
5.6.1 Elemental sulfur . 12
5.6.2 Diphenyl disulfide (DPDS) . 12
5.6.3 Blank oil . 12
5.7 Standard solutions . 12
5.7.1 Stock solutions . 12
5.7.2 Internal standard (IS) solution . 13
6 Instrument set-up . 13
6.1 Gas chromatograph . 13
6.1.1 General . 13
6.1.2 Carrier gas . 13
6.1.3 Injector . 13
6.1.4 Separation parameters . 13
6.1.5 ECD detection . 14
6.1.6 FPD detection . 14
6.1.7 MS detection . 14
6.2 Calibration . 14
6.2.1 General . 14
6.2.2 Calibration procedure . 14
6.2.3 Response factor determination (ECD and FPD) . 15
6.2.4 Response factor determination (MS) . 15

6.3 Analysis . 15
6.3.1 Sample pre-treatment . 15
6.3.2 Sample injection . 16
6.3.3 Chromatographic run . 16
6.3.4 Peak integration . 16
6.4 Calculations . 16
6.4.1 ECD and FPD . 16
6.4.2 Mass spectrometer (MS) . 16
6.4.3 Differential pulse voltammetry measurements . 17
6.5 Results . 17
7 Precision data . 18
7.1 Detection limit . 18
7.2 Repeatability . 18
7.3 Reproducibility . 18
8 Report . 18
Annex A (informative) Figures with typical chromatograms and results . 19
Annex B (informative) RRT results Statistical evaluation of elemental sulfur data GC-
ECD/FPD . 21
Bibliography . 23

Figure 1 – Typical peak form and concentration calculation . 17
–1
Figure A.1 – GC-ECD chromatogram of 5 mg kg elemental sulfur and (IS) in white
mineral oil . 19
–1
Figure A.2 – GC-ECD chromatogram of 100 mg kg elemental sulfur and (IS) in white
mineral oil . 20

Table 1 – Column oven temperature programming parameters . 14
Table 2 – Mass spectrometer parameters . 14
Table 3 – Repeatability limit . 18
Table 4 – Reproducibility limit . 18
Table B.1 – Reproducibility with same chemical analysis approach . 21
Table B.2 – Reproducibility with different chemical analysis approach . 21
Table B.3 – Repeatability . 22

– 4 – IEC TR 62697-3:2018 © IEC 2018
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
TEST METHODS FOR QUANTITATIVE DETERMINATION
OF CORROSIVE SULFUR COMPOUNDS IN UNUSED
AND USED INSULATING LIQUIDS –
Part 3: Test method for quantitative determination
of elemental sulfur
FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC
Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested
in the subject dealt with may participate in this preparatory work. International, governmental and non-
governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely
with the International Organization for Standardization (ISO) in accordance with conditions determined by
agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for internati
...