ISO 19642-7:2019

Road vehicles — Automotive cables — Part 7: Dimensions and requirements for 30 V a.c. or 60 V d.c. round, sheathed, screened or unscreened multi or single core copper conductor cables

This document specifies the dimensions and requirements for multi or single core cables intended for use in road vehicle applications where the nominal system voltage is 30 V a.c. or 60 V d.c.. It also applies to individual cores in multi core and single core cables.

Véhicules routiers — Cables automobiles — Partie 7: Dimensions et exigences des câbles en cuivre ronds, gainés, blindés, mono ou multi conducteurs de 30 V a.c ou 60 V c.c.

General Information

• Status: Published
• Publication Date: 29-Jan-2019
• ICS: 43.040.10 - Electrical and electronic equipment
• Technical Committee: ISO/TC 22/SC 32 - Electrical and electronic components and general system aspects
• Drafting Committee: ISO/TC 22/SC 32/WG 4 - Automotive electrical cables
• Current Stage: 9060 - Close of review
• Start Date: 02-Sep-2029

Relations

• Consolidated By: ISO 12215-10:2020 - Small craft — Hull construction and scantlings — Part 10: Rig loads and rig attachment in sailing craft
• Effective Date: 06-Jun-2022

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 19642-7
First edition
2019-01
Road vehicles — Automotive cables —
Part 7:
Dimensions and requirements for 30
V a.c. or 60 V d.c. round, sheathed,
screened or unscreened multi or
single core copper conductor cables
Véhicules routiers — Cables automobiles —
Partie 7: Dimensions et exigences des câbles en cuivre ronds, gainés,
blindés, mono ou multi conducteurs de 30 V a.c ou 60 V c.c.
Reference number
ISO 19642-7:2019(E)
©
ISO 2019

---------------------- Page: 1 ----------------------
ISO 19642-7:2019(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2019
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: [phone]
Fax: [phone]
Email: [e-mail]
Website: www.iso.org
Published in Switzerland
ii © ISO 2019 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 19642-7:2019(E)

Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Specifications . 1
4.1 General test conditions . 1
4.2 Safety concerns . 2
4.3 Voltage rating . 2
4.4 Temperature classes . 2
4.5 Conductor material . 2
4.6 Conductors . 2
4.7 Sheath thickness . 2
4.8 Core cable outside diameter . 2
4.9 Representative conductor sizes for testing . 2
4.10 Reference and requirements for the tests according to ISO 19642-2 . 2
5 Requirements for single-core cables . 4
6 Requirements for round, sheathed, screened or unscreened multi or single core cables .5
6.1 General .
...