ISO 2007:2018

Rubber, unvulcanized — Determination of plasticity — Rapid-plastimeter method

This document specifies a method for the rapid determination of the plasticity of raw rubber and unvulcanized compounded rubber. It is applicable to the determination of the plasticity retention index (PRI) as specified in ISO 2930.

Caoutchouc non vulcanisé — Détermination de la plasticité — Méthode au plastomètre rapide

General Information

• Status: Published
• Publication Date: 17-Jul-2018
• ICS: 83.060 - Rubber
• Technical Committee: ISO/TC 45/SC 2 - Testing and analysis
• Drafting Committee: ISO/TC 45/SC 2/WG 2 - Visco-elastic properties
• Current Stage: 9092 - International Standard to be revised
• Completion Date: 04-Jan-2024

Relations

• Revises: ISO 2007:2007 - Rubber, unvulcanized — Determination of plasticity — Rapid-plastimeter method
• Effective Date: 05-Dec-2015

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 2007
Fifth edition
2018-07
Rubber, unvulcanized —
Determination of plasticity — Rapid-
plastimeter method
Caoutchouc non vulcanisé — Détermination de la plasticité —
Méthode au plastomètre rapide
Reference number
ISO 2007:2018(E)
©
ISO 2018

---------------------- Page: 1 ----------------------
ISO 2007:2018(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2018
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: [phone]
Fax: [phone]
Email: [e-mail]
Website: www.iso.org
Published in Switzerland
ii © ISO 2018 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 2007:2018(E)

Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principle . 1
5 Apparatus . 2
6 Test piece . 5
7 Calibration . 5
8 Temperature of test . 5
9 Procedure. 5
10 Expression of results . 6
11 Test report . 6
Bibliography . 7
© ISO 2018 – All rights reserved iii

---------------------- Page: 3 ----------------------
ISO 2007:2018(E)

Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particul
...